Stewa rt Connector Insilco Technologies Group TILMIILLTIT ss S 5 h. ) 15-1856 REV. REVISION CHANGES Stewart Connector Systems, Inc./q; ADDED NEW FORMAT 11118 Susquehanna Trail South [| L #635 [16.13] MAX] PART NO. SS-7188S-A-NF-102 (30uIN GOLD) PART NO. SS7188SANF-102-50 (50ulN GOLD) CAT 5 JACK EIGHT CONTACT, EIGHT POSITION, SHIELDED JACK NF NON-FLANGE "1" ALTERNATE SOLDER TAIL "-02" PANEL GROUNDING TAB @ 22 FOR REFERENCE ONLY 02 PANEL GROUNDING o\ 850 [21.59] MAX Ee ! 8 3 /\s Oo); 4 : 5 | St JU TL, 040 [1.02] L. PIN POSITION LAYOUT |S IDENTICAL TO STANDARD JACKS NOTES: MEETS CATEGORY 5 PERFORMANCE SPECIFICATION AS TESTED PER EIA/TIA 568A. 050 [1.27] TYP A F a TOL NON-ACCUM a 3 025 [0.64] = a 100 [2.54] TP = 1p" LU LU < TOL NON-ACCUM Ss, {oe 9.035 [0.89] ( = "y alglg _1 8 4p _-+ 1 3 5 7 el 9128 [3. 128 [3.25] 7125 [3.18] wil 9.062 [1.57] +450 [11.43] *610 [15.49] TOLERANCES COMPLY WITH F.C.C. DIMENSION REQUIREMENTS DIMENSIONS SHOWN WITH * TO BE CENTRAL ABOUT CENTER LINE DIMENSIONS SHOWN ARE SUBJECT TO CHANGE WITHOUT NOTICE. AVAILABLE WITH: - LOADED 1 8 CONTACTS CT/10026 o| 120 son J a P.C.B. RECOMMENDED HOLE LAYOUT SEEN FROM COMPONENT SIDE TOLERANCE +.003 [0.08] UNLESS OTHERWISE SPECIFIED THIRD ANGLE PROJECTION| THIS DRAWING AND THE SUBJECT MATIER SHOWN THEREON ARE CONFIDENTIAL AND THE PROPRIETARY PROPERTY OF STEWART CONNECTOR SYSTEMS ("SCS") AND SHALL NOT BE REPRODUCED, COPIED OR USED IN ANY MANNER WITHOUT PRIOR WRITTEN CONSENT OF "SCS". THE SUBUECT MATTER SHT. 1 OF 1 MAY BE PATENTED OR A PATENT MAY BE PENDING. SCS