REV. 6/3/05 #161 [4.09] | #248 [6.30] i LJ ay _ e+ @ a ee ee ppt $ .050 [1.27] TYP TOL NON-ACCUM 025 [0.64] > wm 100 [2.54] TYP = TOL NON-ACCUM $ 9.035 [0.89] (10) Yee bet 250 [6.35] > dh | a 128 [3.25] AT T soe Paint (2) 125 [3.18] #450 [11.43] P.C.B. RECOMMENDED HOLE LAYOUT SEEN FROM COMPONENT SIDE TOLERANCE +.003 [0.08] UNLESS OTHERWISE SPECIFIED i 2 i DATE REV ECN APP'D. BY 11-4-05 HO 7369 TRM 1-13-06 Ht 7437 uM ++*,605 [15.37] MAX 2 = | STEWART J og zig = PATENTED , 238 TGs} eI | HT | | Op NOTES: 1. CONNECTOR MATERIALS: HOUSING: THERMOPLASTIC UL94 V-0 CONTACTS/SHIELD: COPPER ALLOY SHIELD PLATING: NICKEL CONTACT PLATING: SELECTIVE GOLD IN CONTACT AREA SEE CHART FOR PART NUMBER 2. PRODUCT DESIGNED FOR CATEGORY 5 APPLICATIONS. 3, TOLERANCES COMPLY WITH F.C.C. DIMENSION REQUIREMENTS. 4, THE SUGGESTED PANEL OPENING IS INTENDED TO GIVE USER THE ABILITY TO HAVE REASONABLE JACK /PANEL CLEARANCES, YET MAINTAIN GROUNDING CAPABILITY. THESE VARIABLES CAN BE ADJUSTED IN EITHER DIRECTION BUT MAY CARRY SOME CONSEQUENCES IN THE FORM OF LOWER MATING FORCES OR TIGHTER ASSEMBLY TOLERANCES. 5. FOR PRODUCT SPECIFICATIONS SEE PRO22-01 50 MICRO-INCHES [1.27um] SS-641010-NF-A115 30 MICRO-INCHES [0.76um] - CONTACT PLATING IN MATING AREA PART NUMBER THIRD ANGLE PROJECTION 4 Bel Stewart Connector 11118 Susquehanna Trail South Glen Rock, PA 17327-9199 (717) 235-7512 Fax: (717) 235-7954 http: //www.stewartconnector.com DO NOT SCALE DRAWING DRAWING IS SUBJECT TO CHANGE WITHOUT NOTICE * TEN CONTACT, TEN POSITION, SHORT VERSION JACK DIMENSIONS: INCHES [METRIC] | THIS DRAWING AND THE SUBNECT MATTER SHOWN THEREON [RN BY: cy PAE 5-13-94 UNLESS OTHERWISE SPECIFIED ARE CONFIDENTIAL AND THE PROPRIETARY PROPERTY OF TOLERANCES ARE +.005 [0.13] | BEL STEWART CONNECTOR AND SHALL NOT BE REPRODUCED, | APPD BY: JW DATE 9-23-94 ANGLES ARE + 1 COPIED, OR USED IN ANY MANNER WITHOUT PRIOR WRITTEN SHEET NO. CONSENT OF BEL STEWART CONNECTOR. THE SUBJECT [DWG NO. REV. 1 OF 1 MATTER MAY BE PATENTED OR A PATENT MAY BE PENDING. C1640260 H1 1 AutoCAD