Type: Dupline®
Remote IR Transmitter Housing
IR Accessories
8 Channels
8 output
Handheld IR Transmitter
Du line
®
Fieldbus Installationbus
Specifications are subject to change without notice (01.10.02) 1
Dupline®is a registered trademark. A product of the CARLO GAVAZZI Group
Supply Ordering no.
Batteries G 4085 5561
Ordering KeyProduct Description
The Dupline®IR Remote Con-
troller is designed and coded
for Dupline®IR receiver G
4185 5531. The controller has
as standard 8 channels, but
can via more Dupline®IR
receivers control up to 64
Dupline®channels through
the rotating selector on top of
the controller (See datasheet
G4185 5531 for more details).
• Handheld infrared remote controller
• 8 channel transmitter (possible to increase the number
of channels to 64)
• Designed and coded for G4185 5531 IR receiver
• Operating distance: 12 m
• Supplied via 4 x 1.5 V micro batteries (AAA)
Type Selection
Supply Specifications
Batteries 4 x 1.5 V micro (LR03) (AA)
IR Remote Controller
Type G 4085 5561
G 4085 5561
General Specifications
Principle of transition Infrared light 950 nm
Wave frequency 38 kHz
Coding PPM-kode
(Pulse Position Modulation)
Length of telegram 12 bit
No. of channels 8 (64 via more IR-receivers
G4185 5531)
Operating distance 12 m
Mode of Operation
The IR remote control system is
a system component for the
Dupline®installation bus. It con-
sists of two modules: an 8-chan-
nel IR-receiver (Dupline®trans-
mitter) and an 8-channel hand-
held IR transmitter.
The IR-receiver is supplied by
Dupline®, which eliminates the
need for further connections,
and is intended for building into
flush-type switch boxes. The IR-
receiver can transmit on eight
Dupline®channels, and the
address coding is performed by
means of the programming unit
GAP 1605 through the rear-
mounted modular plug connec-
tion. The handheld IR-transmit-
ter has eight keys for activation
of the eight channels. By means
of a rotary switch, it is possible
to preset channel groups A to H
of the corresponding receiver,
which means that a handheld
transmitter can activate up to 64
channels. The handheld trans-
mitter features a text writing
facility at the back.
22.5
40
155
Dimensions
Start-up
Address coding of the IR-receiv-
er (Dupline®transmitter) can take
place before or after start-up. In
either case, the bus cable must
be connected at the screw ter-
minal on the back of the receiver
(1=Signal, 2=Ground). The IR-
receiver should be mounted in
the specified direction in the
switch box, in order to achieve
optimum receiving characteristics.
The handheld IR-transmitter
must be equipped with four bat-
teries type Micro cell size AAA.
The transmission with IR sys-
tems only works when quasi-
visual contact exists between
transmitter and receiver within
the transmission range. Often
reflection reception is also possi-
ble. Transmission cannot take
place through walls or windows.
Therefore a suitable place for
mounting must be selected.
