.75" M3x.5 Nylon Standoff
(Two locations) Acrylic Screws
(14 locations)
1.25" M3x.5 Nylon Standoff
(Five locations)
0.5" M3x.5 Nylon Standoff
(Five locations)
1" M3x.5 Nylon
Standoff
(Two locations)
M3x.5 nut (x4) M3x16 panhead
metal screw (x4)
Lock washer (x2)
Fan Bracket (x2)
Top PlexiGlas Plate (9 screw holes)
Bottom PlexiGlas Plate (7 screw holes)
Fan
Step 1: Fan
Assembly Detail
Step 1:
Attach fan to top Plexiglas plate using fan brackets (x2), M3x16 panhead
screws (x4), M3x.5 nuts (x4), and lock washers (x2) as shown.
Step 3:
Plug FMCOMMS1 board into ML605 board. Attach Fan cable to J33
on ML605 board (near center of board, by FPGA/Fan).
Step 2:
Attach stand-offs to top Plexiglas plate using acrylic screws.
Step 4:
Place top Plexiglas cover upside down on clean surface, and attach
FCOMMS/ML605 board to top plate.
Step 5:
Attach bottom Plexiglas plate.
Assembly Instructions (Small Philips Screwdriver needed)
Step 6:
Attach antennas, and attach rubber feet to bottom Plexiglas plate
near corners
FCOMMS1 Board
ML605 Board
