VECTRON INTERNATIONAL TCXO C2310A1-0102 Nominal frequency (f0) 100 MHz Frequency stabilities Parameter Frequency stability Operating temp. range -4.6 to 4.6 ppm -0.8 to 0.8 ppm 0 ... 70 C Value Condition -0.8 to 0.8 ppm -0.2 to 0.2 ppm < 2.8 ppm @25 C static; 3.3 V 5 % @ 40 C Parameter Value Condition Signal Load Rise Time Fall Time Duty cycle V Low V High LVCMOS 15 pF 10 % < 5 ns < 5 ns 40 / 60 % x < 0.33 V x > 2.97 V @ 20 to 80 %Vout @ 80 to 20 %Vout @ 1.65 V Value Condition 3.3 V 5 % < 40 mA @ Vsnom & 25 C Over all (df/f0) vs. operating temp. range (df/f@25 C) Parameter initial tolerance (df/f0) vs. supply voltage change (df/f) vs. aging / 20 years (df/f) RF output Supply voltage Parameter Supply voltage (Vs) Current consumption steady state Additional Parameters Parameter Value Phase Noise Condition < -75 dBc/Hz < -100 dBc/Hz < -130 dBc/Hz < -150 dBc/Hz handling&processing note Processing & Packing 10 Hz 100 Hz 1000 Hz 10 kHz typ values Additional environmental conditions Tensile strength of leads DIN IEC 68 T2-21 (Ua 1) Flexibility of leads DIN IEC 68 T2-21 (Ub) Sealing test A nicht dicht (not hermetically sealed) Solderability DIN IEC 68 T2-20 (Ta) Solvent resistance EN 60068-2-45, Test xA non-washable device Absolute Maximum Ratings Parameter Min Operable temperature range Storage temperature range -40 -55 Vectron International * Product Specifications Vectron International GmbH & Co. KG Landstrasse D-74924 Neckarbischofsheim Germany 49-07268-801-0 tel 49-07268-801-281 fax www.vectron.com Typ Max Units 85 105 C C modified 2006-07-17 Index : 11 Condition printed 2008-08-20 * page 1 of 4 VECTRON INTERNATIONAL TCXO C2310A1-0102 Enclosure Type G214B Height 5.9 mm all units in mm Pin Connections Pin 1: N.C. Pin 2: N.C. Pin 3: GND(Case) Pin 4: RF-Output Pin 5: N.C. Pin 6: Vs (supply voltage) Marking C2310A1-102 100,000 MHz * VI AYYWW * pin-1 marking Vectron International * Product Specifications Vectron International GmbH & Co. KG Landstrasse D-74924 Neckarbischofsheim Germany 49-07268-801-0 tel 49-07268-801-281 fax www.vectron.com modified 2006-07-17 Index : 11 printed 2008-08-20 * page 2 of 4 VECTRON INTERNATIONAL TCXO C2310A1-0102 Reflow profile Profile Feature Pb-Free Assembly/Sn-Pb Assembly Average ramp-up rate (TL to Tp) 3C/second max. Preheat -Temperature Min (Tsmin) 150c -Temperature Min (Tsmax) 200c -Time (min to max) (ts) 60-180 seconds Tsmax to TL - Ramp-up Rate 3C/second max. Time maintainted above - Temperature (TL) 217C - Time (tL) 60-150 seconds Peak Temperature (Tp) max 260C Time within 5C of actual Peak Temperature (tp) 20-40 seconds Ramp-down Rate 6C/second max. Time 25C to Peak Temperature 8 minutes max. Note: All temperatures refer to topside of the package, measured on the package body surface. Additional Information This SMD oscillator has been designed for pick and place reflow soldering. SMD oscillators must be on the top side of the PCB during the reflow process. Vectron International * Product Specifications Vectron International GmbH & Co. KG Landstrasse D-74924 Neckarbischofsheim Germany 49-07268-801-0 tel 49-07268-801-281 fax www.vectron.com modified 2006-07-17 Index : 11 printed 2008-08-20 * page 3 of 4 VECTRON TCXO C2310A1-0102 INTERNATIONAL Standard shipping method Tape width W [mm] Quantity per meter Quantity per reel P [mm] A [mm] B [mm] K [mm] 24 83.3 850 12 9.8 15 6.4 Notes: Unless otherwise stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency control voltage, load, temperature (25C). Subject to technical modification. Vectron International * Product Specifications Vectron International GmbH & Co. KG Landstrasse D-74924 Neckarbischofsheim Germany 49-07268-801-0 tel 49-07268-801-281 fax www.vectron.com modified 2006-07-17 Index : 11 printed 2008-08-20 * page 4 of 4 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Vectron: C2310A1-0102