For further information contact your local STMicroelectronics sales office.
June 2012 Doc ID 023390 Rev 1 1/4
4
STEVAL-ILL045V1
9 W, A19 format Triac dimmable, high power factor, non-isolated
LED driver based on the HVLED815PF (for US market)
Data brief
Features
9 W output, for light equal to a range from 40 W
to 60 W incandescent
+/-5% primary-side current regulation, no
optocoupler
Low component count - 25 parts, including the
EMI filter
Only 1 tight-tolerance component
High efficiency, > 86%
High power factor > 0.98 and low THD, < 20%
over 90 V to 132 V range
Fits in 28 mm tubing, 52 mm overall length
Dimmable with common Triac dimmer
RoHS compliant
Description
The STEVAL-ILL045V1 demonstration board
showcases ST’s new LED driver chip,
HVLED815PF. It solves the problem of low-cost
drive circuitry for LED replacements for 40 W
incandescent or equivalent compact-fluorescent
lamps.
The HVLED815PF is a new integrated power
controller using primary-side control to achieve
LED current regulation within +/-5%. (It also has
primary-side voltage regulation, used here for
open load protection.)
The device incorporates an 800 V avalanche-
rated FET and fits a standard SO-16 package. An
internal startup circuit eliminates the need for
external rapid-start circuitry.
The PFC-flyback power converter operates in
transition mode for the highest efficiency and best
use of components.
With the addition of a few extra components the
HVLED815PF is made to draw near-sinusoidal
input current from the AC line.
The circuit regulates LED current over a wide
range of line voltage and LED string voltage, and
it is dimmable with standard Triac-based dimmers.
www.st.com
Schematic diagram STEVAL-ILL045V1
2/4 Doc ID 023390 Rev 1
1 Schematic diagram
Figure 1. Schematic diagram
!-V
32#
),%$
$-'
#/-0
.!
$RAIN

$RAIN

#3
6CC
'.$
$RAIN

$RAIN

.!
.#

.!

.!

5
(6,%$0&
2
+
2
+
2
2
,%$
,%$7(4
,%$
,%$7(4
!AVERAGE
!PPX6
!# 6
!# 6
"2
"2)$'%3-4
#
N&
3EENOTE
2
/HM&USIBLE
7
7
7
7
4
$
--3$

4
#RAMER#3-64
6REFL
6REFL6
,PRIM(Y
#
U&6
$
344(!
#
U&6
0RICOM
0RI6
$RAIN
6CC
AUX
3OURCE
#
N&
2
+
2
+
$
"!4:&),-
#
U&6
2
7
#
U&6
#
U&6
2
+
$-'
COMP
),%$
ACINJ
/UTPOS
,
M(Y
#
U&6
)RMS6!
)RMS6!
)PK02)!
.
.
2
+
#
P&
.OTE
4HISCIRCUITCANBEUSEDWITHOTHER,%$QUANTITIES
&OR,%$SATM!
4#RAMER#3-64OUTPUTTAPATOFPRIMARY
#P&6#/'
$3403(!
#U&6
2+
%XAMPLE
STEVAL-ILL045V1 Revision history
Doc ID 023390 Rev 1 3/4
2 Revision history
Table 1. Document revision history
Date Revision Changes
29-Jun-2012 1Initial release.
STEVAL-ILL045V1
4/4 Doc ID 023390 Rev 1
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY TWO AUTHORIZED ST REPRESENTATIVES, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2012 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com