www.cherryswitches.com
Page 1 of 2, last update 2015-03-16, Specifications subject to change without notice.
Angle Position Sensors
AN8 Sensors
Programmable, non-contact magnetic position
sensors capable of continuous rotation
Description
The AN8 Series sensors are non-contact, intrinsically linear angle position sensors. The sensors operate through the use of Hall
Effect technology with magnetic fields generated by permanent magnets. They provide a linear change in voltage output
(ratiometric to the input voltage) corresponding to an angular rotation of the input shaft.
• Angular position sensor with high tolerance for misalignment
• Non-contact angular position sensing and full 360° rotation
• Custom programming available for: angle range, slope, PWM
output, custom magnets – contact factory
• No mechanical interface means no parts to wear out or jam
• Available with Delphi connector or 12” (305 mm) wire leads
• RoHS compliant
• IP67
• Maximum air gap of 5.5 mm (0.22”)*
• Implement (fork lift, agricultural trailer hitch,
etc.) position sensing
• Steer, throttle by wire
• Gear selection
• Zero-contact encoder alternative
• Replacement for smart bearings
• Outboard trim sensing
Environmental Specifications
6g sinusoidal, 8 g RMS axial; 40Hz
F) with Delphi connectors,
Electrical Specifications
10% to 90% of input (see graph for voltage vs. rotation angle
Absolute Max. Output Current
Mechanical Specifications
Terminal 1214075 / 2047680
*with AS500106 magnet carrier
2 mm radial (magnet to center)