4. SPECIFICATIONS FOR EACH SERIES Conductive polymer type SVPB Series Low profile Marking : Polarity( ), Rated voltage, (Purple) PB Rated capacitance, Lot.No. Specifications Items Category temperature range Tolerance on rated capacitance Tangent of loss angle Leakage current 1 ESR Characteristics of impedance ratio at high temp. and low temp. Conditions 120Hz 120Hz After 2 minutes Based the value at 100KHz+20C Endurance 105C, 1,000h, Rated voltage applied Damp heat (Steady state) 60C, 90 to 95% RH, 1,000h, No-applied voltage Resistance to soldering heat (VPS) (230C X 75s) 2 Characteristics -55C to +105C M :20% Less than or equal to the value of Table4 Less than or equal to the value of Table4 Less than or equal to the value of Table4 Z / Z 20C 0.75 to 1.25 -55C 0.75 to 1.25 Z / Z 20C +105C Within 20% (30% for C5 size) C/C 1.5 times or less than an initial standard tan 1.5 times or less than an initial standard ESR Leakage current Below an initial standard Within 20% C/C 1.5 times or less than an initial standard tan 1.5 times or less than an initial standard ESR Leakage current Below an initial standard (after voltage processing) Within 10% (20% for C5 size) C/C 1.3 times or less than an initial standard tan 1.3 times or less than an initial standard ESR Leakage current Below an initial standard (after voltage processing) 1 In case of some problems for measured values, measure after applying rated voltage for 120 minutes at 105C . 2 Refer to Page 56 for reflow soldering conditions. Dimensions 0.2max. (unit : mm) W L R Size List RV SV F 15 22 33 56 82 100 120 2.5 3.3 C5 C55 P C H Size Code D0.5 D Specificationsfor eachseries This is a low profile series based on the SVPA series. Suitable for miniaturizing devices and circuits. This product can support lead free-reflow (2). 6.3 6.3 W0.2 H0.2 C0.2 6.6 6.6 6.6 6.6 7.3 7.3 4.9 5.4 RV : Rated voltage 4.0 6.3 5.2 8.2 (SV) : Surge (room temperature) 10.0 16.0 20.0 11.5 18.4 23.0 C5 C55 C5 C5 C5 C5 C5 For the minimum packing quantity, please refer to page 55. 24 +0.1 L -0.4 R P0.2 0.6 to 0.8 0.6 to 0.8 2.1 2.1 4. SPECIFICATIONS FOR EACH SERIES Table4 SVPB Series Characteristics List Size Code Rated Voltage (V) Part Number 1 Rated Rated ESR Capacitance 100kHz to 300kHz ripple current 100kHz (mArms) (F) (m) (max.) at 105C Tangent of loss angle (max.) Leakage current (A) (max.)2 20 15 45 2000 0.12 120 16SVPB33M 16 33 40 1670 0.12 211 10SVPB56M 10 56 40 1670 0.12 224 82 40 1670 0.12 207 Specificationsfor eachseries 20SVPB15M C5 C55 1 2 6SVPB82M 6.3 4SVPB100M 4 100 40 1670 0.12 160 2R5SVPB120M 2.5 120 40 1670 0.12 120 22 35 2000 0.12 88 20SVPB22M 20 Capacitance tolerance : M 20% After 2 minutes The C5 size is also available upon request as a radial lead type. Please contact us if this type is required. Maximum height for radial lead types is 4.5 mm. The C55 size is also available upon request as 4V and 6.3V products. Recommended land pattern dimension of PWB c (unit : mm) a Size Code C5 C55 a 2.1 2.1 b 9.1 9.1 c 1.6 1.6 b Frequency coefficient for ripple current Frequency Coefficient 120Hz f 1kHz 0.05 1kHz f 10kHz 0.3 10kHz f 100kHz 0.7 100kHz f 500kHz 1 25