Data Sheet June 2001 Wideband Photodiode Receivers Features Wide-band analog signal reception Single-mode fiber pigtail High optical return loss Up to 20 GHz bandwidth 1310 nm and 1550 nm sensitivity Applications Antenna remoting Cellular and PCS networks Military triband communications TT and C Description The family of wideband photodiode receivers are ideally suited for use in analog fiber-optic communications. With their wide bandwidth and flat response, these devices are used in a wide array of applications, including antenna remoting, timing and reference signal distribution, measurement, delay lines, and two-way communications. Several packaging styles are available for these wideband photodiodes. The most basic package, the photodiode module, contains the photodiode chip, optical fiber pigtail, and impedance-matched electrical connections in a hermetically sealed unit. Of particular note is the high optical return loss, which enables high-quality noise performance for sensitive optical links. Data Sheet June 2001 Wideband Photodiode Receivers Description (continued) for integration with Agere Systems Inc.'s System 10000 rack-mountable chassis and power supplies. Electronics within flange-mount and plug-in receivers provide a reverse bias for the photodiodes and monitor the dc level of the optical input power, thus providing a fully integrated wideband product. In most cases, the basic photodiode module is integrated into a complete receiver, packaged either as a flange-mount for extreme environments, or as a plug-in Absolute Maximum Ratings Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operational sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect device reliability. Parameter Symbol Operating Temperature Range: Modules and Flange-mount Plug-ins Storage Temperature Range: Modules and Flange-mount Plug-ins Input Power: 2510A/B, 2515A.B, 1516A/B/C 2518A/B Maximum Power for 60 s: 2510A/B, 2515A.B, 1516A/B/C 2518A/B dc Current: 2510A/B, 2515A/B, 1516A/B/C 2518A/B Min Max Unit -40 0 70 50 C C -40 -20 85 65 C C 2.0 (typ) 15 2.5 16 mW mW -- -- 4 16 mW mW -- -- 2 12 mA mA TOP Tstg PIN PMAX Idc Characteristics Table 1. Optical Characteristics Package Type Module Flange-Mount Receiver Plug-in Receiver, for 19 in. rack system Device Code 2510A/B1 4510A/B1 10450A/B1 Parameters 2515A/B1 4515A/B1 10455A/B1 2516A/B/C1 4516A/B/C1 10456A/B/C1 2518A/B 4518A/B 10458A/B Specifications dc Photodiode Responsivity at 1310 nm, 25 C >0.75 A/W >0.75 A/W >0.65 A/W >0.70 A/W RF Receiver Efficiency (typ) at 1 GHz 2 >0.38 >0.38 >0.33 >0.35 Optical Return Loss3 Pigtail Fiber Type (where applicable) >45 dB >1 m, 9 m/125 m single-mode SMF-28 4 or equivalent 1. Specified for <2 mW optical power, <50% modulation depth. 2. The photodiode RF current splits evenly between the internal matching resistor and the external load. (See Agere Systems' System Designer's Guide to RF and Wideband Fiber Optics.) 3. Optical return loss specified for FC-APC connectors or fusion splices only. Other connection methods can degrade optical return loss. 4. SMF-28 is a trademark of Corning Incorporated. 2 Agere Systems Inc. Data Sheet June 2001 Wideband Photodiode Receivers Characteristics (continued) Table 2. RF Characteristics Package Type Module Flange-Mount Receiver Plug-in Receiver (for 19 in. rack system) Device Code 2510A/B 4510A/B 10450A/B 2515A/B 4515A/B 10455A/B Parameters 2516A/B/C 4516A/B/C 10456A/B/C 2518A/B 4518A/B 10458A/B Specifications Maximum Frequency: A Version B Version C Version 3 GHz 6 GHz -- 10 GHz 12 GHz -- 20 GHz 18 GHz 15 GHZ 15 GHz 10 GHz -- Minimum Frequency 0.1 GHz 0.1 GHz 1 GHz 0.5 GHz Output Coupling dc ac ac ac Amplitude Flatness1 2.0 dB 2.0 dB 2.0 dB 2.0 dB Output VSWR, Max 2.0:1 2.5:1 0.1--6 GHz -- 0.1 GHz--10 GHz 10 GHz--12 GHz 1 GHz --18 GHz 18 GHz-- 20 GHz 0.5 GHz--15 GHz -- 50 Output Impedance RF Connector for Module SMA (F) SMA (F) RF Connector for FlangeMount and Plug-in K-connector 2 SMA (F) K-connector 2 1. Relative to value at 1 GHz. 2. K-connector is a trademark of Anritsu Company. It is a high-speed and SMA-compatible connector. Table 3. dc Power for Flange-mount and Plug-ins (45xx and 104xx Receivers) Parameter dc Power for Flange-mount and Plug-ins (Models 45xx and 104xx)1: Pin 1 Symbol Min Typ Max Unit Pdc -- 15 nominal at 0.2 A max -- V 1. For photodiode module CDC requirements, contact an Agere Systems' account manager for OEM data sheet. Agere Systems Inc. 3 Data Sheet June 2001 Wideband Photodiode Receivers 2510A/B, 2515A/B Wideband Photodiode Receivers Outline Diagram Dimensions are in inches and (millimeters). 0.49 (12) 0.66 (17) FIBER PIGTAIL RF OUTPUT 1.33 (34) A C E H 0.42 (11) B D 0.23 (6) F 7-PIN MINIATURE RECTANGULAR 1-1192 (F) Pin Information H F E D C B A Table 4. Seven-pin Connector Pin No. Description A B C D E F H NC NC NC NC Bias Ground NC PIN PHOTODIODE RF OUT 50 1-1194 (F) Figure 1. 2510A/B Electrical Schematic H F E D C B A 130 pF 25 PIN PHOTODIODE RF OUT 50 1-1194 (F) Figure 2. 2515A/B Electrical Schematic 4 Agere Systems Inc. Data Sheet June 2001 Wideband Photodiode Receivers 2516A/B, 2518A/B Wideband Photodiode Receivers Outline Diagram Dimensions are in inches and (millimeters). 0.26 (6.7) 1.24 (32) 1.04 (26) 0.10 (2.5) 0.39 (10) 0.84 (21) 0.20 (5) 0.58 (15) 0.78 (20) O.094 (2.4) 0.15 (4) 0.10 (2.5) 0.20 (5) K-CONNECTOR 0.41 (10) PIN 1 0.04 (1) 0.174 (4.4) 1-1193 (F) Pin Information VBIAS Table 5. Six-pin Connector Pin No. Description 1 2 3 4 5 6 NC NC NC Bias NC Ground 150 RF OUT 50 1-1195 (F) Figure 3. 2516A/B, 2518A/B Electrical Schematic Agere Systems Inc. 5 Data Sheet June 2001 Wideband Photodiode Receivers 45XX, 104xx Wideband Photodiode Receivers 45xx Outline Diagram (Dimensions are in inches and (millimeters).) RF OUT SMA (F) dc CONNECTOR 9-PIN D-SUB (M) O.12 (3) 5.00 (127) 4.25 (108) 2.13 (54) 0.38 (10) 0.20 (5) 5.60 (142) 6.00 (152) POWER ON OPTICAL IN 1.50 (38) 1-1191 (F) 0.12 (3) 104xx Outline Diagram (Dimensions are in inches and (millimeters).) 1.39 (35) 9.12 (232) FIBER-OPTIC RECEIVER OPTICAL IN POWER ON OPTICAL POWER 5.06 (129) RF OUT FRONT PANEL dc CONNECTOR 9-PIN D-SUB (M) 1-1189 (F)c Pin Information Front Panel LEDs Table 6. Nine-Pin D-sub Connector Power on Optical power received (plug-ins only) Pin No. Description 1 15 Vdc 2 NC 3 NC 4 Power Ground 5 Ref. Ground 6 Optical Current Monitor 7 Low Optical Power Alarm 8 NC 9 NC dc Monitor Voltages dc photocurrent (Pin 6): 1 V/mA Alarm Circuits 1 The alarm is an open collector output capable of sinking 20 mA when active and withstanding 15 V when off. It can be used for remote drive of relays or LEDs. 1. Open collector outputs. 6 Agere Systems Inc. Data Sheet June 2001 Wideband Photodiode Receivers Ordering Information Table 7. Wideband Photodiode Receiver Options Package Type Option No. -020 Connector/Pigtail Module Flange Plug-in -- x x FC/APC Bulkhead Optical Connector Connector1 -021 FC/SPC Bulkhead Optical -- x x -022 FC/APC Optical Connector/3 mm Fiber Cable Pigtail -- x -- -023 FC/SPC Optical Connector/3 mm Fiber Cable Pigtail -- x -- -026 FC/PC Bulkhead Optical Connector -- x x -028 FC/PC Optical Connector/3 mm Fiber Cable Pigtail -- x -- -030 No Optical Connector/900 m Buffered Fiber Pigtail x -- -- -031 FC/PC Optical Connector/900 m Buffered Fiber Pigtail x -- -- -032 FC/APC Optical Connector/900 m Buffered Fiber Pigtail x -- -- 1. FC/SPC connectors are a higher grade version of FC/PC connectors and are compatible with them. Table 8. Ordering Information1 Device Code Description Package Type Comcode 2510A 2510B 2515A 2515B 2516A 2516B 2516C 2518A 2518B 4510A 4510B 4515A 4515B 4516A 4516B 4516C 4518A 4518B 10450A 10450B 10455A 10455B 10456A 10456B 10456C 10458A 10458B Wideband Photodiode Receiver Module Module Module Module Module Module Module Module Module Flange-Mount Flange-Mount Flange-Mount Flange-Mount Flange-Mount Flange-Mount Flange-Mount Flange-Mount Flange-Mount Plug-in, for 19 in. Rack System Plug-in, for 19 in. Rack System Plug-in, for 19 in. Rack System Plug-in, for 19 in. Rack System Plug-in, for 19 in. Rack System Plug-in, for 19 in. Rack System Plug-in, for 19 in. Rack System Plug-in, for 19 in. Rack System Plug-in, for 19 in. Rack System TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD TBD 1. For additional ordering information, please contact an account manager at OPTO West, Agere Systems Inc., 1-800-362-3891 (for sales staff, please press option 2). Agere Systems Inc. 7 Wideband Photodiode Receivers Data Sheet June 2001 . For additional information, contact your Agere Systems Account Manager or the following: http://www.agere.com INTERNET: docmaster@micro.lucent.com E-MAIL: N. AMERICA: Agere Systems Inc., 555 Union Boulevard, Room 30L-15P-BA, Allentown, PA 18109-3286 1-800-372-2447, FAX 610-712-4106 (In CANADA: 1-800-553-2448, FAX 610-712-4106) ASIA PACIFIC: Agere Systems Singapore Pte. Ltd., 77 Science Park Drive, #03-18 Cintech III, Singapore 118256 Tel. (65) 778 8833, FAX (65) 777 7495 CHINA: Agere Systems (Shanghai) Co., Ltd., 33/F Jin Mao Tower, 88 Century Boulevard Pudong, Shanghai 200121 PRC Tel. (86) 21 50471212, FAX (86) 21 50472266 JAPAN: Agere Systems Japan Ltd., 7-18, Higashi-Gotanda 2-chome, Shinagawa-ku, Tokyo 141, Japan Tel. (81) 3 5421 1600, FAX (81) 3 5421 1700 EUROPE: Data Requests: DATALINE: Tel. (44) 7000 582 368, FAX (44) 1189 328 148 Technical Inquiries: OPTOELECTRONICS MARKETING: (44) 1344 865 900 (Ascot UK) Agere Systems Inc. reserves the right to make changes to the product(s) or information contained herein without notice. No liability is assumed as a result of their use or application. Copyright (c) 2001 Agere Systems Inc. All Rights Reserved June 2001 DS00-305OPTO-1 (Replaces DS00-305OPTO)