QSFP+ and zQSFP+ Multi-Port Connector Tooling 2-by-1 QSFP+ and zQSFP+ Insertion Tool Application Tooling Specification Sheet Order No. 62202-5300 FEATURES Lightweight tool used in the insertion of a QSFP+ and zQSFP+ connector in a PCB Inserts connector to a PCB without damage to the board Use tool 62202-5210 for removing connectors SCOPE Products: Quad Small Form-factor Pluggable Plus (QSFP+) and zQSFP+ Cage Assembly, 2-by 1 Multi-Port Connector, 2 Press Fit Rear Legs, Elastomeric Gasket for SAN Applications. Series No. 76871 171208 171722 76871-0001 76871-0007 171208-0001 171722-0001 171722-1802 76871-0002 76871-0008 171208-0002 171722-1000 171722-6001 Connector Order No. 76871-0003 76871-0004 76871-5001 76871-5002 171208-0003 171722-1001 171722-1002 76871-0005 76871-5003 76871-0006 76871-5004 171722-1003 171722-1062 Notes: 1. See the following pages for tooling operation instructions. 2. These tools require a "Keep Out Zone" around the connector free of components. The rear of the connector should be .197" (5.0mm). The right and left sides should be .14" (3.5mm). See Figure 1. QSFP CONNECTOR ASSEMBLY 5.0mm MINIMUM PCB 3.5mm MINIMUM (BOTH SIDES) Figure 1 KEEP OUT ZONE Doc. No: ATS-622025300 Revision: B Release Date: 07-08-13 Revision Date: 02-10-16 UNCONTROLLED COPY Page 1 of 2 QSFP+ and zQSFP+ Multi-Port Connector Tooling Description The following Instructions are used for inserting the 2 by 1 connector into a PCB. INSERTION TOOL OVER CONNECTOR ASSEMBLY Operation INSERTION TOOL (CLOSED END) Figure 2 1. Place a connector assembly on the PCB. 2. Place the tool on the connector assembly (closed end to the back end of the connector). See Figure 2. QSFP BOTTOM OF 3. Place tool, connector, and PCB CONNECTOR CONNECTOR TO PCB, in a press of suitable ASSEMBLY SEAT FLUSH ON PCB size and force, and seat the connector assembly as shown. The support plate (furnished by the customer) under the PCB must have clearance for the connector pins as they pass through the PCB. SIDE PLATE Clearance 1.0mm CLEARANCE BETWEEN BOARD AND THE SIDE PLATE AFTER QSFP ASSEMBLY IS SEATED ONTO THE PCB PCB Figure 3 Use this tool only with a press that has a pre-determined shut height when seating a QSFP Assembly on a PCB. See figure 3. Allowing the Press-In Tool to stop on the board will result in damage the QSFP cage and terminals being over seated. CAUTION: Molex application tooling specifications are valid only when used with Molex connectors and tooling. Contact Information For more information on Molex application tooling please contact Molex at 1-800-786-6539. Visit our Web site at http://www.molex.com Doc. No: ATS-622025300 Revision: B Release Date: 07-08-13 Revision Date: 02-10-16 UNCONTROLLED COPY Page 2 of 2