A267
■Product Specifications
Rated Current
Note 1
Rated Voltage
Crimping
Insulation Displacement
Crimping
250V AC
Insulation Displacement
100V AC
AWG 22~26: 2A
Wire size AWG 28 : 1A
AWG 30 : 0.5A
Wire size AWG 26 : 1A
Operating Temperature Range
Operating Humidity Range
Storage Temperature Range
Storage Humidity Range
■UL·CSA Safety Standard File No.
UL :E52653
CSA :LR95109
-30~85çNote 2
40~80%
-10~60çNote 3
40~70%
Note 1: Temperature rise included when energized
Note 2: This storage indicates a long-term storage state for the unused product before the board mounted.
The operating temperature and humidity ranges are applied to the non-energized state after the connector has been installed
to the board.
Note 3: The above standards represent this series. Individual formal agreement should be based on the "Specification".
Note 4: The above standards represent this series. The Individual formal agreement should be based on the Specification.
Item Specification Condition
1. Insulation Resistance 1000M
ø
min. Measured at 500V DC
2. Withstand voltage Neither short or insulation breakdown 650V AC for 1 minute
3. Contact Resistance 30m
ø
max. Measured at 100mA
4.
Single Insertion/Extraction Force
0.3N (30gf) min., 4.4N(450gf) min.
Measured by the square steel-made pin of 0.5±0.002mm
5. Vibration Electrical discontinuity, 1
µ
S max.
10~55Hz and single amplitude 0.75mm in 3 directions for 2 hours,respectively.
6.
Moisture Resistance
Contact resistance: 30mømax. Insulation resistance: 500Mømin.
Exposed to temperature 40±2çand humidity 90~95%for 96 hours
7. Temperature Cycle
Contact resistance: 30mømax. Insulation resistance: 1000Mømin.
(-55ç: 30 minutes ➝ 15~35ç: 2~3 minutes
85ç: 30 minutes ➝ 15~35ç: 2~3minutes) 5 cycles
8. Operating Life Contact resistance: 30m
ø
max. Tin plating: 30 cycles
Gold plating:50 cycles
DIP type
Reflow 250
ç
for 10 seconds
9.
Resistance to Soldering heat
No resion area fusion to degrade performance Manual solder
Soldering iron temperature 300
ç
for 2 seconds
SMT type
Reflow
According to the recommended temperature profile
Soldering iron temperature
300çfor 3 seconds
■Features of DF11 Insulation Displacement Machine
(Single Core Punching Full Automatic ID Machine AM700/DF11)
● 5 Major Features of ID Machine AM700/DF11
1. Perform the multi-harness.
2. The setup time has been widely reduced. (10 minutes maximum)
3. Space saving design.
(About half space compared with the conventional machine)
4. Minimize initial cost with low cost.
5. The harness data can be saved in the floppy disk and easily
changed.
■Points
Since the DF11 insulation displacemention allows double rows ID with a single part, the harness service is completed with
machine connection only.
Rating
Rated Current
Rated Voltage
UL-CSA Safety Standard Approved Specification
30V AC
AWG 22 : 2A
Wire size AWG 24~28: 1A
AWG 30 : 0.5A
Rating
Data storage
Low cost
Multi-harness
Half space
Setup in 10 minutes