LOW COST PLASTIC APPLICATOR P/N 293220-1
(FOR 4 POS. WIRE TO WIRE IDC CONNECTOR)
Instruction Sheet
411-20103
Rev. 4
Tyco-Electronics AMP Italia S.r.l. - C.so F.lli Cervi, 15 - COLLEGNO (TO) 10093 - Tel +39 011 40121
This AMP controlled document is subject to change. For latest revision call the AMP Italy number.
Copyright 1993 by AMP Incorporated. All international rights reserved.
* Trademark of AMP Incorporated
Page 1 of 2
1 BEFORE TERMINATION
The Figure 1 represents the status of
the connector before the termination.
2 PREPARATION
The connector must be oriented as shown and the
wires that should be terminated have to be prepared
(on Figure 2 is represented the full wires case)
3 POSITIONING
The connector must be placed into the base as shown
then the wires must be inserted into the proper holes of the
connector fixing them into the external frictioning feature.
Figure 2
Figure 1
Figure 3
APPLICATOR
PUSHER
APPLICATOR
BASE
CONNECTOR
LOW COST PLASTIC APPLICATOR P/N 293220-1
(FOR 4 POS. WIRE TO WIRE IDC CONNECTOR)
Instruction Sheet
411-20103
Rev. 4
Tyco-Electronics AMP Italia S.p.A. - C.so F.lli Cervi, 15 - COLLEGNO (TO) 10093 - Tel +39 011 40121
This AMP controlled document is subject to change. For latest revision call the AMP Italy number.
Copyright 1993 by AMP Incorporated. All international rights reserved.
* Trademark of AMP Incorporated
Page 2 of 2
4 PUSHER LOCKING
The pusher must be positioned over the connector and locked into the
base as shown.
5 TERMINATION BY CLAMPS
The two parts of the applicator must be closed
by appropriate clamps in order to establish
the electrical connection.
6 PUSHER UNLOCKING
The pusher must be unlocked from the base and removed as shown.
7 AFTER TERMINATION
The terminated connector can be picked up from the base, as shown.
Figure 5
Figure 7
Figure 4
Figure 6
