Darlington Transistor TO-3 Description Designed for use as output devices in complementary general purpose amplifier applications. Features: * * * High gain darlington performance High DC current gain hFE = 1,000 (Minimum) at Ic = 20A Monolithic construction with built-in base-emitter shunt resistor Maximum Ratings Characteristic Symbol MJ11016 Collector-Emitter Voltage VCEO 120 CoIIector-Base Voltage VCBO 120 Emitter-Base Voltage Unit V VEBO 5 Collector Current -Continuous -Peak IC ICM 30 50 Base Current IB 1 PD 200 1.15 W W/C TJ, TSTG -65 to +200 C Characteristic Symbol Maximum Unit Thermal Resistance Junction to Case Rjc 0.87 C/W Total Power Dissipation @TC= 25C Derate above 25C Operating and Storage Junction Temperature Range A Thermal Characteristics www.element14.com www.farnell.com www.newark.com Page <1> 13/08/14 V1.1 Darlington Transistor TO-3 Electrical Characteristics (TC = 25C unless otherwise noted) Characteristic Symbol Minimum Maximum Unit VEO (sus) 120 - V ICEO - 1 ICER - 1 5 IEBO - 5 hFE 1,000 200 - VCE (sat) - 3 4 VBE (sat) - 3.5 5 |hfe| 4 - Off Characteristics Collector-Emitter Sustaining Voltage (1) (lC= 100mA, lB = 0) MJ11016 Collector Cutoff Current (VCE = 50 V, IB = 0 ) Collector-Emitter Leakage Current (VCE = 120V, RBE = 1k) (VCE = 120V, RBE = 1k, TC = 125C) MJ11016 MJ11016 Emitter Cutoff Current (VEB = 5V, IC = 0 ) mA On Characteristrics (1) DC Current Gain (lC = 20A,VCE = 5V) (lC = 30A,VCE = 5V) Collector-Emitter Saturation Voltage (lC = 20A, IB = 200mA) (lC = 30A, lB = 300mA) Base-Emitter Saturation Voltage (lC = 20A, IB = 200mA) (lC = 30A, IB = 300mA) - V Dynamic Characteristics Small-Signal Current Gain (lC = 10A, VCE = 3V, f =1MHz) - (1) Pulse Test : Pulse Width = 300s, Duty Cycle 2%. (2) fT = |hfe|* ftest. Internal Schematic Diagram NPN MJ11016 www.element14.com www.farnell.com www.newark.com Page <2> 13/08/14 V1.1 Darlington Transistor TO-3 www.element14.com www.farnell.com www.newark.com Page <3> 13/08/14 V1.1 Darlington Transistor TO-3 www.element14.com www.farnell.com www.newark.com Page <4> 13/08/14 V1.1 Darlington Transistor TO-3 There are two limitation on the power handling ability of a transistor: average junction temperature and second breakdown safe operating area curves indicate IC-VCE limits of the transistor that must be observed for reliable operation i.e., the transistor must not be subjected to greater dissipation than curves indicate. The data of SOA curve is base on TJ(PK) = 200C; TC is variable depending on conditions. Second breakdown pulse limits are valid for duty cycles to 10% provided TJ(PK) 200C. At high case temperatures, thermal limitation will reduce the power that can be handled to values less than the limitations imposed by second breakdown. www.element14.com www.farnell.com www.newark.com Page <5> 13/08/14 V1.1 Darlington Transistor TO-3 TO-3 Dimensions Minimum Maximum A 38.75 39.96 B 19.28 22.23 C 7.96 9.28 D 11.18 12.19 E 25.2 26.67 F 0.92 1.09 G 1.38 1.62 H 29.9 30.4 I 16.64 17.3 J 3.88 4.36 K 10.67 11.18 Pin 1. Base 2. Emitter 3. Collector (Case) Part Number Table Description Part Number Darlington Transistor, TO-3 MJ11016 Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. (c) Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com Page <6> 13/08/14 V1.1