ACDC
Specification
60 Watts
•Single, Dual, Triple & Quad Outputs
•Output Voltages from 3.3 V to 48 V
•Nonstandard Outputs Available
•Industry Standard 3” x 5” Package
•Fits 1U Applications
•Open Frame, U Channel & Covered Versions
•3 Year Warranty
SDS Series
Input
Input Voltage • 90-264 VAC (120-370 VDC)
Input Frequency • 47-63 Hz
Input Current • 1.6 A max at 115 VAC
1.0 A max at 230 VAC
Inrush Current • <15 A at 115 VAC, cold start at 25 °C
<30 A at 230 VAC, cold start at 25 °C
Earth Leakage Current • <0.30 mA at 115 VAC
<0.75 mA at 240 VAC
Power Factor • EN61000-3-2, Class A
Input Protection • T2 A/250 VAC internal fuse in line
Output
Output Voltage • See table
Output Voltage Trim • ±10% on V1 only (see note 4)
Initial Set Accuracy • Single output models: ±1%
Multi-output models: ±5%
Minimum Load • 10% required on V1 & V2 of multi-output
models to maintain regulation, unit will
start up with no load
Start Up Delay • 2 s typical
Hold Up Time • 12 ms min at 110 VAC, 100% load
Line Regulation • 1% from low line to high line
Load Regulation • 7% max all models 3% typical, see table
10% with no load on V1, for multi output
models
Transient Response • 4% max deviation, recovery to within
1% in 4 ms for a 50% load change
Ripple & Noise • 1% pk-pk typical, 20 MHz bandwidth
Overvoltage Protection • 112-132% of nominal output voltage on
V1 only, recycle input to reset
Overload Protection • 110-150% of nominal power,
with auto recovery
Short Circuit Protection • Trip & restart (hiccup mode),
auto recovery
Temperature • ±0.04%/°C
Coefficient
xppower.com
General
Efficiency • 80% typical, 230 VAC full load
Isolation • 3000 VAC Input to Output
1500 VAC Input to Ground
500 VDC Output to Ground
Switching Frequency • 60 kHz typical
Power Density • 3.5 W/In3
Signals • Green DC OK LED
MTBF • 190 kHrs typical to MIL-HDBK-217F
at 25 °C, GB
Environmental
Operating Temperature • 0 °C to +70 °C, derate linearly from 100%
load at +50 °C to 50% load at +70 °C
Cooling • Convection-cooled
Operating Humidity • 5-95% RH, non-condensing
Storage Temperature • -40 °C to +85 °C
EMC & Safety
Emissions • EN55022, level B conducted and radiated
Harmonic Currents • EN61000-3-2, Class A
Voltage Flicker • EN61000-3-3
ESD Immunity • EN61000-4-2, level 2 contact, level 3 air,
Perf Criteria A
Radiated Immunity • EN61000-4-3, level 2, Perf Criteria A
EFT/Burst • EN61000-4-4, level 2, Perf Criteria A
Surge • EN61000-4-5, installation Class 3,
Perf Criteria A
Conducted Immunity • EN61000-4-6, level 2, Perf Criteria A
Magnetic Field • EN61000-4-8, 1 A/m, Perf Criteria A
Dips & Interruptions • EN61000-4-11, 30% 10 ms,
60% 100 ms, 100% 5000 ms
Perf Criteria A, B, B
Safety Approvals • EN60950-1, UL60950-1,
CSA60950-1 per cUL
21-Jan-11
ACDC
Output Power Output V1(2,3,4) Output V2(2,3,4) Output V3(3) Output V4(3) Model Number(5,6)
63.0 W +5.0 V/7.0 A +12.0 V/3.0 A SDS60UD01
48.1 W +3.3 V/7.0 A +5.0 V/5.0 A SDS60UD04
63.0 W +3.3 V/6.0 A +12.0 V/3.0 A -12.0 V/0.8 A SDS60UT00
63.0 W +3.3 V/6.0 A +12.0 V/3.0 A -5.0 V/0.8 A SDS60UT01
63.0 W +3.3 V/6.0 A +12.0 V/3.0 A +5.0 V/0.8 A SDS60UT02
53.5 W +3.3 V/5.0 A +5.0 V/5.0 A +12.0 V/1.0 A SDS60UT03
53.5 W +3.3 V/5.0 A +5.0 V/5.0 A -12.0 V/1.0 A SDS60UT04
63.0 W +5.0 V/6.0 A +12.0 V/3.0 A -12.0 V/0.8 A SDS60UT05
63.0 W +5.0 V/6.0 A +12.0 V/3.0 A -5.0 V/0.8 A SDS60UT06
63.0 W +5.0 V/6.0 A +15.0 V/3.0 A -15.0 V/0.8 A SDS60UT07
63.0 W +5.0 V/6.0 A +24.0 V/2.0 A -24.0 V/0.5 A SDS60UT08
63.0 W +5.0 V/6.0 A +24.0 V/2.0 A -12.0 V/0.8 A SDS60UT09
63.0 W +5.0 V/6.0 A +24.0 V/2.0 A +12.0 V/0.8 A SDS60UT10
63.0 W +3.3 V/6.0 A +12.0 V/3.0 A -12.0 V/0.8 A -5.0 V/0.8 A SDS60UQ00
63.0 W +3.3 V/6.0 A +12.0 V/3.0 A -12.0 V/0.8 A +5.0 V/0.8 A SDS60UQ01
63.0 W +5.0 V/6.0 A +12.0 V/3.0 A -12.0 V/0.8 A -5.0 V/0.8 A SDS60UQ02
63.0 W +5.0 V/6.0 A +12.0 V/3.0 A -12.0 V/0.8 A +24.0 V/0.8 A SDS60UQ03
63.0 W +5.0 V/6.0 A +12.0 V/3.0 A -12.0 V/0.8 A -24.0 V/0.8 A SDS60UQ04
63.0 W +5.0 V/6.0 A +15.0 V/3.0 A -15.0 V/0.8 A -5.0 V/0.8 A SDS60UQ05
59.3 W +5.0 V/6.0 A +24.0 V/1.8 A -15.0 V/0.1 A +12.0 V/0.8 A SDS60UQ06
0.16 (4.0) DIA MOUNTING HOLE (4PL.)
AC
INPUT
P1
P2
DC
OUTPUT
L
1
6
7(multi output only)
8
ADJ
DC OK
LED
N
G
2.55 (64.8)
4.56 (115.8)
5.00 (127.0)
3.00 (76.2)
0.22 (5.6)
0.22 (5.6)
1.20 (30.5)
0.12 (3.0)
max
SDS60
Mechanical Details
PIN CONNECTIONS
Pin Single Output Dual Output Triple Output Quad Output
1 Output 1 Output 2 Output 2 Output 2
2 Output 1 Output 1 Output 1 Output 1
3 Output 1 Output 1 Output 1 Output 1
4 Return Common Common Common
5 Return Common Common Common
6 Return N/C Output 3 Output 3
7 Output 4
8 Output 4
Models and Ratings
Notes
Notes
1. If an output voltage within the factory-set voltage range is required, a model
number will be allocated at the time of order.
2. 10% minimum load required on V1 & V2 of multi-output units to maintain
regulation of ±5%. Regulation increases to ±10% with no load.
3. Other output combinations are available - contact sales for more information.
4. On multi-output units V2 tracks V1, if V1 is adjusted by 5%, V2 changes by 5%.
5. For optional U-bracket, add suffix ‘B’ to model number.
6. For optional 2 pin AC input, contact sales for details.
7. To receive unit with cover fitted, add suffix ‘-C’ to model number.
1. All dimensions are in inches (mm)
2. Weight: 0.52 lbs (240 g) approx
3. Tolerance: ±0.02 (0.5)
4. Input connector mates with Molex housing 09-50-3051 and Molex 2878 series crimp terminal.
5. Output connector mates with Molex housing 09-50-3061 or 9-50-3081 and
Molex 2878 series crimp terminal.
6. For optional cover kit order part number SDS60 COVER KIT, to receive unit with cover
fitted add suffix ‘-C’ to model number. Cover size: 5.46 x 3.55 x 1.55 (140 x 91 x 39.7mm).
7. For mating connectors and cable harness order part numbers:
SDS60 CON KIT - Single, dual and triple output models
SDS60Q CON KIT - Quad output models
SDS60 LOOM KIT - Single output models cable harness
SDS60DT LOOM KT - Dual and triple output models cable harness
SDS60Q LOOM KIT - Quad output models cable harness
Output Power Output Voltage Output Current Factory-Set
Voltage Range(1) Current Range Total Regulation Model Number(5,6)
50 W 3.3 V 15.1 A 3.0-5.0 VDC 16.6-10.0 A 5% SDS60US03
55 W 5.0 V 11.0 A 5.0-6.0 VDC 11.0-9.1 A 5% SDS60US05
60 W 7.0 V 8.6 A 6.0-8.0 VDC 10.0-7.5 A 4% SDS60US07
63 W 9.0 V 7.0 A 8.0-11.0 VDC 7.8-5.7 A 3% SDS60US09
63 W 12.0 V 5.2 A 11.0-13.0 VDC 5.7-4.8 A 3% SDS60US12
63 W 15.0 V 4.2 A 13.0-16.0 VDC 4.8-3.9 A 3% SDS60US15
63 W 19.0 V 3.3 A 16.0-21.0 VDC 3.9-3.0 A 3% SDS60US19
63 W 24.0 V 2.6 A 21.0-27.0 VDC 3.0-2.3 A 2% SDS60US24
63 W 30.0 V 2.1 A 27.0-33.0 VDC 2.3-1.9 A 2% SDS60US30
63 W 36.0 V 1.7 A 33.0-40.0 VDC 1.9-1.5 A 2% SDS60US36
63 W 48.0 V 1.3 A 40.0-50.0 VDC 1.5-1.2 A 2% SDS60US48
