Crystal Resonator Specifications: Electrical Parameters: No Description Contents 1 Holder Type MCRSD03686F183000RR 2 Nominal Frequency 3 Oscillation Mode 4 Load Capacitance 5 Frequency Tolerance at 25C 3C 30ppm 6 Frequency Tolerance in Operating Temperature Range 30ppm 7 Operating Temperature Range -20C to +70C 8 Storage Temperature Range -40C to +85C 9 Equivalent Series Resistance 80 10 Drive Level 11 Shunt Capacitance 12 Insulation Resistance 500M 13 Test Impedance Meter KH1200 14 Aging 3.6864MHz AT-FUND 18pF 100W 5pF 3ppm/Year www.element14.com www.farnell.com www.newark.com Page <1> 24/02/14 V1.0 Crystal Resonator Physical & Environmental Parameters: No 1 Description Lead Strength Lead Bending Contents Force of 0.9kg is applied for 10 1seconds to each lead in axial direction. Firmed the terminal up to 2mm, lead shall be subjected to withstand against 90 bending its stem. This operation shall be done toward both direction. 10 ~ 500Hz, 0.75mm amplitude, in 3 directions duration of 2h. Measurement taken after 1 hour. 2 Vibration 3 Random Dropping The crystal will be test by natural dropping to 3cm wooden broad 3 times from high of 75cm. 4 Solder Stability Dipped the terminals no closer than 2mm into the solder bath at 235C 5C for 2 0.5 sec. 5 Resistance Solder Heat Use a 350C 10C solder iron to touch device under test at the 2 ~ 2.5mm end part of lead for 10 1 seconds. Measurement taken after DUT being left at room temperature for at least 1hours. 6 Temperature Cycle Shock Temperature cycling from -40C (30mins) to +85C (30mins) was performed 3 times, then placed in a natural condition for 24 2 hours. 7 Life Test (High Temperature) Placed in a chamber (125C 2C) for 72 hours, then placed in a natural condition for 24 2 hours. 8 Life Test (Low Temperature) Placed in a chamber (-55C 2C) for 72 hours, then placed in a natural condition for 24 2 hours. 9 Humidity Requirements No mechanical damage and the measured values shall meet electrical parameters. At least 95% of the terminal surface shall be coated by the solder Measured values shall meet electrical parameters. Placed in a chamber (Humi: 90 ~ 95% RH, Temp: 40C 2C) for 96 hours, then placed in a natural condition for 24 2 hours. www.element14.com www.farnell.com www.newark.com Page <2> 24/02/14 V1.0 Crystal Resonator Dimensions: Part Number L Max. MCRSD03686F183000RR 4.3 Dimensions : Millimetres Reflow Profile: Part Number Table Description Part Number Crystal Resonator MCRSD03686F183000RR Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. (c) Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com Page <3> 24/02/14 V1.0