www.element14.com
www.farnell.com
www.newark.com
Page <1> V1.024/02/14
Crystal Resonator
No Description Contents
1Holder Type MCRSD03686F183000RR
2 Nominal Frequency 3.6864MHz
3 Oscillation Mode AT-FUND
4 Load Capacitance 18pF
5 Frequency Tolerance at 25°C ±3°C ±30ppm
6Frequency Tolerance
in Operating Temperature Range ±30ppm
7Operating Temperature Range -20°C to +70°C
8Storage Temperature Range -40°C to +85°C
9 Equivalent Series Resistance ≤80Ω
10 Drive Level ≤100μW
11 Shunt Capacitance ≤5pF
12 Insulation Resistance ≥500MΩ
13 Test Impedance Meter KH1200
14 Aging ±3ppm/Year
Electrical Parameters:
Specications:
www.element14.com
www.farnell.com
www.newark.com
Page <2> V1.024/02/14
Crystal Resonator
No Description Contents Requirements
1Lead Strength
Lead Bending
Force of 0.9kg is applied for 10 ±1seconds to each
lead in axial direction.
Firmed the terminal up to 2mm, lead shall be
subjected to withstand against
90º bending its stem. This operation shall be done
toward both direction. No mechanical damage and
the measured values shall
meet electrical parameters.
2 Vibration 10 ~ 500Hz, 0.75mm amplitude, in 3 directions
duration of 2h. Measurement taken after 1 hour.
3 Random Dropping The crystal will be test by natural dropping to 3cm
wooden broad 3 times from high of 75cm.
4 Solder Stability Dipped the terminals no closer than 2mm into the
solder bath at 235°C ±5°C for 2 ±0.5 sec.
At least 95% of the terminal
surface shall be coated by the
solder
5Resistance Solder
Heat
Use a 350°C ±10°C solder iron to touch device under
test at the 2 ~ 2.5mm end part of lead for 10 ±1
seconds. Measurement taken after DUT being left
at room temperature for at least 1hours.
Measured values shall meet
electrical parameters.
6Temperature Cycle
Shock
Temperature cycling from -40°C (30mins) to +85°C
(30mins) was performed 3 times, then placed in a
natural condition for 24 ±2 hours.
7Life Test
(High Temperature)
Placed in a chamber (125°C ±2°C) for 72 hours,
then placed in a natural condition for 24 ±2 hours.
8Life Test
(Low Temperature)
Placed in a chamber (-55°C ±2°C) for 72 hours,
then placed in a natural condition for 24 ±2 hours.
9 Humidity
Placed in a chamber (Humi: 90 ~ 95% RH,
Temp: 40°C ±2°C) for 96 hours, then placed in a
natural condition for 24 ±2 hours.
Physical & Environmental Parameters:
www.element14.com
www.farnell.com
www.newark.com
Page <3> V1.024/02/14
Crystal Resonator
Important Notice : This data sheet and its contents (the “Information”) belong to the members of the Premier Farnell group of companies (the “Group”) or are licensed to it. No licence is granted
for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change
without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any
error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any
assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the
Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence.
Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.
Dimensions:
Reow Prole:
Part Number Table
Description Part Number
Crystal Resonator MCRSD03686F183000RR
Part Number L Max.
MCRSD03686F183000RR 4.3
Dimensions : Millimetres
