Thyristors Datasheet 2N6394 Surface Mount - 50 - 800V Pb Description The 2N6394 is designed primarily for half-wave AC control applications, such as motor controls, heating controls and power supplies. Features Glass Passivated Junctions for Greater Parameter Uniformity and Stability Blocking Voltage to 800 V These are Pb-Free Devices Small, Rugged, Thermowatt Construction for Low Thermal Resistance, High Heat Dissipation and Durability Additional Information Resources Accessories Pin Out Samples CASE 221A STYLE 4 1 Functional Diagram 1 2 (c) 2021 Littelfuse, Inc. Specifications are subject to change without notice. Revised: GD. 02/11/21 Thyristors Datasheet 2N6394 Surface Mount - 50 - 800V Maximum Ratings (TJ = 25C unless otherwise noted) Rating Symbol Value Unit VDRM, VRRM 50 100 400 800 V 12 A ITSM 100 A 2N6394 2N6395 2N6397 2N6399 Peak Repetitive Off-State Voltage (Note 1) (TJ = -40 to 110C, Sine Wave, 50 to 60 Hz, Gate Open) On-State RMS Current (180 Conduction Angles; TC = 90C) Peak Non-Repetitive Surge Current (1/2 Cycle, Sine Wave, 60 Hz, TJ = 90C) IT Circuit Fusing Considerations (t = 8.3 ms) (RMS) I2t 40 As Forward Peak Gate Power (Pulse Width 1.0 s, TC = 90C) PGM 20 W Forward Average Gate Power (t = 8.3 ms, TC = 90C) PG(AV) 0.5 W Forward Peak Gate Current (Pulse Width 1.0 s, TC = 90C) IGM 2.0 A Operating Junction Temperature Range TJ -40 to +125 C Storage Temperature Range Tstg -40 to +125 C Indicates JEDEC Registered Data Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. 1.VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. Thermal Characteristics Rating Thermal Resistance, Junction to Case Maximum Lead Temperature for Soldering Purposes, 1/8" from case for 10 seconds Symbol Value Unit R8JC 2.0 C/W TL 260 C Indicates JEDEC Registered Data. Electrical Characteristics - OFF (TC = 25C unless otherwise noted; Electricals apply in both directions) Characteristic *Peak Repetitive Blocking Current (VD = VDRM = VRRM; Gate Open) TJ = 25C TJ = 100C Symbol Min Typ Max Unit IDRM, IRRM - - 1.0 A - - 2.0 mA Electrical Characteristics - ON (TC = 25C unless otherwise noted; Electricals apply in both directions) Characteristic Symbol Min Typ Max Unit Peak Forward On-State Voltage (Note 2) (ITM = 24 A Peak) VTM - 1.7 2.2 V Gate Trigger Voltage (Continuous DC), All Quadrants (Continuous dc) (VD = 12 Vdc, RL = 100 Ohms) IGT - 5.0 30 mA Gate Trigger Voltage (Continuous dc) (VD = 12 Vdc, RL = 100 Ohms) VGT - 0.7 1.5 V Gate Non-Trigger Voltage (VD = 12 Vdc, RL = 100 Ohms, TJ = 125C) VGD 0.2 - - V Holding Current (VD = 12 Vdc, Initiating Current = 200 mA, Gate Open) IH - 6.0 50 mA Turn-On Time (ITM = 12 A, IGT = 40 mAdc, VD = Rated VDRM) tgt - 1.0 2.0 s - - 15 - - 35 Turn-Off Time (VD = Rated VDRM) (ITM = 12 A, IR = 12 A) (ITM = 12 A, IR = 12 A, TJ = 125C) tq s Indicates JEDEC Registered Data 2. Pulse Test: Pulse Width 300 sec, Duty Cycle 2%. 2 (c) 2021 Littelfuse, Inc. Specifications are subject to change without notice. Revised: GD. 02/11/21 Thyristors Datasheet 2N6394 Surface Mount - 50 - 800V Dynamic Characteristics Characteristic Critical Rate-of-Rise of Off-State Voltage Expovnential (VD = Rated VDRM, TJ = 125C) Symbol Min Typ Max Unit dv/dt(c) - 50 - V/s Voltage Current Characteristic of Triacs (Bidirectional Device) Symbol Parameter VDRM Peak Repetitive Forward Off State Voltage IDRM Peak Forward Blocking Current VRRM Peak Repetitive Reverse Off State Voltage IRRM Peak Reverse Blocking Current VTM Maximum On State Voltage IH Holding Current I I I Figure 1. Current Derating I Figure 2. Maximum On-State Characteristics 3 (c) 2021 Littelfuse, Inc. Specifications are subject to change without notice. Revised: GD. 02/11/21 Thyristors Datasheet 2N6394 Surface Mount - 50 - 800V Figure 3. On-State Characteristics Figure 4. Maximum Non-Repetitive Surge Current Figure 5. Typical Thermal Response 4 (c) 2021 Littelfuse, Inc. Specifications are subject to change without notice. Revised: GD. 02/11/21 Thyristors Datasheet 2N6394 Surface Mount - 50 - 800V Typical Characteristics Figure 6. Typical Gate Trigger Current vs. Pulse Width Figure 7. Typical Gate Trigger Current vs. Temperature Figure 8. Typical Gate Trigger Voltage vs. Temperature Figure 9. Typical Holding Current vs.Temperature 5 (c) 2021 Littelfuse, Inc. Specifications are subject to change without notice. Revised: GD. 02/11/21 Thyristors Datasheet 2N6394 Surface Mount - 50 - 800V Dimensions Part Marking System 4 SEATING PLANE B F 4 Q 12 2N639xG YMAXX C T S A U 3 1 H 2 3 TO 220AB CASE 221A STYLE 12 K Z x =D, M, or N Y =Year M =Month A =Assembly Site XX =Lot Serial Code G =Pb-Free Package R L V J G D N Dim Inches Millimeters Pin Assignment Min Max Min Max 1 Cathode A 0.590 0.620 14.99 15.75 2 Anode B 0.380 0.420 9.65 10.67 3 Gate C 0.178 0.188 4.52 4.78 4 Anode D 0.025 0.035 0.64 0.89 F 0.142 0.147 3.61 3.73 G 0.095 0.105 2.41 2.67 H 0.110 0.130 2.79 3.30 J 0.018 0.024 0.46 0.61 K 0.540 0.575 13.72 14.61 L 0.060 0.075 1.52 1.91 N 0.195 0.205 4.95 5.21 Q 0.105 0.115 2.67 2.92 R 0.085 0.095 2.16 2.41 S 0.045 0.060 1.14 1.52 T 0.235 0.255 5.97 6.47 U 0.000 0.050 0.00 1.27 V 0.045 --- 1.15 --- Z --- 0.080 --- 2.04 Ordering Information Device Package Shipping 2N6394G 1000 Units / Box 2N6394TG 1000 Units / Box 2N6395G 2N6397G 2N6397TG TO-220AB (Pb-Free) 1000 Units / Box 1000 Units / Box 1000 Units / Box 2N6399G 1000 Units / Box 2N6399TG 1000 Units / Box 1. Dimensioning and tolerancing per ansi y14.5m, 1982. 2. Controlling dimension: inch. 3. Dimension z defines a zone where all body and lead irregularities are allowed. Disclaimer Notice - Information furnished is believed to be accurate and reliable. However, users should independently evaluate the suitability of and test each product selected for their own applications. Littelfuse products are not designed for, and may not be used in, all applications. Read complete Disclaimer Notice at http://www.littelfuse.com/disclaimer-electronics. 6 (c) 2021 Littelfuse, Inc. Specifications are subject to change without notice. Revised: GD. 02/11/21