MICROMOT
System
The complete engraving kit: with trial glass and motifs
allowing anyone to start immediately!
14
The UHV shown is described
on page 17.
Complete engraving kit with „trial glass“
Complete engraving kit with „trial glass“, supplied with the tried and tested
engraving tool GG 12 (12 – 18V, 20,000rpm spindle speed, fitted with ball bearing),
TUV approved mains adapter (12V, 0.5A), motifs and instruction booklet as well
as all necessary bits: 1.0 and 1.8mm diamond grinding bits with spherical head
for engraving and line work, silicon carbide grinding bits in both conical and
bullet shape for frosting glass as well as carborundum grinding bits in ball and
cylinder shape for grinding and engraving. Every component is securely packed
in an attractive plastic case and bit holder is included for.
No 28 635
Engraving tool GG 12, 12 Volt
Available individually, includes one diamond bit (1.8mm spherical head).
No 28 592
Two ball bearings in the turned, light
aluminium hand piece and one in the
drive end prevent tool bit chatter.
The highly flexible shroud and core
effortlessly transmit power without
heating up when bent tightly. Antikink
springs at the grip and drive end pre-
vent kinks. Six MICROMOT collets
1.0 – 1.5 – 2.0 – 2.4 – 3.0 and
3.2mm are supplied.
No 28 620
Flexishaft MICROMOT 110/P
with triple ball bearings, up to 25,000rpm.
VOLT
12
Supplied in durable plastic case.
