https://www.phoenixcontact.com/us/products/1020775 Connector-PV-C4M-S 2,5-6 (-)-1020775 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Photovoltaic connector, Range of articles: PV-C4M-S, Connector, housing material: PPE, color: black, min. conductor cross section: 2.5 mm, max. conductor cross section: 6 mm, rated current: 20 A, Connection method: Spring-cage, Type of contact: Pin Key Commercial Data Packing unit 1 pc Minimum order quantity 50 pc GTIN GTIN 4055626511283 Weight per Piece (excluding packing) 19.600 g Custom tariff number 85359000 Country of origin India Technical data Dimensions External cable diameter 5 mm ... 8 mm Ambient conditions Degree of protection (when plugged in) IP66 /IP68 (2 m / 24 h) Ambient temperature (operation) -40 C ... 85 C Ambient temperature (assembly) -25 C ... 50 C General Design Pin Tightening torque nut 2 Nm 0.1 Nm Insertion force 45 N 10 N 02/15/2021Page1/5 https://www.phoenixcontact.com/us/products/1020775 Connector-PV-C4M-S 2,5-6 (-)-1020775 Technical data General Disconnect force 250 N 50 N (when locked) Pull-out force of cable >= disconnect force > 80 N Insertion/withdrawal cycles 100 Degree of pollution 2 Degree of protection IP66 /IP68 (2 m / 24 h) Voltage 1500 V Current 35 A Rated surge voltage (III/3) 16 kV pluggable Yes Nominal cross section 6 mm Protection class II Material Color black Insulating material mPPE Contact material Cu Contact surface material Ag Connection data Connection method Spring-cage Connection capacity 2.5 mm ... 6 mm Contact resistance with connected conductor 0.45 m Stripping length 15 mm Cable type H1Z2Z2-K cable Type of contact Pin Standards and Regulations Flammability rating according to UL 94 V0 Safety note * WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. * WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. * The products are suitable for applications in plant, controller, and electrical device engineering. 02/15/2021Page2/5 https://www.phoenixcontact.com/us/products/1020775 Connector-PV-C4M-S 2,5-6 (-)-1020775 Technical data Standards and Regulations * Assembled products may not be manipulated or improperly opened. * Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). * When using the product in direct connection with third-party manufacturers, the user is responsible. * For operating voltages > 50V AC, conductive connector housings must be grounded * Ensure that the protective or functional ground has been properly connected. * Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product * The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product. * Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products * The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). * Operate the connector only when it is fully plugged in and interlocked. * Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. * Observe the minimum bending radius of the cable. Lay the cable without twisting it. Environmental Product Compliance China RoHS Environmentally friendly use period: unlimited = EFUP-e No hazardous substances above threshold values Drawings Dimensional drawing 82,6 27,4 O20 15 16 02/15/2021Page3/5 https://www.phoenixcontact.com/us/products/1020775 Connector-PV-C4M-S 2,5-6 (-)-1020775 Classifications eCl@ss eCl@ss 10.0.1 27440102 eCl@ss 11.0 27440102 eCl@ss 8.0 27440102 eCl@ss 9.0 27440102 Accessories Accessories Photovoltaic connector Protective cap-PV-C PROTECTION CAP-1785430 Photovoltaic connector, Range of articles: SUNCLIX, Protective cap, color: black. self-sealing, without interlock, set consisting of: 1protective cap for connector side and1protective cap for coupling side Filler plugs-PV-C-PLUG-HV-1623478 Photovoltaic connector, Filler plugs, housing material: PA 6 Screwdriver tools Screwdriver-SZF 1-0,6X3,5-1204517 Actuation tool, for ST terminal blocks, also suitable for use as a bladed screwdriver, size: 0.6 x 3.5 x 100 mm, 2component grip, with non-slip grip Stripping tool 02/15/2021Page4/5 https://www.phoenixcontact.com/us/products/1020775 Connector-PV-C4M-S 2,5-6 (-)-1020775 Accessories Stripping pliers-QUICK WIREFOX 6 SC-1207637 Stripping tool for short-circuit proof conductors, stripping range: 1.5 up to 6 mm, wire cutting up to 6 mm cable stopper up to 18 mm Stripping tool-WIREFOX-D SR 6-1-1212511 Stripping tool, for standard 2.5, 4, and 6 mm solar cables, with 15 mm length stop, for SUNCLIX field connectors Phoenix Contact 2021 (c) - all rights reserved http://www.phoenixcontact.com 02/15/2021Page5/5