BIAS Power Supply Module BPW 4 Series Data Sheet Single (Vo) or Dual (Vo & Vr) output BPW 4-08-00, -08-33, -08-50 BPW 4-14-00, -14-33, -14-50 BPW 4-24-00 The BPW 4 Power Supply Module is an ideal solution for numerous control applications in lighting, sensing, smart building and power distribution where operation from 277VAC mains is required. This low-cost supply provides up to four watts of output power at 8, 14 and 24 VDC (Vo) and optional 3.3 and 5.0 VDC (Vr) output for microprocessors, logic, timing circuits, transceivers, sensors or other control functions. Incorporating a custom integrated circuit into a small package (2.45 in3 [40.1 cm3]) the BIAS Module provides an immediate "drop-in" solution, requiring no additional external components. Operating Specifications (@120VAC / 60 Hz / 25C unless otherwise specified) Electrical Input Voltage Range 85 - 308 VAC (50/60Hz) Input Surge Withstand 345V, < 30 sec Output Power (Pmax) 4 W min. (60Hz) 3.33 W min. (50Hz) Efficiency 70% Output Vo (Peak) 8, 14 or 24 VDC nom. +/- 5% Line / Load Regulation Vo (Peak) +/- 1% Po < Pmax Temperature Regulation Vo (Peak) +/- 2% Po < Pmax Ripple Vo (@120 Hz) (@ 100 kHz) 1.75 V p:p 0.25 V p:p For Vo = 8V, Ir out 160mA max, Io+Ir 500mA For Vo = 14V, Ir out 70mA max, Io+Ir 285mA For Vo = 24V, Vr not available Output Vr, 3.3 volt (+/- 5%) No-load Consumption 30 mW typical @ Vin=120 VAC Isolation 3000 VAC (meets UL / CSA & EN Product Safety) < 10 uA Short Circuit Protection Continuous, Pin 0.7 w @ Vin = 120 VAC Reliability @ 25 C, MIL HDBK-217F > 500 Khr MTBF Thermal Operating Temperature -30 to +70o C Operating Relative Humidity 0 - 95%, non-condensing Storage Temperature -40 to +105o C Mechanical 1.91 x 1.31 x 0.98 inches [48.5 x 33.3 x 24.9 mm] Safety Safety Compliance UL / EN 60950-1 2nd Ed. (CB Report Available) EMI Emissions EN 55022, Class B, FCC Part 15, Class B BIAS Power Universal Input (85-308 VAC, 50/60Hz) Small Size--2.45 in3 [40.1 cm3] Low no-load input power <30mW Constant power mode, not current limit 3000 VAC Isolation Up to 75% efficiency EN 55022, Class B; FCC Part 15, Class B Meets UL/CSA and EN Product Safety (ITE) Bias Power AC/DC power supplies are designed to be applied in two major categories of applications... Auxiliary, where the Bias supply is one of two or more supplies and provides power for standby, housekeeping, biasing or other requirements. Generally, these supply 3.3V or 5.0V requirements from the Vr output. In some cases a small amount of Vo power is used. The characteristics of the Vo and Vr outputs are different and each has application-specific benefits which can provide high value to the system designer. For Vo = 8V, Ir out 250mA max, Io+Ir 500mA For Vo = 14V, Ir out 83mA max, Io+Ir 285mA For Vo = 24V, Vr not available Package Size (L x W x H) * * * * * * * * Second is as a main or utility supply where Bias is the only supply and provides all power necessary for the product or system. Both Vr and Vo supplies are often utilized for optimum system performance. Output Vr, 5.0 volt (+/- 5%) Earth Leakage @ 120 VAC Features Vo is a voltage-regulated output which has a constant power mode instead of a conventional current limit. This output is best suited to drive mechanical relays, solenoids, SSRs, capacitive loads, indicating lights, LEDs and as a source for isolated DC utility power which may be used directly or post-regulated with either a linear regulator or a DC/DC converter. Vo is self protecting, cannot be overloaded and can be shorted indefinitely. The graceful transition from voltage regulation to constant power along with the wide range of product ratings, allows the designer to select a supply tightly matched to the design load. There is no need to oversize a Bias Power supply. Unlike designyour-own, or partially complete modules where significant design margin is required, to stay far away from current limit, Bias's constant power alternative requires no such over-spec'ing. Vr is also a voltage-regulated output and is thermally protected from overload. It has very low output ripple capable of driving microprocessors , logic, transceivers, sensors and other elements which require a low-noise, tightly-regulated supply. In addition, Vr is supplied internally by Vo. This means that any capacitance added to Vo can increase the hold-up time of Vr as well. *Note: maximum currents specified for constant voltage range only. See V-I curve on page 2 for Vo in constant power range. BPW 4 Series Data Sheet, Page 1 of 3 Revised 08/22/2011 Specifications subject to change www.biaspower.com BIAS Power Supply Module BPW 4 Series Data Sheet Single (Vo) or Dual (Vo & Vr) output BPW 4-08-00, -08-33, -08-50 BPW 4-14-00, -14-33, -14-50 BPW 4-24-00 No Load Pow e r VS Input Voltage V - I, typical 12.00 130 10.00 Vo, volts 110 90 70 50 Constant Power Region 8.00 6.00 4.00 2.00 30 0.00 10 85 110 135 160 185 210 235 0 260 200 400 600 800 1,000 1,200 1,400 1,600 Io, mA Input Voltage (Vac) EMI, Conducted, dBV EMI, Radiated Signal Strength, typical, dBV/m Vo, volts f or 8, 14, 24 Input Power (mW) 150 BIAS Power Output Regulation, Vo 24 22 20 18 16 14 12 10 8 6 100% Load 50% Load 25% Load 0 8.3 BPW 4 Series Data Sheet, Page 2 of 3 Revised 08/22/2011 Specifications subject to change 16.6 24.9 33.2 Time, mSec www.biaspower.com 41.5 49.8 BIAS Power Supply Module BPW 4 Series Data Sheet Single (Vo) or Dual (Vo & Vr) output BPW 4-08-00, -08-33, -08-50 BPW 4-14-00, -14-33, -14-50 BPW 4-24-00 Part Number Designation Part Number Output Configuration Vo Vr BPW 4-08-00 Single output 8 VDC N/A BPW 4-08-33 Dual Output 8 VDC 3.3 VDC BPW 4-08-50 Dual Output 8 VDC 5.0 VDC BPW 4-14-00 Single output 14 VDC N/A BPW 4-14-33 Dual Output 14 VDC 3.3 VDC BPW 4-14-50 Dual Output 14 VDC 5.0 VDC BPW 4-24-00 Single Output 24 VDC N/A For custom configurations, contact BIAS Power Pin Description L1 Input High L2 Input Low N/C No Connection Vo Output GND Ground Vr Vr Output N/C No Connection Isolation, bottom view Recommended Land Pattern, top view NOTES 1. Pins 0.031" [0.787 mm] round 2. Pins extend 0.125" [3.175 mm] below stand-offs BIAS Power BPW 4 Series Data Sheet, Page 3 of 3 Revised 08/22/2011 Specifications subject to change www.biaspower.com Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: BIAS Power: BPW 4-05-00 BPW 4-05-33 BPW 4-08-00 BPW 4-08-33 BPW 4-08-50 BPW 4-12-00 BPW 4-12-33 BPW 4-12-50 BPW 4-14-00 BPW 4-14-33 BPW 4-14-50 BPW 4-24-00 BPW 4-24-33 BPW 4-24-50