CHEMTRONICS TDS # 1015 Technical Data Sheet Ultrajet 70 PRODUCT DESCRIPTION Ultrajet 70 is an economical general-purpose duster with a new BIGGER blast for electronic applications. Its exceptional purity jet instantly cleans surfaces free of particulate contamination. Ultrajet 70 is engineered to remove dirt, dust, oxide particles and other airborne particles instantly, and can be used to facilitate the accelerated drying of solvent cleaners. Filtered to 0.2 microns Ozone safe; CFC and HCFC free Nonflammable; may be used on energized equipment Nonabrasive; safe for most materials. Will not scratch surfaces No residue Cleans hard to reach areas TYPICAL APPLICATIONS Ultrajet 70 is used in a wide range of applications including: Audio/Video Equipment Fax Machines Keyboards Laboratory Instruments Microcomputers Photo Equipment Printers TYPICAL PRODUCT DATA AND PHYSICAL PROPERTIES Boiling Point -15.7F 3.18 Vapor Density (air=1) @ 77F 0.10% by weight Solubility in Water @ 77F F/1 atm 1.21 Specific Gravity (water = 1 @77F) Evaporation Rate (butyl acetate=1) Appearance Odor >1 Clear, Colorless Gas Slight Ethereal Surface Tension (dynes/cm @77F) 7.8 Flash Point (TCC) None Shelflife 5 years COMPATIBILITY Ultrajet 70 is generally compatible with most materials used in printed circuit board fabrication, including sensitive plastics and compounds. As with any duster/cleaner, compatibility must be determined on a noncritical area prior to use. Material Buna-N Graphite HDPE LDPE Lexan Neoprene Cross-Linked PE Polyacrylate Polystyrene PVC Silicone Rubber Teflon Viton TECHNICAL & APPLICATION ASSISTANCE Chemtronics provides a technical hotline to answer your technical and application related questions. The toll free number is: 1-800-TECH-401. Compatibility Excellent Excellent Excellent Excellent Excellent Excellent Excellent Excellent Excellent Excellent Excellent Excellent Excellent ENVIRONMENTAL IMPACT DATA ENVIRONMENTAL IMPACT DATA CFC HCFC CL Solv. VOC HFC ODP 0.0% 100.0% 0.0 CFC, HCFC, CL. SOLV., VOC, and HFC numbers shown are the content by weight. Ozone depletion potential (ODP) is determined in accordance with the Montreal Protocol and U.S. Clean Air Act of 1990. The ODP of this product is 0.0. It is the sum of the ODP of the substances that may contribute to the depletion of stratospheric ozone, based upon the weight of each substance in the product's formulation. PERFORMANCE Pressure PSIG / Temperature F 200 P S I G 0.0% 0.0% 0.0% 150 100 50 NOTE: 0 20 40 60 80 Temperature F 100 120 140 USAGE INSTRUCTIONS For industrial use only. Read MSDS carefully prior to use. No special surface preparation is required prior to using Ultrajet 70. Direct high pressure spray onto the area to be cleaned to remove dust, dirt and other contaminant. For optimum performance and pin point control, use with the attached extension tube. AVAILABILITY ES1015 10 oz. Aerosol This information is believed to be accurate. It is intended for professional end users having the skills to evaluate and use the data properly. CHEMTRONICS does not guarantee the accuracy of the data and assumes no liability in connection with damages incurred while using it. CHEMTRONICS 8125 COBB CENTER DRIVE KENNESAW, GA 30152 REV. F (08/13) 1-770-424-4888 DISTRIBUTED BY: