SURFACE MOUNT DISPLAY APSC03-41MBWA BLUE Features Description !0.3 INCH The Blue source color devices are made with GaN on SiC !LOW DIGIT HEIGHT. CURRENT OPERATION. !EXCELLENT Light Emitting Diode. CHARACTER APPEARANCE. Static electricity and surge damage the LEDS. It is !I.C. COMPATIBLE. recommended to use a wrist band or anti-electrostatic glove !MECHANICALLY when handling the LEDs. !GRAY RUGGED. FACE,WHITE SEGMENT. All devices, equipment and machinery must be electrically !PACKAGE : 1100PCS / REEL. grounded. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. SPEC NO: DSAB2954 APPROVED : J. Lu REV NO: V.1 CHECKED :Joe Lee D DATE: MAY/19/2002 DRAWN:L.ZHANG PAGE: 1 OF 5 Selection Guide P ar t N o . Dic e APSC03-41MBWA Iv (m c d ) @ 10 m A L en s Ty p e BLUE(GaN) WHITE DIFFUSED Min . Ty p . 1.9 5 D es c r i p t i o n Common Cathode,Rt. Hand Decimal Electrical / Optical Characteristics at T)=25C Sy m b o l Par am et er D ev i c e peak Peak Wavelength Blue D Dominate Wavelength 1/2 Ty p . Max . Un it s Tes t Co n d it io n s 430 nm I F =20mA Blue 466 nm I F =20mA Spectral Line Half-width Blue 60 nm I F =20mA C Capacitance Blue 100 pF VF=0V;f=1MHz VF Forward Voltage Blue 3.8 4.5 V I F =20mA IR Reverse Current Blue 10 uA V R = 5V Absolute Maximum Ratings at T)=25C P ar am e t e r B lu e Un it s Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA Reverse Voltage 5 V Operating Temperature -40C To +85C Storage Temperature -40C To +85C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAB2954 APPROVED : J. Lu REV NO: V.1 CHECKED :Joe Lee DATE: MAY/19/2002 DRAWN:L.ZHANG PAGE: 2 OF 5 Blue APSC03-41MBWA SPEC NO: DSAB2954 APPROVED : J. Lu REV NO: V.1 CHECKED :Joe Lee DATE: MAY/19/2002 DRAWN:L.ZHANG PAGE: 3 OF 5 APSC03-41MBWA SMT Reflow Soldering Instruction Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) SPEC NO: DSAB2954 APPROVED : J. Lu REV NO: V.1 CHECKED :Joe Lee DATE: MAY/19/2002 DRAWN:L.ZHANG PAGE: 4 OF 5 Tape Specification (Units : mm) SPEC NO: DSAB2954 APPROVED : J. Lu REV NO: V.1 CHECKED :Joe Lee DATE: MAY/19/2002 DRAWN:L.ZHANG PAGE: 5 OF 5