4. SPECIFICATIONS FOR EACH SERIES Conductive polymer type SVPC Series Large capacitance, low ESR Marking : Polarity( ), Rated voltage (Purple) PC(B6, C6), SVPC(E7, E12), Rated capacitance, Lot.No. Specifications Conditions Items Category temperature range Tolerance on rated capacitance Tangent of loss angle Leakage current 1 ESR Characteristics of impedance ratio at high temp. and low temp. Characteristics -55C to +105C M: 20% 120Hz Less than or equal to the value of Table3 120Hz Less than or equal to the value of Table3 After 2 minutes Less than or equal to the value of Table3 Z / Z 20C -55C 0.75 to 1.25 Based the value at +105C 0.75 to 1.25 Z / Z 20C 100KHz+20C C/C Within 20% tan 1.5 times or less than an initial standard 105C, 2,000h, Rated Endurance ESR 1.5 times or less than an initial standard voltage applied Leakage current Below an initial standard C/C Within 20% 60C, 90 to 95%RH, tan 1.5 times or less than an initial standard Damp heat (Steady state) 1,000h, ESR 1.5 times or less than an initial standard No-applied voltage Leakage current Below an initial standard (after voltage processing) Within 10% (15% for 2.5V) C/C 1.3 times or less than an initial standard Resistance to tan 2 (VPS) (230C X 75s) 1.3 times or less than an initial standard soldering heat ESR Leakage current Below an initial standard (after voltage processing) 1 In case of some problems for measured values, measure after applying rated voltage for 120 minutes at 105C . 2 Refer to Page 56 for reflow soldering conditions. (unit : mm) Dimensions 0.2max. Size Code D0.5 B6 C6 E7 E12 F12 5.0 6.3 8.0 8.0 10.0 L P C H W D Specificationsfor eachseries The SVPC series capacitor has larger capacitance than SVPA series. Adopt this series to reduce the size of equipment and circuits. This product can support lead free-reflow. (2). R Size List RV : Rated voltage (SV) : Surge (room temperature) RV SV F 39 68 100 120 150 180 220 270 330 390 560 680 820 1200 1500 2700 2.5 3.3 4 5.2 6.3 8.2 10.0 16.0 11.5 18.4 B6 B6 C6 B6 C6 E7 B6 B6 C6 E7 C6 C6 E7 E7,E12 E7 E12 E12 F12 E12 E12 E12 For the minimum packing quantity, please refer to page 55. 22 +0.1 L W0.2 H0.2 C0.2 -0.4 5.9 5.9 6.9 11.9 12.6 5.3 6.6 8.3 8.3 10.3 5.3 6.6 8.3 8.3 10.3 6.0 7.3 9.0 9.0 11.0 R P0.2 0.6 to 0.8 0.6 to 0.8 0.6 to 0.8 0.8 to 1.1 0.8 to 1.1 1.4 2.1 3.2 3.2 4.6 4. SPECIFICATIONS FOR EACH SERIES Table3 SVPC Series Characteristics List Size Code Rated Voltage (V) Part Number 1 Rated Capacitance (F) ESR (m) (max.) 100kHz Rated ripple current Tangent of loss angle (max.) Leakage current (A) (max.)2 300kHz 3 100kHz (mArms) at 105C 16SVPC39M 16 39 35 30 1820 0.12 300 10SVPC68M 10 68 30 26 1970 0.12 300 6.3 100 30 26 1970 0.12 300 6SVPC100MY 6.3 100 25 21 2150 0.12 300 4SVPC150M 4 150 30 26 1970 0.12 300 4SVPC150MY 4 150 23 20 2240 0.12 300 2R5SVPC180M 2.5 180 30 26 1970 0.12 300 2R5SVPC180MY 2.5 180 24 20 2200 0.12 300 Specificationsfor eachseries 6SVPC100M B6 C6 E7 E12 F12 1 2 3 16SVPC68M 16 68 30 26 2200 0.12 300 10SVPC120M 10 120 27 23 2320 0.12 300 6SVPC220M 6.3 220 27 23 2320 0.12 300 6SVPC220MV 6.3 220 15 13 3110 0.12 300 4SVPC330M 4 330 27 23 2320 0.12 300 4SVPC330MY 4 330 21 18 2630 0.12 300 2R5SVPC390M 2.5 390 25 22 2410 0.12 300 16SVPC120M 16 120 27 23 2900 0.12 500 10SVPC270M 10 270 22 19 3220 0.12 500 6SVPC390M 6.3 390 22 19 3220 0.12 491 4SVPC560M 4 560 22 19 3220 0.12 500 2R5SVPC680M 2.5 680 20 17 3370 0.12 500 6SVPC820M 6.3 820 12 10 4700 0.15 1033 4SVPC560MX 4 560 9 8 5380 0.15 500 4SVPC1200M 4 1200 12 10 4700 0.15 960 4SVPC1500M 4 1500 12 10 4700 0.15 1200 2R5SVPC820M 2.5 820 9 8 5380 0.15 500 2R5SVPC1500M 2.5 1500 10 9 5150 0.15 750 2R5SVPC2700M 2.5 2700 12 10 5080 0.15 1350 Capacitance tolerance : M 20% After 2 minutes The ESR value in 300kHz is a reference one. c Recommended land pattern dimension of PWB Size a b Code B6 C6 E7 E12 F12 (unit:mm) a 1.4 2.1 2.8 2.8 4.3 b 7.4 9.1 11.1 11.1 13.1 c 1.6 1.6 1.9 1.9 1.9 Frequency coefficient for ripple current Frequency Coefficient 120Hz f 1kHz 0.05 1kHz f 10kHz 0.3 10kHz f 100kHz 0.7 100kHz f 500kHz 1 23