Memory Module Specifications KVR16N11/8 8GB 2Rx8 1G x 64-Bit PC3-12800 CL11 240-Pin DIMM DESCRIPTION This document describes ValueRAM's 1G x 64-bit (8GB) DDR31600 CL11 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: FEATURES SPECIFICATIONS CL(IDD) 11 cycles Row Cycle Time (tRCmin) 48.125ns(min.) Refresh to Active/Refresh Command Time (tRFCmin) 260ns(min.) Row Active Time (tRASmin) 35ns(min.) Maximum Operating Power TBD W* UL Rating 94 V - 0 Operating Temperature 0o C to +85o C Storage Temperature -55o C to +100o C * JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply *Power will vary depending on the SDRAM used. * VDDQ = 1.5V (1.425V ~ 1.575V) * 800MHz fCK for 1600Mb/sec/pin * 8 independent internal banks * Programmable CAS latency: 11, 10, 9, 8, 7, 6 * Programmable Additive Latency: 0, CL - 2, or CL - 1 clock * 8-bit pre-fetch * Burst Length: 8 (interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS) * Bi-directional Differential Data Strobe * Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm 1%) * On Die Termination using ODT pin * Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C * Asynchronous Reset * PCB: Height 0.740" (18.75mm) or 1.180" (30.00mm) Important Information: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here. Continued >> kingston.com Document No. VALUERAM1445-001.C00 12/18/15 Page 1 MODULE DIMENSIONS kingston.com Document No. VALUERAM1445-001.C00 Page 2