SURFACE MOUNT ALUMINUM ELECTROLYTIC CAPACITORS NEW type, Low Impedance CK Chip Series Low Impedance Solvent Proof Chip type, low impedance temperature range up to 105 C Designed for surface mounting on high density PC board Applicable to automatic insertion machine using carrier tape Item Characteristics Operating temperature range Leakage current max. Capacitance tolerance -55 ~ +105 C I = 0.01CV or 3 A whichever is greater (after 2 minutes) 20% at 120Hz, 20 C WV tan Dissipation factor max. (at 120Hz, 20 C) 6.3 0.24 10 0.19 6.3 2 3 WV Z-25 C/Z+20 C Z-55 C/Z+20 C Low temperature characteristics (Impedance ratio at 120Hz) 16 0.16 10 2 3 25 0.14 16 2 3 35 0.12 50 0.12 35 2 3 50 2 3 25 2 3 Less than specified value Leakage current Within 20% of initial value Capacitance change Less than 200% of specified value tan 4, 5 and 6.3 products are for 1000 hours Load life (after application of the rated voltage for 2000 hours at 105 C) After 1000 hours no load test, leakage current, capacitance and tan are same as load life value. The following specifications shall be satisfied when the capacitors are restored to 20 C after exposing them at 250 C for 30 seconds. Less than specified value Leakage current Within 10% of initial value Capacitance change Less than specified value tan Shelf life (at 105 C) Resistance to soldering heat Unit : mm DRAWING 4, 5, 6.3 ) Positive W E 0.2 5.8 0.3 Voltage mark for 6.3V is 6 8 B 0.2 Voltage D 0.5 47 6K Lot No. C 0.2 0.2 0.3 max. Series Code 0.4 max. Plastic plateform Capacitance Negative 0.5 0.8 D 4 5 6.3 8 6.2 B 4.3 5.3 6.6 8.3 W 4.8 6.0 7.1 3.3 C 4.3 5.3 6.6 8.3 E 1.0 1.4 2.2 2.3 6.2 (See the page 41) DIMENSIONS & MAXIMUM PERMISSIBLE RIPPLE CURRENT WV F 1 1.5 2.2 3.3 4.7 6.8 10 15 22 33 47 68 100 150 220 330 6.3 4 5 5 6.3 6.3 6.3 6.3 8 1.8 0.76 0.76 0.44 0.44 0.44 0.44 0.26 10 80 150 150 230 230 230 230 280 4 4 4 5 6.3 6.3 6.3 6.3 8 1.8 1.8 1.8 0.76 0.44 0.44 0.44 0.44 0.29 16 80 80 80 150 230 230 230 230 280 4 4 5 6.3 6.3 6.3 6.3 8 1.8 1.8 0.76 0.44 0.44 0.44 0.44 0.29 25 80 80 150 230 230 230 230 280 4 4 4 5 5 6.3 6.3 6.3 8 1.8 1.8 1.8 0.76 0.76 0.44 0.44 0.44 0.29 35 50 4 60 5 80 5 115 5 140 5 230 6.3 230 6.3 230 8 280 1.8 0.76 0.76 0.76 0.76 0.44 0.44 0.29 50 80 150 150 150 150 230 230 280 Ripple current (mA rms) at 105 C, 100kHz Impedance () at 20C, 100kHz Case size D X L(mm) 4 4 4 4 5 5 6.3 6.3 6.3 8 8 5.0 5.0 5.0 5.0 1.52 1.52 0.88 0.88 0.88 0.68 0.68 30 30 30 30 85 85 165 165 165 185 185