Tools for crimp contacts Tools for crimp termination - D-Sub-S, D-Sub-HD, DIN 41 612 Identification Part No. for high density contacts Service crimp tool for single D-Sub standard contacts 09 99 000 0175 for single D-Sub high density contacts 09 99 000 0535 for standard contacts HARTINGCrimp tool for 500 bandoliered D-Sub standard contacts 09 99 000 0169 for 500 bandoliered D-Sub high density contacts 09 99 000 0597 HARTINGSemi-automatic crimping device Main drive foot-operated 220 V / 50 Hz 09 99 000 0246 Wire gauge Crimping head for bandoliered D-Sub standard contacts 09 99 000 0253 0.09-0.56 mm (AWG 28-20) for DIN 41 612 contacts, types BC / har-bus(R) 64 09 99 000 0252 0.09 - 0.5 mm FC 1 FC 2 FC 3 09 99 000 0249 09 99 000 0250 09 99 000 0251 0.09 - 0.25 mm 0.14 - 0.56 mm 0.5 - 1.5 mm BC / har-bus(R) 64 09 99 000 0628 0.13 mm (solid wire) Reel holder for 10 000 contacts 09 99 000 0158 Tooling Insertion and removal tool for single D-Sub standard contacts 09 99 000 0171 for single D-Sub high density contacts 09 99 000 0513 Assembly of crimp contacts After crimping the stranded wire to the contact using a hand tool or automatic crimping device, insert the contact into the chamber with the tool, working from the wiring side. You will h ear the contacts snap home and to check that they are s ecurely in place, give the wire a gentle pull. Removing crimp contacts Position the tool from the wiring side as shown in the diagram below and insert into the contact chamber. The contact can then easily be removed from the wiring side together with the wire itself and reinserted in a different chamber. The tool is designed for a maximum insulation diameter of O 1.7 mm. 20 16 Tool Stripping length: 2.5 + 0.5 mm