Product Data Sheet TC-210 (Z5) Series TCXOs Temperature Compensated Crystal Oscillators Features Frequency from 0.5 to 160 MHz Stability as tight as 0.28 ppm Aging to <3.5 ppm for ten years Package: 29.21 x 25.40 x 10.03mm (1.15x 1.0x 0.395) 3.3 Vdc or 5 Vdc operation All outputs available (TTL, HCMOS, PECL, SINEWAVE) Stratum 3 Applications SONET/SDH Network Timing Sources DWDM / FDM / ATM Wireless Communications VSAT, LMDS, WLL Vectron International has introduced a series of surface mount, Temperature Compensated Crystal Oscillators (TCXO s) available in frequencies from 0.5 to 160 MHz. Model Z5 surface mount TCXOs can be mounted using the standard convection reflow process. The units can meet the 0.37 ppm Holdover requirement of G R - 1 2 4 4 - C O R E Ta b l e 3 - 1 f r o m 0 C t o + 7 0 C temperature range and operate from a 3.3V or 5V supply. Current drain to lower than 2 mA is available upon request. Aging <3.5 ppm for ten years. Phase noise is -115 dBc/Hz at 100 Hz and -155 dBc/Hz at 100k Hz at 10 MHz. These units are ideal for Stratum 3 applications. For additional Stratum 3 solutions please visit our website at: www.stratum3.com Standard Frequencies: Package: Supply Voltage (Vdd): (Other options are available upon request) Current Draw: Output Options: Standard Stability Options: Note: Other stability options are available. Contact the factory for assistance. 10.00, 12.80, 16.384, 19.44, 20.00, 38.88, 40.00, 77.76, 155.52 MHz, Available from 0.5 MHz to 160 MHz 210 = 29.21 x 25.40 x 10.03 mm (1.15x 1.00x 0.395) (See page 3) C = 5 Vdc 5% D = 3.3 Vdc 5% Current draw will vary greatly depending on frequency and output type. For this series TCXO typical current draw will be about 15 mA and depending on output type may be less than 2 mA. Please consult the factory about your exact current requirements. A B F G = = = = HCMOS / ACMOS 10 TTL Complementary PECL 0 dBm / 50 ohm B-307 = 3.0 x 10-7 * B-ST3 = Stratum 3 * C-ST3 = Stratum 3-7 C-507 = 5.0 x 10 F-106 = 1.0 x 10-6 over over over over over 0.5 0.5 35 5.0 to to to to 160 MHz 160 MHz 160 MHz 100 MHz 0C to +50C 0C to +50C 0C to +70C 0C to +70C -40C to +85C * STRATUM 3 per GR-1244-CORE Table 3-1 Total Stability: Vs Holdover: Stability vs Supply: Aging (typical): Electrical Frequency Adjust: Phase Noise (Typical): 10 MHz <4.6 x 10-6 for all causes & 10 years <3.7 x 10-7 for all causes and 24 Hours (Available in Temperature Ranges B & C) <0.1 ppm for a 5% change in Supply Voltage <3.5 ppm for ten years @ +70C 5 ppm minimum via external voltage, 0 to Vdd Offset 100 Hz 1k Hz 10k Hz 100k Hz Phase Noise -115 dBc/Hz -145 dBc/Hz -150 dBc/Hz -155 dBc/Hz For HCMOS / ACMOS / TTL & PECL outputs with frequencies above 35 MHz a low phase noise PLL multiplier may be used. Please inform that factory of your phase noise requirements. Vectron International 267 Lowell Road, Hudson, NH 03051 1.143R (.045R) 2.54 (.100) 2.54 (.100) 5 places 25.40 (1.00) 29.21 (1.15) 10.16 (0.4) 20.574 (0.81) 10.033 (in.) (0.395) 2.54 (.100) 6.35 (.250) 13.97 25.4 (.550) (1.00) 20.32 (.800) 2.54 3.048 SQ (.120 (.100) SQ ) Vectron International 267 Lowell Road, Hudson, NH 03051 pre-heating 60 to 90 sec. a t 1 5 0 C to 170C reflow 20 to 40 sec. a t > 2 0 0 C Note: TCXO s are precision subsystems with tolerances measured to 0.01 ppm. Non-Hermetically sealed TCXO s should not be subjected to a wash process that will immerse the TCXO in solvents. NO CLEAN is the recommended procedure. The Z5 series of TCXO s has been designed for pick and place reflow soldering. The suggested reflow profile is shown above. The TCXO may be reflowed once, and should not be reflowed in the inverted position. Typical frequency shift as a result of reflow is <1.0 ppm per reflow. Vectron International 267 Lowell Road, Hudson, NH 03051 Vdd Vdd 50 .01F .01F Vdd +3 Vdc +3 Vdc .01F DUT PROBE OUT CL DUT OUT 51 PROBE Q DUT RL Q 50 Ohm Sinewave Standard CMOS 51 50 COAX (G) PECL (F) (A) TC- 210 - X X X - X X X A Supply Voltage C = 5 Vdc +/-5% D = 3.3 Vdc +/-5% - MHz Output Frequency 0.5 to 160 MHz Other Options A = Standard, No Options (Default) Output Type A = HCMOS / ACMOS B = 10 TTL F = Comp. PECL G = 0 dBm / 50 ohm Temperature & Stability B-307 = 3.0 x 10-7 B-ST3 = Stratum 3 C-ST3 = Stratum 3 C-507 = 5.0 x 10-7 F-106 = 1.0 x 10-6 Example: over 0C to +50C over 0C to +50C over 0C to +70C over 0C to +70C over -40C to +85C Note: Other stabilities are available upon request TC-210-DAC-507A - 10 MHz This is a 10 MHz Z5 series TCXO in our 210 package configuration, 3.3 Vdc supply, HCMOS / ACMOS output, with a Temp stability of 5.0 x 10-7 over 0C to +70C. USA: 267 Lowell Road, Hudson, NH 03051 . . . . . . . . . . . . . . . . . . . . . .Tel: 1-88-VECTRON-1, FAX: 1-888-FAX-VECTRON EUROPE: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. .Tel: 49 (0) 3328 4784 17 Fax: 49 (0) 3328 4784 30*ASIA: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Tel: +86 21 28909740 / 41 /42 Fax: +86 21 28909240 / 2890999 www.vectron.com 081902 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Vectron: TC-210-DFF-106A-27.00MHZ