DESCRIPTION
HyperX HX318C10FW/4 is a 512M x 64-bit (4GB) DDR3-1866
CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module,
based on eight 512M x 8-bit DDR3 FBGA components. This
module has been tested to run at DDR3-1866 at a low latency
timing of 10-11-10 at 1.5V. Additional timing parameters are
shown in the PnP Timing Parameters section below. The
JEDEC standard electrical and mechanical specifications are
as follows:
Document No. 4807032-001.B00 04/23/15 Page 1
SPECIFICATIONS
selcyc 01)DDI(LC
Row Cycle Time (tRCmin) 44.75ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 32.125ns (min.)
Maximum Operating Power TBD W*
0 - V 49gnitaR LU
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.
FEATURES
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
933MHz fCK for 1866Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 13, 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95 ° C
Asynchronous Reset
Height 1.291” (32.80mm) w/heatsink, single sided
component
HX318C10FW/4
4GB 512M x 64-Bit DDR3-1866
CL10 240-Pin DIMM
Continued >>
kingston.com/hyperx
PnP JEDEC TIMING PARAMETERS:
DDR3-1866 CL10-11-10 @1.5V
DDR3-1600 CL9-10-9 @1.5V
DDR3-1333 CL8-9-8 @1.5V
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
Document No. 4807032-001.B00 Page 2
continued HyperX
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX
kingston.com/hyperx
7.08 mm
133.35 mm
32.8 mm
MODULE DIMENSIONS
MODULE WITH HEAT SPREADER