Users should evaluate the suitability of this product for their application. Specications are subject to change without notice.
Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specication, without notication to Buyer.
1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER,
AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: “901/902...” MAY BE REPLACED BY “Axxx”.) OTHER CODES AND
SUFFIXES MAY BE ADDED TO THE PART NUMBER AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER.
Page 1 of 1
The TE logo, Tyco Electronics and Raychem are trademarks. Raychem Wire & Cable
501 Oakside Avenue
Redwood City, CA 94063-3800
Phone: 1-800-227-8816
Fax: 1-650-361-6297
DIMENSIONS ARE IN INCHES, AND UNLESS OTHERWISE DESIGNATED ARE NOMINAL
THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN.
REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID.
© 2009 Tyco Electronics Corporation. All rights reserved.
COMPONENT WIRES - 55A0812
NOTE: Nominal values are for information only.
Nominal values are not requirements.
SPECIFICATION CONTROL DRAWING 55A0832
THREE CONDUCTOR CABLE, UNSHIELDED, UNJACKETED, GENERAL PURPOSE, 600 VOLT 10-26-09 D
This specication sheet forms a part of the latest issue of Raychem Specication 55A.
TITLE Date Revision
CABLE CONSTRUCTION DETAILS
PART NUMBER
1/
CONDUCTOR
SIZE
(AWG)
OUTSIDE DIAMETER
(inches) MAXIMUM
WEIGHT
(lbs/1000 ft.)
NOMINAL MAXIMUM
55A0832-26-* 26 .086 .091 5.2
55A0832-24-* 24 .097 .102 7.0
55A0832-22-* 22 .108 .112 9.8
55A0832-20-* 20 .125 .130 14.4
55A0832-18-* 18 .151 .158 22.0
55A0832-16-* 16 .166 .173 27.5
55A0832-14-* 14 .203 .210 42.2
55A0832-12-* 12 .240 .246 62.7
55A0832-10-* 10 .289 .298 99.1
55A0832-8-* 8 .421 .438 189.
55A0832-6-* 6 .521 .542 289.
55A0832-4-* 4 .670 .691 483.
CABLE RATINGS AND ADDITIONAL REQUIREMENTS
TEMPERATURE RATING: 200°C
Maximum continuous conductor temperature
VOLTAGE RATING: 600 volts (rms) at sea level
INSULATION FLAWS:
Spark Test, 5.7 kV (rms) at 3 kHz
Impulse Dielectric Test, 8.0 kV (peak)
PART NUMBER:
The “*” in the part numbers above shall be replaced by color
code designators with a slash separating the component wire
colors. Colors shown do not necessarily reect the sequence
of manufacturing.
1/ Example: AWG 22, black, brown and red component wires:
55A0832-22-0/1/2
