TL074 LINEAR INTEGRATED CIRCUIT
1
LOW NOISE QUAD J-FET
OPERATIONAL AMPLIFIER
DESCRIPTION
The Contek TL074 is a high speed J- FET input quad
operational amplifier. It incorporates well matched ,
high voltage J- FET and bipolar transistors in a
monolithic integrated circuit. The device features high
slew rates, low input bias and offset current, and low
offset voltage temperature coefficient.
FEATURES
*Low power consumption
*Wide common-mode (up to vcc+) and differential
voltage range
*Low input bias and offset current
*Low noise en= 15nV / Hz(typ)
*Output short-circuit protection
*High input impedance J-FET input stage
*Low harmonic distortion:0.01%(typ)
*Internal frequency compensation
*Latch up free operation
*High slewrate:13V/ms(typ)
DIP-14
SOP-14
PIN CONFIGURATIONS
Contek
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
TL074 LINEAR INTEGRATED CIRCUIT
2
SCHEMATIC DIAGRAM
ABSOLUTE MAXIMUM RATINGS(Ta=25 C )
PARAMETER SYMBOL VALUE UNIT
Supply Voltage (note 1) Vcc +-18 V
Input Voltage (note 2) Vi +-15 V
Differential Input Voltage (note 3) Vid +-30 V
Power Dissipation Ptot 680 mW
Output Short-Circuit Duration (Note 4) Infinite
Operating Free Air Temperature Toper 0 to 70 C
Storage Temperature Tstg 5 to 150 C
NOTES: 1. All voltage values, except differential voltage, are with respect to the zero reference level (ground) of
the supply voltages where the zero reference level is the midpoint between Vcc- and Vcc+.
2. The magnitude of the input voltage must never exceed the magnitude of the supply voltage or 15 volts,
whichever is less.
3. Differential voltages are at the non-i nverting input terminal with respect to the inverting input terminal.
4. The output may be shorted to ground or to either supply. Temperature and/or supply voltages must be
limited to ensure that the dissipation rating is not exceeded.
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
TL074 LINEAR INTEGRATED CIRCUIT
3
Contek TL074C ELECTRICAL CHARACTERISTICS( Vcc=+-15V, Ta=25 C,unless otherwise
specified)
PARAMETER SYMBOL MIN TYP MAX UNIT
Input Offset Voltage(Rs=50 W), Ta=25 C
Tmin<=Ta<=Tmax
Vio
310
13
mV
Temperature Coefficient of Input Offset
Voltage
Dvio 10 V/
Input Offset Current*
Ta=25 C
Tmin<=Ta<=Tmax
Iio
5 100
10
pA
nA
Input Bias Current*
Ta=25 C
Tmin<=Ta<=Tmax
Iib
30 200
20
pA
nA
Input Common Mode Voltage Vicm +-11 -12~+15 V
Output Voltage Swing(RL=10kW)
Ta=25 C, RL=2kW,
Ta=25 C, RL=10kW
Tmin<=Ta<=Tmax, RL=2kW
Tmin<=Ta<=Tmax, RL=10kW
Vopp
10
12
10
12
12
13.5
V
Large Signal Voltage Gain(RL=2kW, Vo=+-
10V) Ta=25 C
Tmin<=Ta<=Tmax
Avd
25
15
200 V/mV
Gain Bandwidth Product(Ta=25 C, RL=10kW,
f=100kHz, Vin=10mV, CL=100pF)
GBP 2 3 MHz
Input Resistance Ri 1012 W
Common Mode Rejection Ratio(RS=50W)
Ta=25 C
Tmin<=Ta<=Tmax
CMR
70
70
86
dB
Supply Voltage Rejection Ratio(RS=50W)
Ta=25 C
Tmin<=Ta<=Tmax
SVR
70
70
86
dB
Supply Current( no load)
Ta=25 C
Tmin<=Ta<=Tmax
Icc
1.4 2.5
2.5
mA
Channel Separation(Av=100, Ta=25 C) V01/V02 120 dB
Output Short-circuit Current
Ta=25 C
Tmin<=Ta<=Tmax
Ios
10
10
40 60
60
mA
Slew Rate(Vi=10V, RL=2kW,CL=100pF,
Ta=25 C, unity gain)
SR 8 13 V/ms
Rise Time(Vi=20mV, RL=2kW,CL=100pF,
Ta=25 C, unity gain)
tr0.1 ms
Overshoot Factor(Vi=20mV, RL=2kW,
CL=100pF, Ta=25 C, unity gain)
Kov 10 %
Total Harmonic Distortion(Av=20dB, f=1kHz
RL=2kW,CL=100pF, Ta=25 W, Vo=2Vpp)
THD 0.01 %
Phase Margin 45 Degrees
Equivalent Input Noise Voltage(R S=100W,
f=1KHz)
en15
*The Input bias currents are junction leakage currents, which approximately double for every 10 C increase in the
junction temperature.
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
TL074 LINEAR INTEGRATED CIRCUIT
4
Contek TL074AC ELECTRICAL CHARACTERISTICS( Vcc=+-15V, Ta=25 C,unless otherwise
specified)
PARAMETER SYMBOL MIN TYP MAX UNIT
Input Offset Voltage(Rs=50 W), Ta=25 C
Tmin<=Ta<=Tmax
Vio
36
7
mV
Temperature Coefficient of Input Offset
Voltage(Rs=50W)
Dvio 10 mV/ C
Input Offset Current*
Ta=25 C
Tmin<=Ta<=Tmax
Iio
5 100
4
pA
nA
Input Bias Current*
Ta=25 C
Tmin<=Ta<=Tmax
Iib
20 200
20
pA
nA
Input Common Mode Voltage Vicm +-11 -12~+15 V
Output Voltage Swing(RL=10kW)
Ta=25 C, RL=2kW,
Ta=25 C, RL=10kW
Tmin<=Ta<=Tmax, RL=2kW
Tmin<=Ta<=Tmax, RL=10kW
Vopp
10
12
10
12
12
13.5
V
Large Signal Voltage Gain(RL=10kW, Vo=+-
10V) Ta=25 C
Tmin<=Ta<=Tmax
Avd
50
25
200 V/mV
Gain Bandwidth Product(Ta=25 C, RL=10kW,
CL=100pF)
GBP 2 3 MHz
Input Resistance Ri 1012 W
Common Mode Rejection Ratio(RS=50W)
Ta=25 C
Tmin<=Ta<=Tmax
CMR
80
80
86
dB
Supply Voltage Rejection Ratio(RS=50W)
Ta=25 C
Tmin<=Ta<=Tmax
SVR
80
80
86
dB
Supply Current( no load)
Ta=25 C
Tmin<=Ta<=Tmax
Icc
1.4 2.5
2.5
mA
Channel Separation(Av=100, Ta=25 C) V01/V02 120 dB
Output Short-circuit Current
Ta=25 C
Tmin<=Ta<=Tmax
Ios
10
10
40 60
60
mA
Slew Rate(Vi=10V, RL=2kW,CL=100pF,
Ta=25 C, unity gain)
SR 8 13 V/ms
Rise Time(Vi=20mV, RL=2kW,CL=100pF,
Ta=25 C, unity gain)
tr0.1 ms
Overshoot Factor(Vi=20mV, RL=2kW,
CL=100pF, Ta=25 C, unity gain)
Kov 10 %
Total Harmonic Distortion(Av=20dB, f=1kHz
RL=2kW,CL=100pF, Ta=25 C, Vo=2Vpp)
THD 0.01 %
Phase Margin 45 Degrees
Equivalent Input Noise Voltage(R S=100W,
f=1KHz)
en15
*The Input bias currents are junction leakage currents, which approximately double for every 10 C increase in the
junction temperature.
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
TL074 LINEAR INTEGRATED CIRCUIT
5
Contek TL074BC ELECTRICAL CHARACTERISTICS( Vcc=+-15V, Ta=25 C,unless otherwise
specified)
PARAMETER SYMBOL MIN TYP MAX UNIT
Input Offset Voltage(Rs=50 W), Ta=25 C
Tmin<=Ta<=Tmax
Vio
13
5
mV
Temperature Coefficient of Input Offset
Voltage(Rs=50W)
Dvio 10 V/
Input Offset Current*
Ta=25 C
Tmin<=Ta<=Tmax
Iio
5 100
4
pA
nA
Input Bias Current*
Ta=25 C
Tmin<=Ta<=Tmax
Iib
20 200
20
pA
nA
Input Common Mode Voltage Vicm +-11 -12~+15 V
Output Voltage Swing(RL=10kW)
Ta=25 C, RL=2kW,
Ta=25 C, RL=10kW
Tmin<=Ta<=Tmax, RL=2kW
Tmin<=Ta<=Tmax, RL=10kW
Vopp
10
12
10
12
12
13.5
V
Large Signal Voltage Gain(RL=10kW, Vo=+-
10V) Ta=25 C
Tmin<=Ta<=Tmax
Avd
50
25
200 V/mV
Gain Bandwidth Product(Ta=25 C, RL=10kW,
CL=100pF)
GBP 2 3 MHz
Input Resistance Ri 1012 W
Common Mode Rejection Ratio(RS=50W)
Ta=25 C
Tmin<=Ta<=Tmax
CMR
80
80
86
dB
Supply Voltage Rejection Ratio(RS=50W)
Ta=25 C
Tmin<=Ta<=Tmax
SVR
80
80
86
dB
Supply Current( no load)
Ta=25 C
Tmin<=Ta<=Tmax
Icc
1.4 2.5
2.5
mA
Channel Separation(Av=100, Ta=25 C) V01/V02 120 dB
Output Short-circuit Current
Ta=25 C
Tmin<=Ta<=Tmax
Ios
10
10
40 60
60
mA
Slew Rate(Vi=10V, RL=2kW,CL=100pF,
Ta=25 C, unity gain)
SR 8 13 V/ms
Rise Time(Vi=20mV, RL=2kW,CL=100pF,
Ta=25 C, unity gain)
tr0.1 ms
Overshoot Factor(Vi=20mV, RL=2kW,
CL=100pF, Ta=25 C, unity gain)
Kov 10 %
Total Harmonic Distortion(Av=20dB, f=1kHz
RL=2kW,CL=100pF, Ta=25 C, Vo=2Vpp)
THD 0.01 %
Phase Margin 45 Degrees
Equivalent Input Noise Voltage(R S=100W,
f=1KHz)
en15
*The Input bias currents are junction leakage currents, which approximately double for every 10 C increase in the
junction temperature.
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
TL074 LINEAR INTEGRATED CIRCUIT
6
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
TL074 LINEAR INTEGRATED CIRCUIT
7
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
TL074 LINEAR INTEGRATED CIRCUIT
8
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
TL074 LINEAR INTEGRATED CIRCUIT
9
PARAMETER MEASUREMENT INFORMATION
CONTEK
Contek Microelectronics Co.,Ltd.
http://www.contek-ic.com E-mail:sales@contek-ic.com
