formerly RI-03 Series Dry Reed Switch RI-03 Series Micro dry-reed switch hermetically sealed in a gas-filled envelope. Singlepole, single-throw (SPST) type, having normally open contacts, and containing two magnetically actuated reeds. The switch is of the double-ended type and may be actuated by an electromagnet, a permanent magnet or a combination of both. The device is intended for use in sensors, relays, pulse counters or similar devices. RI-03 Series Features Ideal for general purpose reed relays and sensors. Contact layers: ruthenium on gold Superior glass-to-metal seal and blade alignment RoHS Compliant Dimensions for RI-03 Series 0.906 0.020 (23.0 0.5) tinned 0.100 max (O2.54) 0.024 max (O0.60) 0.570 max (14.5) 1.811 0.020 (46.0 0.5) All Dimension in inches (mm) nominal General data for all models RI-03 AT-Customization / Performed Leads Besides the standard models, customized products can also be supplied offering the following options: * Operate and release ranges to customer specification * Cropped and/or performed leads Coils All characteristics are measured using the Philips Standard Coil. For definitions of the Philips Standard Coil, refer to "Application Notes" in the Reed Switch Technical & Application Information Section of this catalog. Life expectancy and reliability The life expectancy data given below are valid for a coil energized at 1.25 times the published maximum operate value for each type in the RI-03 series. No load conditions (operating frequency: 100Hz) Life expectancy: min. 10 operations with a failure rate of less than 10-9 with a confidence level of 90%. End of life criteria: Contact resistance > 1 after 2 ms 8 Release time > 2 ms (latching or contact sticking). Loaded conditions (resistive load: 12 V; 4 mA; operating frequency: 170Hz) Life expectancy: min. 106 operations with a failure rate of less than 10-8 with a confidence level of 90%. End of life critera: Contact resistance > 2 after 4 ms Release time > 0.7 ms (latching or contact sticking). Switching different loads involves different life expectancy and reliability data. Further information is available on request. Mechanical Data Contact arrangement is normally open; lead finish is tinned; net mass is approximately 190mg; and can be mounted in any position. Shock The switches are tested in accordance with "IEC 68-2-27", test Ea (peak acceleration 150 G, half sinewave; duration 11 ms). Such a shock will not cause an open switch (no magnetic field present) to close, nor a switch kept closed USA Tel: +(1)973 777 6900 / Fax: +(1) 973 777 8405 Belgium Tel: + 32 (0)12 390400 Page 1 of 3 RI-03 Series Dry Reed Switch Technical Specifications Parameters Test Conditions Units RI-03AAA RI-03AA RI-03A RI-03B Operating Characteristics Operate Range AT 6-16 14-23 18-32 28-52 Release Range AT 3-15.5 6-21 7-27 10-36 Operate Time - including Bounce (typ.) ms 0.1 0.25 0.25 0.25 Bounce Time (typ.) ms 0.05 0.15 0.15 0.15 Release Time (max) ms 70 30 30 30 Resonant Frequency (typ.) Hz 5500 5500 5500 5500 Switched Power (max) W 5 10 10 10 Switched Voltage DC (max) V 160 200 200 200 Switched Voltage AC, RMS value (max) V 110 140 140 140 Switched Current DC (max) mA 250 500 500 500 Switched Current AC, RMS value (max) Electrical Characteristics mA 250 500 500 500 Carry Current DC (max) A 1 1.5 2.5 2.5 Breakdown Voltage (min) V 200 250 300 350 Contact Resistance (initial max.) m 120 120 120 120 Contact Resistance (initial typ.) m 70 70 70 70 Contact Capacitance (max) without test coil pF 0.3 0.3 0.25 0.25 Insulation Resistance (min) RH 45% M 106 106 106 106 Welding by an 80 AT coil to open. The leads can be welded. Vibration The switches are tested in accordance with "IEC 68-2-6", test Fc (acceleration 10G; below cross-over-frequency 57 to 62 Hz; amplitude 0.75 mm; frequency range 10 to 2000 Hz; duration 90 minutes.) Such a vibration will not cause an open switch ( no magnetic field present) to close, nor a switch kept closed by an 80 AT coil to open. Mounting The leads should not be bent closer than 1 mm to the glass-to-metal seals. Stress on the seals should be avoided Care must be taken to prevent stray magnetic fields from influencing the operating and measuring conditions. Mechanical Strength The robustness of the terminations is tested in accordance with "IEC 68-2-21", test Ua1 (load 40 N). Operating and Storage Temperature Operating ambient temperature; min: -55C; max: +125C. Storage temperature; min: -55; max: +125C. Note: Temperature excursions up to 150C may be permissible. For more information contact your nearest Comus Group sales office. Soldering The switch can withstand soldering heat in accordance with "IEC 68-2-20", test Tb, method 1B: solder bath at 350 10C for 3.5 0.5 s. Solderability is tested in accordance with "IEC 68-2-20" test Ta, method 3: solder globule temperature 235C; ageing 1b: 4 hours steam. * As part of the company policy of continued product improvement, specifications may change without notice.Our sales office will be pleased to help you with the latest information on this product range and the details of our full design and manufacturing service. All products are supplied to our standard conditions of sale unless otherwise agreed in writing. USA Tel: +(1)973 777 6900 / Fax: +(1) 973 777 8405 Belgium Tel: + 32 (0)12 390400 Page 2 of 3 RI-03 Series Dry Reed Switch Comus International 454 Allwood Road Clifton, New Jersey 07012 U.S.A Tel: (1)973 - 777 - 6900 Fax: (1)973 - 777 - 8405 email: info@comus-intl.com Website: http://www.comus-intl.com Comus Europe Ltd Unit 7, Rice Bridge Industrial Estate Thorpe - Le - Soken Essex, England CO160HL Tel: +44 (0)1255 862236 Fax: +44 (0)1255 862014 email: sales@assemtech.co.uk Website: http://www.assemtech.co.uk ISO 9001:2008 CERTIFICATE NO: 03-12314 ISO 9001:2008 CERTIFICATE NO: FM 21080 Comus Technology BV Jan Campertstraat 11 6416 SG Heerlen The Netherlands Comus Belgium BVBA Overhaamlaan 40 B-3700 Tongeren Belgium Tel: +33 (0)12 390400 Fax: +33 (0)12 235754 email: info@comus.be Website: http://www.comus.be Comus Electronics and Technologies India Private Limited No.3, Kamaraj Nagar 2nd Street Tambaram Sanatorium Chennai 600045 India Tel:+(91)-(44)-43219090 Fax:+(91)-(44)-22628198 email: info@comus-intl.com Website: http://www.comusindia.com Tel: +31(0)45 5439345 Fax: +31(0)45 5427216 email: info@comus-intl.com Website: http://www.dry-reeds.com TAKE A LOOK AT OUR VARIETY OF PRODUCTS Float Switches Acceleration / Shock Switches Movement Sensors Tilt / Tip Switches Reed Relays Solid State Relays High Breakdown Switches Reed Switches Magnets Hybrid Senors Optical Level Alarm / Security Switches Switches Page 3 of 3