18TECHNICAL 18 HEATING DATASHEET www.stego.de | www.stego.co.uk | www.stegonorden.se PRODUCT CATALOGUE - STEGO SEMICONDUCTOR HEATER HG 140 | 15 W to 150 W >>Pressure clamp connectors >>Dynamic heating up >>Wide voltage range >>Energy saving >>Clip fixing >>Quick installation TECHNICAL DATA Operating voltage AC/DC 120 - 240 V (min. 110 V, max. 265 V) Heating element PTC resistor - temperature limiting Heater body extruded aluminium profile, anodised Connection 3 pressure clamps for stranded wire 0.5 - 1.5 mm (with wire end ferrule) and rigid wire 0.5 - 2.5 mm Connection casing plastic according to UL94 V-0, black Mounting clip for 35 mm DIN rail, EN 60715 Fitting position vertical airflow (air outlet up, connection on bottom) Operating/Storage temperature -45 to +70 C (-49 to +158 F) Operating/Storage humidity max. 90 % RH (non-condensing) Protection type/Protection class IP20 / I (earthed) Approvals VDE, UL File No. E150057, EAC Accessoires screw fixing, Art. No. 09024.0-00 (1 packing unit = 2 pieces) Note other voltages on request Operating with voltages below AC/DC 140 V reduces heating performance by approx. 10 %. Art. No. Heating capacity Inrush current max. Recommended pre-fuse T (time-delay) Length (L) Weight (approx.) 14000.0-00 15 W 1.5 A 2.0 A 65 mm 0.3 kg 14001.0-00 30 W 3.0 A 4.0 A 65 mm 0.3 kg 14003.0-00 45 W 3.5 A 4.0 A 65 mm 0.3 kg 14005.0-00 60 W 2.5 A 4.0 A 140 mm 0.4 kg 14006.0-00 75 W 4.0 A 6.3 A 140 mm 0.5 kg 14007.0-00 100 W 4.5 A 8.0 A 140 mm 0.5 kg 14008.0-00 150 W 9.0 A 10.0 A 220 mm 0.7 kg at +20 C (+68 F) ambient temperature 19.03.2019 | Specifications are subject to change without notice. Errors and omissions excepted. Suitability of this product for its intended use and any associated risks must be determined by the end customer/buyer in its final application. These heaters are used in enclosures where damage from condensation must be prevented, or where the temperature may not fall below a minimum value. The aluminium profile heater body design has a chimney effect and distributes the heat evenly. The heaters are designed for permanent operation. Pressure clamb connectors save time and simplify installation.