COPPERMedia 1
DATASheet
1-800-BELDEN-1 •www.belden.com
AX102272 10GX Modular Jack, Black
10GX Modular Jack
The 10GX Modular Jacks is a revolutionary
punch down UTP connector designed to be
used within the new Belden IBDN System
10GX.
To allow for data-rates of 10 Gb/s, the signal
needs to be transmitted at frequencies up to a
minimum of 500 MHz, as compared with
Category 6 transmissions which run up to
200 MHz. To achieve communication at these
high frequencies over UTP copper requires
significant changes in the way the channel
components are designed.
At these high frequencies, all components of
a 10G channel begin to emit electromagnetic
fields, which negatively impact the channels
that are closest in physical proximity. This
interaction between one channel and its
neighboring channels is called Alien Near End
Cross Talk (ANEXT). Overcoming this is one of
the most difficult requirements of the
Category 6A standard.
The second critical challenge to developing
10G jacks is to control the electrical performance
on all the other module parameters up to a
minimum of 500 MHz.
In order to achieve true 10G performance,
Belden has designed the 10GX Modular Jack
based on three technological revolutions in
structured cabling connectivity:
MatriX IDC Technology or “Module ANEXT
Cancellation Technology” is a patent-pending
design of the 10GX Modular Jack’s IDC pattern.
In this matrix design each IDC is positioned at
right angles to its neighboring IDC, and serves
to “cancel out” the Alien crosstalk generated
between jacks. The astonishing results of
incorporating this technology can be seen in
the 15 dB reduction in ANEXT in dense
installations such as in patch panels or
faceplates.
The FleXPoint PCB Technology or “Module
NEXT Compensation Technology” allows the
jack's crosstalk compensation circuitry to be
located at the very point of the source of the
noise; the plug interface. The FleXPoint PCB
module design uses a patent pending
flexible printed circuit board that offers
instant compensation to deliver unbeatable
crosstalk performance up to a minimum
of 625 MHz.
The X-Bar Technology or “Module NEXT
Control Bar Technology” is the use of a specific
patented plastic device that allows each pair
to be perfectly positioned at right angles for
termination on the 10GX Modular Jack’s IDC
pins. This device optimizes the termination
process and allows a 10GX Modular Jack
terminated under real field conditions to have
Installable Performance™ similar to the performance
measured in a laboratory environment.
The 10GX Modular Jack is the most advanced
10G jack available. It is designed to work in
existing hardware including the Flex Modular
Patch Panel and the MediaFlex Outlet Series.
The 10GX Modular Jack also comes in a
KeyConnect version that is designed to be used
with Belden's KeyConnect Patch Panels. It can
also be mixed and matched with a wide variety
of adapters and boxes to suit practically any
installation configuration for workstation
outlet, consolidation point and telecommuni-
cations closet applications.
The unmatched Beyond 10G™ performance
exceeds all parameters specified in the
proposed in the Category 6A standard.
All performance characteristics including
ANEXT, NEXT, FEXT, Insertion Loss and Return
Loss have been set to guarantee transmission
performance up to 625 MHz.
The 10GX Modular Jack is designed to be used
with the Belden IBDN System 10GX.
10GX Module.qxd:master 8/19/08 7:14 AM Page 1