T-1 (3mm) SOLID STATE LAMP Part Number: WP710A10YD5V Yellow Features Description z Low power consumption. The Yellow source color devices are made with Gallium z Popular T-1 diameter package. Arsenide Phosphide on Gallium Phosphide Yellow Light z General purpose leads. Emitting Diode. z Reliable and rugged. z Long life - solid state reliability. z Available on tape and reel. z 5V internal resistor. z RoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAL0566 REV NO: V.3B DATE: MAR/30/2013 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029092 Selection Guide Part No. Dice WP710A10YD5V Lens Type Yellow (GaAsP/GaP) Viewing Angle [1] Iv (mcd) [2] V= 5V Min. Typ. 21/2 7 15 40 Yellow Diffused Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2. Luminous intensity/ luminous Flux: +/-15%. 3. Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. peak Peak Wavelength Yellow D [1] Dominant Wavelength 1/2 Max. Units Test Conditions 590 nm VF=5V Yellow 588 nm VF=5V Spectral Line Half-width Yellow 35 nm VF=5V IF Forward Current Yellow 13 17.5 mA VF=5V IR Reverse Current Yellow 10 uA VR = 5V Note: 1.Wavelength: +/-1nm. 2. Wavelength value is traceable to the CIE127-2007 compliant national standards. Absolute Maximum Ratings at TA=25C Parameter Yellow Units Power dissipation 85 mW Forward Voltage 6 V Reverse Voltage 5 V Operating Temperature -40C To +70C Storage Temperature -40C To +85C Lead Solder Temperature [1] 260C For 3 Seconds Lead Solder Temperature [2] 260C For 5 Seconds Notes: 1. 2mm below package base. 2. 5mm below package base. SPEC NO: DSAL0566 REV NO: V.3B DATE: MAR/30/2013 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029092 Yellow WP710A10YD5V SPEC NO: DSAL0566 REV NO: V.3B DATE: MAR/30/2013 PAGE: 3 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029092 PACKING & LABEL SPECIFICATIONS WP710A10YD5V SPEC NO: DSAL0566 REV NO: V.3B DATE: MAR/30/2013 PAGE: 4 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029092 SPEC NO: DSAL0566 REV NO: V.3B DATE: MAR/30/2013 PAGE: 5 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029092 All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes SPEC NO: DSAL0566 REV NO: V.3B DATE: MAR/30/2013 PAGE: 6 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029092