PROCESSOR & STORAGE
• Powerful 720Mhz ARM Cortex A8 processor
with 128MByte DDR2 RAM
• 256MByte Flash memory storage (~120MB
available on board space for user storage)
• MicroSD card slot for additional storage
OPERATING SYSTEM
• Embedded Linux & Software Development
Kit (SDK)
CELLULAR BANDS
NTC-140W-01
• LTE:
– Band 2 (1900 MHz)
– Band 4 (AWS) (1700 / 2100 MHz)
– Band 5 (850 MHz)
– Band 13 (700 MHz)
– Band 17 (700 MHz)
– Band 25 (1900 MHz G Block)
• CDMA (EVDO Release 0 and EVDO
Release A):
– BC0 (Cellular 800 MHz)
– BC1 (PCS 1900 MHz)
– BC10 (Secondary 800 MHz)
• UMTS/HSDPA/HSUPA/HSPA+/DC-HSPA+:
– Band 1 (2100 MHz)
– Band 2 (1900 MHz)
– Band 4 (AWS 1700/2100 MHz)
– Band 5 (850 MHz)
– Band 8 (900 MHz)
• GSM/GPRS/EDGE:
– GSM 850 (850 MHz)
– EGSM 900 (900 MHz)
– DCS 1800 (1800 MHz)
– PCS 1900 (1900 MHz)
NTC-140W-02
• LTE:
– • Band 1 (2100 MHz)
– • Band 3 (1800 MHz)
– • Band 7 (2600 MHz)
– • Band 8 (900 MHz)
– • Band 20 (800 MHz)
• UMTS/HSDPA/HSUPA/HSPA+/DC-HSPA+:
– • Band 1 (2100 MHz)
– • Band 2 (1900 MHz)
– • Band 5 (850 MHz)
– • Band 8 (900 MHz)
• GSM/GPRS/EDGE:
– • GSM 850 (850 MHz)
– • EGSM 900 (900 MHz)
– • DCS 1800 (1800 MHz)
– • PCS 1900 (1900 MHz)
PEAK DATA SPEED
• LTE: Category 3:
– 100 Mbps / 50 Mbps (Downlink/Uplink)
(20Mhz bandwidth)
– 50 Mbps / 25 Mbps (Downlink/Uplink)
(10Mhz bandwidth)
• HSPA+:
– 42 Mbps downlink (Category 24)
– 5.76 Mbps uplink (Category 6)
• EDGE
– 236 kbps throughput
NTC-140W-01 only
• CDMA 1xEV-DO Rev. A:
– 3.1 Mbps (forward channel)
– 1.8 Mbps (reverse channel)
• CDMA 1x:
– 153 kbps (forward channel)
– 153 kbps (reverse channel)
– 14.4 kbps (circuit-switched data bearers)
CONNECTIVITY
• 2 x 10/100/1000 Base-T Ethernet RJ45 ports
with Auto MDIX
• Micro USB 2.0 OTG interface with 0.5A
supply capability
• 1 x multipurpose I/O pin
SIM CARD READER
• Lockable Tray Reader with Push-Button-to-
Release
– optional soldered-down SIM (ETSI MFF2
DFN-8 USIM)
• Supports Mini USIM/SIM Format (2FF)
RESET BUTTON
• Reset button (recessed, requiring pen/
paperclip) with three functions: Reboot,
reboot into recovery mode, and reset unit to
factory defaults
ANTENNA CONNECTORS
• 2x SMA connectors for 3G/4G
• 2x Reverse SMA connectors for Wireless
LAN (MIMO)
• 1x SMA connector for GPS
LED INDICATORS
• Tri-colour (Red/Amber/Green) LEDs. Power,
WLAN, Mobile Broadband, Service Type and
Signal Strength indicators
• Easy and clear LED status display for
connection status, connected network type,
and connection errors
CELLULAR
• Prole managed packet data connections
• NAT Disable for framed route conguration
• Transparent bridge mode using PPPoE to
allow the router to transparently forward
Public WAN IP address to a downstream
device
• SIM Security Management (PIN
conguration, enable and disable)
• Automatic and manual cellular band
selection
• Automatic and manual operator selection
GPS
• Embedded GPS receiver (1575.42Mhz)
• SMA Connector for external passive or
active GPS Antenna
• Active antenna voltage: 3.05V
• Maximum current: 50mA
• Tracking sensitivity under open sky:
-161dBm
• Acquisition sensitivity under open sky:
-145dBm
• Cold start sensitivity: -145dBm
• Time to rst x (TTFF): Cold 32s, Warm 29s,
Hot 1s
WIFI/WLAN
• High throughput and extended range
802.11b/g/n 2T2R WiFi with transmission
speeds up to 300Mbps
• Supports 2.4GHz frequency band
NETWORK & ROUTING
• Static Routing, RIP (v1/v2), Port Forwarding
and DMZ
• Dynamic DNS
• VRRP for redundant router failover
• DHCP Server, including :
– Address reservation by MAC address
– Custom DNS server denitions
– DHCP Relay
– DHCP list display in Web-UI
– Advanced DHCP Option conguration
(Option 42 NTP, Option 66 TFTP, Option
150, Option 160)VPN
• Data Stream Manager providing ability to
create mappings between input and output
ports (e.g. Serial Port, SMS, GPS, USB)
and perform required translation or data
processing by each virtual tunnel.
• Modbus Server TCP/IP Gateway and
Client TCP/IP Agent with up to 247 slaves
connected to the Serial TCP/IP Gateway.
• Modbus RTU/ASCII frames support.
VPN
• PPTP Client for VPN connectivity to remote
PPTP VPN Server
• IPSec tunnel termination (for up to 5 tunnels)
• GRE Tunnelling
• OpenVPN (Client, Server and P2P)
ADMIN & CONFIGURATION
• Web-based User Interface (HTTP/HTTPS) for
full device status and conguration
• Password protected conguration le
backup and restore for quick device
conguration and device cloning
• Telnet Command Line Interface for status
monitoring, conguration and control
• SNMP v1/v2 including cellular specic MIB,
cong and rmware download
• TR-069 Client for remote device
conguration, conguration backup and
restore, and rmware upgrade
• SMS messaging (Send/Receive) including
inbox, outbox
• Ping monitor watchdog (Reset connection
on repeated ping failure)
• Diagnostic Log Viewer (remote and local)
• System Status and Security Logs
• NTP Server Support for network time sync of
device’s system clock
• Device User Guide stored on the device and
accessible via the Web-based User Interface
(HTTP/HTTPS)
• Advanced Diagnostics and Control via SMS
– Query status information – such as
Signal Strength, WAN IP, Uptime, and
many more
– Congure device remotely via SMS –
such as APN, authentication settings,
and many more
– Execute commands via SMS – such as
reboot, reset to defaults, go ofine, and
many more
– Secure SMS management using sender
whitelisting and password management
– SMS acknowledgement replies for
queries and commands
FIRMWARE MANAGEMENT
• Firmware Upgrade locally via LAN or
remotely Over-The-Air (HTTP/ HTTPS,
SNMP, TR-069)
• Multiple rmware image storage on device
and dynamic install
• Triggered rmware upgrade via SMS (initiate
download & install from HTTP/HTTPS)
SOFTWARE DEVELOPMENT KIT
• Develop and install custom software
applications
• Open Linux standard development
environment
• Develop applications/scripting in standard
ANSI C/Shell script and LUA
• Package manager built into Web-UI for
Application installation/removal
• API (C, LUA and Shell libraries) to the unit’s
internal Runtime Database to allow full
status monitoring conguration and control
of the device from custom applications
TEMPERATURE
• Module Manufacturer’s Recommended
Operating Temperature: -40ºC to +85ºC
• Storage Temperature: -40ºC to +85ºC
POWER SUPPLY
• AC Power supply available as an optional
accessory
• Power input and I/O via 4 way Molex mini-t
connector
• DC Power (8 - 40V DC)
• 1x dedicated ignition input on 4 way
connector
• Minimum power input rating of 6W via 4 way
mini-t connector. Recommended power
input 12V 1.5A.
• Vehicle compatible protection on DC Input
Jack. (ISO7637 standard)
DIMENSIONS & WEIGHT
• Device dimensions (excluding external
antenna): 143mm (L) x 107mm (W) x 34mm
(D) / ~235g
MOUNTING OPTIONS
• Wall mount support in multiple orientations
via embedded mounting holes
• DIN Rail mount support via plastic bracket
included in box (Top hat section rail TH 35
IEC60715)
CERTIFICATIONS
NTC-140W-01
• FCC (USA)
• IC (Canada)
• PTCRB (USA)
• ISO7637
NTC-140W-02
• CE (Europe)
• RCM (Australia and New Zealand)
• E-Mark (Europe)
• TRA (UAE)
• iDA (Singapore)
• CITC (Saudi Arabia)
• MOC (Kuwait)
• SASO (Saudi Arabia)
• ICASA (South Africa)
• CB Compliant
• RoHS
• WEEE
CARRIER APPROVALS
NTC-140W-01
• AT&T (NTC-140-01-ATT)
• Verizon (NTC-140-01-VZW)
NTC-140W-02
• STC
Technical
Specications
Trademarks and registered trademarks are the property of NetComm Wireless Limited or their respective owners. Specications are subject to change without notice. Images shown may vary slightly from the actual product.
NETCOMM WIRELESS LIMITED HEAD OFFICE 18-20 Orion Road, Lane Cove, NSW 2066, Sydney, Australia ABN 85 002 490 486
NetComm
AUSTRALIAN OFFICE
T: +61 2 9424 2070
E: m2msales@netcommwireless.com
NORTH AMERICA OFFICE
T: +1 320 566 0316
E: NA.sales@netcommwireless.com
EUROPEAN OFFICE
E: EU.sales@netcommwireless.com
JAPAN OFFICE
T: +81 3 5326 3153
E: JP.sales@netcommwireless.com
MENA OFFICE
T: +971 4 450 8667
E: MENA.sales@netcommwireless.com
* In progress