WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: sales@wj.com • Web site: www.wj.com September 2000
HMJ5
Product Description
The HMJ5 is a high dynamic range, GaAs FET
mixer. This active FET mixer realizes a typical
third order intercept point of +35 dBm at an
LO drive level of +17 dBm. The HMJ5 comes
in a low cost, J-Lead package. Typical applica-
tions include frequency up/down conversion,
modulation and demodulation for receivers and
transmitters used in communications systems.
Product Features
•+35 dBm IIP3
•No external matching element
Required
•RF 40-1000 MHz
•LO 30-900 MHz
•IF 5-250 MHz
•+17 dBm LO Drive Level
•+3V at 35 mA DC Power Supply
•Low Cost Sur face Mount J-Lead
Package
Functional Diagram
Function Pin No.
Ground 1
IF 2
Ground 3-9
+3V DC 10
Ground 11
Function Pin No.
Ground 12
LO 13
Ground 14-20
RF 21
Ground 22
1234567891011
22 212019 18171615 1413 12
High Dynamic Range FET Mixer
Absolute Maximum Ratings
Parameter Rating
Operating Case Temperature -40 to +85°C
Storage Temperature -65 to +100°C
Maximum Input Power +25 dBm
1. Operation of this device above any of these parameters may cause per manent damage.
2.Total sum of LO port and RF port power should not exceed 25 dBm.
Ordering Information
Part No. Description
HMJ5 High Dynamic Range FET Mixer
(Available in tape and reel)
HMJ5-PCB Fully Assembled Application Circuit
Specifications
Parameter Units Minimum Typical Maximum Condition
Frequency Range:
RF MHz 40 1000
LO MHz 30 900
IF MHz 5 250
SSB Conversion Loss dB 7.5 9.0
SSB Noise Figure dB 9.5
Isolation:
LO to RF dB 20 28
LO to IF dB 24 30
IIP3 dBm 31 35 RF = 900 MHz (0 dBm)
Return Loss:
RF Port dB 11.7
LO Port dB 6.0
IF Port dB 10.9
Input P1dB dBm 23
LO Drive Level dBm 17
DC Current at +3V Bias mA 35 60
Notes:
1. RF = 905 MHz (-10 dBm) LO 900 (+17 dB) IF = 5 at 25°C.
2. Measured in a 50-ohm system with nominal LO dr ive in a downconver ter application only, unless otherwise specified.
3. LO frequency must be separated from IF frequency by a minimum of 2 MHz (i.e., |FLO - FIF| ≥2 MHz).
The Communications Edge™
• UPDATED •
+17 dBm LO Drive
WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: sales@wj.com • Web site: www.wj.com September 2000
HMJ5
Performance Charts
0 200 400 600 800 1000
Conversion Loss vs. RF Frequency IP3 vs. RF Frequency
LO Port Return Loss vs. LO Freq
LO to RF Isolation LO to IF Isolation
RF Frequency (MHz)
0 300 600 900
50
45
40
35
30
IF = 250 MHz
Conversion Loss (dB)
RF Frequency (MHz)
9
8
7
6
5
LO Frequency (MHz)
0 300 600
L-R Isolation (dB)
60
50
40
30
20
10 900 RF Frequency (MHz)
L-I Isolation (dB)
60
50
40
30
LO Return Loss
5
25
20
15
10
IF Return Loss vs. IF Frequency
IF Frequency (MHz)
Return Loss (dB)
50 100 150 200 250
5
25
20
15
10
RF Port Return Loss
RF Frequency (MHz)
Return Loss (dB)
0 200 400 600 800 1000
5
25
20
15
10
IP3 (dBm)
0 300 600 900
LO Frequency (MHz)
0 200 400 600 800 1000
IF = 5 MHz
IF = 250 MHz
IF = 100 MHz
IF = 5 MHz
LO = 750 MHz LO = 550 MHz
LO = 350 MHz
LO = 250 MHz
LO = 450 MHz
LO = 850 MHz
WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: sales@wj.com • Web site: www.wj.com September 2000
HMJ5
Specifications and information are subject to change without notice.
Caution! ESD sensitive device.
Outline Drawing
Land Pattern Mounting Configuration
WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: sales@wj.com • Web site: www.wj.com
