STRAIN RELIEF - Rugged internal clamp holds cable tightly, while making a secure, low
resistance connection between cable shield and housing.
FLEX RELIEF - Protects by minimizing cable bending stress at point of cable entry.
Maximum recommended cable diameter is .115 inch (2.92 mm) when flex relief is used. By
omitting flex relief (Series T(*)FL and T(*)ML only), cable up to .170 inch (4.32 mm) diameter
can be used.
ASSEMBLY - Connector parts are mechanically keyed for simple assembly.
POLARIZATION - Mating male and female connectors are also mechanically keyed (latch
and groove) so that it is impossible to mate them incorrectly.
"SCOOP-PROOF" FEATURE - Fully recessed pins on
male plugs and receptacles cannot be "scooped", bent or damaged by accidental mismating with
mating connector.
COLOR ESCUTCHEONS - Attractive color escutcheons, Series TYEF, are recommended for
use with Series TY(*)F and TY(*)FPC receptacles (when rear mounted) for attractive panel
trim, as well as color coding one or more connectors. Colors are: red, black, gray, green, blue,
white and yellow.
CUSTOM Tini Q-G® CABLE ASSEMBLIES -
On special order where production quantities warrant, Switchcraft can supply assembled and
tested Tini Q-G® cables.
MOUNTING
Panel/Chassis Thickness:
Series TB(*)M: .25 inch (6.35 mm)
maximum
Series TY(*)F:
Front--.375 inch (9.5 mm) maximum
Rear--.093 inch (2.3 mm) maximum
Series TY(*)FPC:
Front--.312 inch (7.9 mm) maximum
Rear--.093 inch (2.3 mm) maximum
SPECIFICATIONS: (all Tini QG, except 6 pin)
ELECTRICAL
Contact Resistance: .010 ohms maximum after life (and after salt spray).
Current Rating (Carry Only): 5 A, 125 V AC (4 A, 125 V AC on 5 circuit) based on 30°C
maximum.
Insulation Resistance: 510,000 megohms minimum @ 500 V DC (initial); 10,000 megohms
minimum (after humidity test).
Dielectric Strength: 1,000 V (rms).