BI-CELL AND QUADRANT PHOTODIODES SPECIFICATIONS (PER ELEMENT) Responsivity: 0.32 A/W min., 0.38 A/W typ. @ 632.8nm; 0.50 A/W min., 0.62 A/W typ. @ 900nm Non-uniformity between elements: Part Number Total Shunt Area Resistance1 per Element (mm2) 5% deviation max., 1% typ. Dark Current1 at 5V Breakdown Voltage2 at 10A Capacitance3 NEP4 at 632.8nm NEP5 at 950nm Light6 Power Density Response Time7 at 10V Typ. Min. (M) Typ. (nA) Max. (nA) Typ. (V) at 0V (pF) At 10V (pF) Typ. (W/Hz) Typ. (W/Hz) Typ. (mW/cm2) Typ. (ns) Bi-Cell (Two Element Detectors) SD 066-24-21-011 0.67 500 0.2 1.0 50 15 3 2.1x10-14 1.2x10-14 10 7 SD 113-24-21-021 3.1 250 0.9 5.0 50 60 13 4.3x10-14 2.5x10-14 10 8 SD 160-24-21-021 2.3 300 0.7 3.5 50 45 9 4.3x10-14 2.5x10-14 10 7 SD 385-24-21-041 18.5 40 6.0 31.0 50 390 85 5.0x10-14 2.9x10-14 10 32 Quadrant (Four Element Detectors) SD 055-23-21-011 0.25 800 0.1 0.4 50 15 3 2.1x10-14 1.2x10-14 10 7 SD 085-23-21-021 2.25 350 0.6 3.5 50 45 9 4.3x10-14 2.5x10-14 10 7 SD 118-23-21-021 1.61 450 0.5 2.5 50 35 7 4.3x10-14 2.5x10-14 10 7 SD 197-23-21-041 4.79 175 1.4 7.5 50 100 20 4.3x10-14 2.5x10-14 10 8 SD 225-23-21-040 5.4 100 1.2 6.5 50 102 24 4.3x10-14 2.5x10-14 10 8 SD 380-23-21-051 17.8 100 5.0 27.0 50 375 75 5.2x10-14 3.0x10-14 10 30 * All specifications are per element. All values at 23C 1. Dark Current and Shunt Resistance vary with temperature as follows; for T23C, IDT = ID23 * 1.09T, RSHT= RSH23 * 0.9T, where T=(T-23) and ID23 and RSH23 are values at 23C. 2. Typical values listed. Minimum value shall be 50% of typical. 3. Typical values listed. Maximum value shall be 20% higher than the typical. 4. Test conditions are VB = 10mV, and 632.8 nm. 5. Test conditions are VB = 10mV, and 950 nm. 6. In photovoltaic mode. Maximum linear current specifies the level at which the output current characteristic deviates more than 10% from the straight line. The short circuit current saturates at approximately 10 times this level. 7. Response Time (transition time between 10% and 90% of the output signal amplitude) measured at 670 nm with a 50 load. Shorter wavelengths will result in faster rise and fall times. Storage and Operating Temperature Range for all photodiodes is -40C to 110C, except for the SD 225-23-21-040, which is -25C to 100C. Absolute Spectral Responsivity 0.70 Responsivity (A/W) 0.60 0.50 0.40 0.30 0.20 0.10 0.00 200 300 400 500 600 700 800 900 1000 1100 1200 Wavelength (nm) Bi-Cell Dimensional Outlines SD 066-24-21-011 SD 113-24-21-021 SD 160-24-21-021 1 3 1 3 1 2 2 1 3 1 BOTTOM VIEW 1 2 CASE 3 SD 385-24-21-041 1 3 2 1 3 BOTTOM VIEW 2 CASE 3 1 3 2 3 1 BOTTOM VIEW 2 CASE 1 3 3 BOTTOM VIEW 2 CASE 1 3 Quadrant Dimensional Outlines SD 055-23-21-211 SD 085-23-21-021 6 SD 118-23-21-021 4 3 1 4 3 1 2 2 4 3 1 2 2 1 1 6 3 5 1 BOTTOM VIEW 2 5 CASE 3 SD 225-23-21-040 SD 197-23-21-041 2 1 2 5 CASE 3 4 4 6 5 CASE BOTTOM VIEW 1 3 4 4 BOTTOM VIEW 1 2 3 5 4 SD 380-23-21-051 3 2 4 1 5 2 4 1 5 5 3 CASE 2 4 5 CASE 2 4 5 1 2 3 BOTTOM VIEW 1 1 3 3 6 BOTTOM VIEW 1 5 4 5 BOTTOM VIEW 1 3 7 1 7 2&6 CASE 3 5 7