AH117 The Communications Edge TM 1/4 Watt, High Linearity InGaP HBT Amplifier Product Features Product Description * 400 - 2200 MHz Functional Diagram The AH117 is a high gain, high dynamic range driver amplifier in a low-cost surface mount package. The InGaP/GaAs HBT is able to achieve performance over a broad range with +41 dBm OIP3 and +24 dBm of compressed 1-dB power and is housed in an industry standard SOT-89 SMT package. All devices are 100% RF and DC tested. * +24 dBm P1dB * +41 dBm Output IP3 * 18.5 dB Gain @ 900 MHz * 15 dB Gain @ 1900 MHz * Single Positive Supply (+5V) 4 1 The product is targeted for use as a gain block/driver amplifier for various current and next generation wireless technologies such as GPRS, GSM, CDMA, W-CDMA, and UMTS, where high linearity and medium power is required. In addition, the AH117 will work for numerous other applications within the 440 to 2000 MHz frequency range such as CATV and fixed wireless. The internal active bias allows the AH117 to maintain high performance and low gain variation over temperature. * SOT-89 SMT Package Specifications Parameters Preliminary Product Information 2 Function Input / Base Output / Collector Ground 3 Pin No. 1 3 2, 4 Typical Performance Units Min Typ Max Parameters MHz dB dB dB dBm dBm dB 400 1900 15 14 8 +24 +41 5.5 2200 Frequency S21 S11 S22 Output P1dB Output IP32 Noise Figure Supply Bias Frequency Range Gain Input R.L. Output R.L. Output P1dB Output IP32 Noise Figure IS-95 Channel Power @ -65 dBc ACPR, 9 Ch .Fwd., 1960MHz Operating Current Range Device Voltage dBm +11 mA V 120 5 Units Typical MHz dB dB dB dBm dBm dB 900 1900 18.5 15 -13 -14 -11 -8 +24 +23 +39 +39 5.0 5.5 +5 V @ 120 mA Typical parameters reflect performance in recommended application circuit: Test conditions unless otherwise noted. Specifications apply across entire frequency band. 1. T = 25C, Vsupply = +5 V, Frequency = 1900 MHz, in recommended application circuit 2. 3OIP measured with two tones at an output power of +5 dBm/tone separated by 1 MHz. The suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule. Absolute Maximum Rating Parameters Operating Case Temperature Storage Temperature RF Input Power (Continuous) dc Voltage / Current Rating -40 to +85 C -55 to +150 C +12 dBm +6 V / 200mA Ordering Information Part No. Description AH117 0.25 Watt, High Linearity InGaP HBT Amplifier (Available in Tape & Reel) Operation of this device above any of these parameters may cause permanent damage. This document contains information on a new product. Specifications and information are subject to change without notice WJ Communications, Inc * Phone 1-800-WJ1-4401 * FAX: 408-577-6621 * e-mail: sales@wj.com * Web site: www.wj.com April 2003 AH117 1/4 Watt, High Linearity InGaP HBT Amplifier Outline Drawing The Communications Edge TM Preliminary Product Information Product Marking The component will be marked with an "AH117" designator with a four- or five-digit alphanumeric lot code on the top surface of the package. Tape and reel specifications for this part is located on the website in the "Application Notes" section. ESD / MSL Information Land Pattern ESD Classification: Value: Test: Standard: Class 1B Passes at 1000V Human Body Model (HBM) JEDEC Standard JESD22-A114 MSL Rating: Standard: Level 2 JEDEC Standard J-STD-020A Mounting Config. Notes 1. Ground / thermal vias are critical for the proper performance of this device. Vias should use a .35mm (#80 / .0135") diameter drill and have a final plated thru diameter of .25 mm (.010"). 2. Add as much copper as possible to inner and outer layers near the part to ensure optimal thermal performance. 3. Mounting screws can be added near the part to fasten the board to a heatsink. Ensure that the ground / thermal via region contacts the heatsink. 4. Do not put solder mask on the backside of the PC board in the region where the board contacts the heatsink. 5. RF trace width depends upon the PC board material and construction. 6. Use 1 oz. Copper minimum. 7. All dimensions are in millimeters (inches). Angles are in degrees. This document contains information on a new product. Specifications and information are subject to change without notice WJ Communications, Inc * Phone 1-800-WJ1-4401 * FAX: 408-577-6621 * e-mail: sales@wj.com * Web site: www.wj.com April 2003 AH117 The Communications Edge TM 1/4 Watt, High Linearity InGaP HBT Amplifier Preliminary Product Information Typical Device Data S-Parameters (VD = +5 V, ID = 120 mA, T = 25C, calibrated to device leads) Freq (MHz) 50 100 200 300 400 500 600 700 800 900 1000 1100 1200 1300 1400 1500 1600 1700 1800 1900 2000 2100 2200 2300 2400 2500 2600 2700 2800 2900 3000 S11 (dB) S11 (ang) S21 (dB) S21 (ang) S12 (dB) S12 (ang) S22 (dB) S22 (ang) -2.65 -2.57 -2.59 -2.57 -2.55 -2.54 -2.54 -2.50 -2.46 -2.48 -2.47 -2.45 -2.41 -2.42 -2.43 -2.42 -2.45 -2.42 -2.46 -2.48 -2.47 -2.50 -2.47 -2.48 -2.49 -2.48 -2.47 -2.47 -2.45 -2.44 -2.43 177.33 168.77 155.22 142.28 129.43 116.66 104.00 91.29 78.85 66.07 53.51 40.86 28.14 15.33 2.44 -10.30 -23.37 -36.30 -49.39 -62.48 -76.10 -89.48 -102.75 -115.96 -129.34 -142.86 -155.90 -169.14 178.16 165.28 152.51 17.51 16.57 16.22 16.10 15.88 15.68 15.53 15.32 15.02 14.92 14.58 14.24 14.11 13.65 13.51 13.36 12.90 12.79 12.52 12.14 11.88 11.61 11.38 11.32 10.77 10.78 10.34 9.60 9.77 9.23 9.02 152.58 153.47 143.38 130.25 116.45 101.74 87.19 73.27 58.60 44.31 31.42 16.61 3.55 -10.11 -25.13 -36.95 -50.59 -64.30 -76.30 -89.28 -103.20 -116.14 -130.40 -141.99 -154.82 -168.81 -177.90 166.21 153.14 142.29 127.63 -31.50 -31.42 -31.36 -31.38 -31.34 -31.37 -31.18 -31.23 -31.20 -30.96 -30.92 -30.89 -30.63 -30.78 -30.47 -30.12 -30.33 -29.95 -29.77 -29.90 -29.75 -29.53 -29.40 -29.11 -29.18 -28.67 -28.56 -29.51 -28.46 -28.79 -28.69 -0.15 -6.89 -16.84 -26.35 -35.08 -44.64 -53.64 -62.35 -71.87 -80.68 -88.65 -99.45 -107.77 -116.61 -128.20 -135.92 -146.12 -156.80 -164.31 -174.43 175.27 165.09 154.30 145.05 134.89 123.06 119.33 104.59 92.39 86.95 70.65 -3.65 -3.50 -3.49 -3.52 -3.57 -3.63 -3.72 -3.80 -3.90 -3.98 -4.08 -4.17 -4.28 -4.37 -4.46 -4.57 -4.67 -4.76 -4.85 -4.97 -5.01 -5.10 -5.12 -5.20 -5.21 -5.22 -5.25 -5.25 -5.23 -5.26 -5.24 -177.48 171.39 155.69 141.70 128.21 115.10 102.05 89.03 76.35 63.64 51.08 38.62 26.05 13.46 1.13 -11.46 -23.86 -36.59 -48.97 -61.57 -74.30 -87.08 -99.62 -112.43 -125.02 -137.81 -150.27 -162.60 -174.85 172.90 160.87 Thermal Information Parameters Operating Case Temperature Storage Temperature Thermal Resistance Rating -40 to +85 C -55 to +150 C 125 C/W This document contains information on a new product. Specifications and information are subject to change without notice WJ Communications, Inc * Phone 1-800-WJ1-4401 * FAX: 408-577-6621 * e-mail: sales@wj.com * Web site: www.wj.com April 2003