R E L AY S A N D C O N TA C T O R S D.C. P o w e r C o n t a c t o r s - Ty p e 586 Type 586 SPDT STANCOR Part Sec. Number Duty Cycle Terminal Pole Type* Form Type 586 SPNO Bracket Style Coil Coil Resistance Volt. (Ohms) D.C. @25C Contact Rating-(Amps.) Inductive Load Volt. Normally Open Normally Closed D.C. Continuous Inrush** Continuous Inrush** Contact Material Dimensions Inches Case L W H Weight Agency (oz.) Certif. A 586-901 Continuous 4 SPNO Standard 6 5.3 Silver Alloy 6 200 600 - - 3.69 3.30 2.90 24.0 - 586-902 Continuous 4 SPNO Standard 12 21.0 Silver Alloy 12 200 600 - - 3.69 3.30 2.90 24.0 - 586-903 Continuous 4 SPNO Standard 15 32.8 Silver Alloy 15 200 600 - - 3.69 3.30 2.90 24.0 - B 586-905 Continuous 4 SPNO Standard 24 84.0 Silver Alloy 24 200 600 - - 3.69 3.30 2.90 24.0 - 586-906 Continuous 4 SPNO Standard 36 189.0 Silver Alloy 36 200 600 - - 3.69 3.30 2.90 24.0 - 586-907 Continuous 4 SPNO Standard 48 336.0 Silver Alloy 36 200 600 - - 3.69 3.30 2.90 24.0 - C 586-911 Continuous 6 SPDT Standard 12 13.2 Silver Alloy 12 200 600 100 300 4.61 3.30 2.90 26.0 - 586-914 Continuous 6 SPDT Standard 24 53.0 Silver Alloy 24 200 600 100 200 4.61 3.30 2.90 26.0 - 586-915 Continuous 6 SPDT Standard 36 120.0 Silver Alloy 36 200 600 100 200 4.61 3.30 2.90 26.0 - For outline drawings refer to page 57. -- Water Resistant * Terminal Type: "4" = Isolated Coil "6" = Isolated Coil ** Inrush Current: Current applied within the first 1/2 second of contact closure Engine e r i n g D e s i g n D a t a D.C. Type 586 Coil Rating Nominal Magnetic Coil Rating (Watts) Operation in % of Nom. Coil Voltage Rating Pick-up Max. Safe Operate Breakdown Voltages All Terminals - 60 Hz RMS Open Contacts Opposite Same To Polarity Polarity Ground Contact Material Power 8 - SPNO 75% 110% 500 500 500 Silver Alloy 12 - SPDT Temperature Range Pilot - Electrical Life Oper. Oper. At Per Rated Load Min. 50,000 2 Mechanical Life Oper. At No Load Oper. Per Min Max. Oper. Temp. F 100,000 30 150 Type 586 Custom Design Capabilities -- -40F to 150F Terminations -- Contacts: 5/16"-24 UNF-2A thread -- Coil: #10-32 UNF-2A thread -- Coil voltages 6 VDC through 48 VDC -- High vibration -- Please complete application data form on page 95 of this section. Recommended Mounting -- Vertical plane with coil terminals up. Hardware Torque Specification -- Contact Terminal: 60 inch-lbs., max. -- Coil Terminal: 12-18 inch lbs. Note: Caution must be used in coil selection for use in 12 volt systems where battery charging may expose coil to continuous, higher-than-rated voltage. Stancor will not be responsible for consequences of misapplied solenoids. 56 www.stancor.com R E L AY S A N D C O N TA C T O R S Type 586 Terminal Type 4 - Isolated Coil SPNO .281 wIde X .600 lonG slot 3.300 W 2.300 5/16-24 unf-2A X .594 lonG 3.688 L #10-32 unf-2A X .375 lonG 2.797 H Terminal Type 6 - Isolated Coil SPDT .281 wIde X .600 lonG slot 3.300 W 2.300 5/16-24 unf-2A X .594 lonG 4.618 L #10-32 unf-2A X .375 lonG 2.797 H www.stancor.com 57