TENSOLITE CABLE ASSEMBLY TECHNICAL DATA SHEET TS1818 CONFIGURATION TS SERIES CABLE ASSEMBLIES. TS7878 CONFIGURATION NOTE: 2 CAUTION MARKERS (1 EACH END) TS1878 CONFIGURATION ELECTRICAL SPECIFICATIONS MATERIALS AND FINISHES IMPEDANCE, NOMINAL: CAPACITANCE NOMINAL: VELOCITY OF PROPAGATION, NOMINAL: 50 OHMS 28.7 pf/FOOT 70.7 % RELATIVE SHIELDING PARALLEL TOUCHING 24 IN: -100.0 dB MIN. INSULATION RESISTANCE: 1000 MEGOHMS MIN. DIELECTRIC WITHSTANDING VOLTAGE: 1500 VRMS MIN. ELECTRICAL DELAY, NOMINAL: 1.44 ns/FOOT ELECTRICAL DELAY, NOMINAL: 120 ps/INCH PULSE RF POWER: 1250 WATTS MAX. (INTO A 50 OHM SYSTEM, WITH DUTY CYCLE LESS THAN CW RATING) F (IN GHz) ----------------1 2 4 6 12 18 MAX. CW WATTS ------- 213 145 97 76 49 38 0.6 1.2 1.8 3.6 5.4 PHASE STABILITY DEG 0.3 LOSS STABILITY dB---- 0.01 0.01 0.01 0.015 0.03 0.05 CABLE FORMED AND STRAIGHTENED 9O DEGREES ON A 4" RADIUS Cables are manufactured as matched sets or matched to laboratory standards. Cables maintain network analyzer compatible characteristics during product life when formed up to 180 degrees at a 4 inch (2.5 inch for TS1818-07) or greater radius. DESCRIPTION MATERIAL FINISH OR COLOR CABLE JACKET: PVC GRAY MARKING: BLACK BOOTS: RUBBER COMPOUND GRAY SOLDER: QQ-S-571 NONE FLUX: MIL-F-14256, RMA NONE CONTACTS: ASTM B196 BeCu MIL-G-45204 GOLD PLATED N INSULATORS: ASTM D1457 PTFE NONE 7 MM INSULATORS: PTFE COMPOSITE NONE N CONNECTOR BODY: ASTM A 582 303 STAINLESS STEEL QQ-P-35 PASSIVATED 7 MM CONNECTOR BODY: ASTM B196 BeCu MIL-G-45204 GOLD PLATED NUTS: ASTM A 582 303 STAINLESS STEEL QQ-P-35 PASSIVATED AVAILABLE GASKET: ZZ-R-765 SILICON RUBBER RED THIS TYPE N CONNECTOR DOES NOT HAVE A WEATHER SEALING GASKET. A USER INSTALLED TYPE N GASKET IS AVAILABLE. ORDER GASKET, PART NUMBER 5-1368-100-17. SOLVENTS: NO OZONE DEPLETING MATERIALS ARE USED MECHANICAL SPECIFICATIONS: CABLE MAX. DIAMETER: MIN. ONE TIME BEND RADIUS: FLEXED BEND RADIUS: CONNECTOR RETENTION: TEMPERATURE RANGE: MATING TORQUE: CONNECTOR INTERFACES: PART NUMBER LENGTH 0.220 1.17 3.90 100 -55 TO +85 7-10 MIL-STD-348 (N) INCHES INCHES INCHES POUNDS MIN. DEGREES C INCH POUNDS IEEE 287 (7MM) +- MAXIMUM VSWR :1 AT FREQUENCY (IN GHz.) UP TO 1 1 TO 2 2 TO 3 3 TO 6 6 TO 12 12 TO 18 REF. REF. WEIGHT CONN. INCHES LENGTH OUNCES TS1818TS1818TS1818TS1818TSA1818TS1818TS1818TS1818TS1818TS7878TS7878TS7878- 07 07S 12 24 24V 34 36 STR 18 18 24 STS OTHER AVAILABLE CONFIGURATIONS: CONN. 1 CONN. 2 LENGTH PART NUMBER TS1878-12 N MALE 7 MM 12 N MALE 7MM TS1878-24 24 N MALE 7 MM TS1878-34 34 7MM 7MM TS7878-34 34 7.5 0.38 N N INCH CABLES 12.0 0.60 N 24.0 1.20 N 1.20 N 24 34.0 1.70 N 36.0 1.80 N SET AND 1 - 34 INCH 0.90 7MM 18.0 0.90 7MM 18.0 1.20 7MM 24.0 7MM INCH CABLES PRODUCT SPECIFICATIONS SEE TS1818-12 ABOVE SEE TS1818-24 ABOVE SEE TS1818-34 ABOVE SEE TS1818-34 ABOVE MAXIMUM INSERTION LOSS IN dB AT FREQ. (IN GHz.) UP TO 1 1 TO 2 2 TO 3 3 TO 6 6 TO 12 12 TO 18 REF. REF. LENGTH CM 4.3 1.07 1.10 1.13 1.18 1.25 0.16 0.21 0.27 0.38 0.56 19.1 4.6 5.3 5.3 5.8 5.9 1.07 1.07 1.06 1.07 1.07 1.10 1.10 1.06 1.10 1.10 1.13 1.13 1.06 1.13 1.13 1.18 1.18 1.25 1.25 1.17 1.18 1.25 1.25 0.20 0.32 0.32 0.43 0.45 0.28 0.46 0.46 0.61 0.64 0.35 0.58 0.58 0.77 0.81 0.50 0.85 0.85 1.13 1.19 0.76 1.29 1.29 1.72 1.81 30.5 61.0 61.0 86.4 91.4 4.9 4.9 5.3 1.07 1.07 1.07 1.09 1.09 1.09 1.10 1.10 1.10 1.16 1.16 1.16 1.22 1.22 1.22 0.26 0.26 0.32 0.37 0.37 0.46 0.47 0.47 0.58 0.68 0.68 0.85 1.02 1.02 1.29 1.30 1.30 1.30 1.46 1.46 1.80 45.7 45.7 61.0 MAXIMUM SPECIFICATIONS ARE PRODUCT MAXIMUM INCLUDING MEASURING SYSTEM UNCERTAINTY. SPECIFICATIONS FROM 6 THRU 18 GHZ ARE NOT VERIFIED AND ARE FOR REFERENCE ONLY. HP PART NUMBECONN. LENGTH 11851 N 24, 34 NOTE11857 A + D 7MM 24 8120-4779 7MM 24 8120-4780 N 34 8120-4781 N 24 8120-4782 N 8 8120-4387 N 7.5 8120-5639 N 24 ORDER QMI PART NUMBER TYPICAL EQUIPMENT PROVIDED WITH THESE CABLES AS RF INTERCONNECTS: TS1818-STR (SET OF 3-24, 1-34) TS7878-STS (SET OF 2-7MM) TS7878-24 TS1818-34 TS1818-24 TS1818-07 TS1818-07S (SET OF 4-7.5) TSA1818-24V 3577 8502 8503 8505 8507 8711 8712 8713 ANA T/R S PAR ANA ANA ANA ANA ANA 8714 8748 8751 8752 8753 11850 35677 85044 ANA S PAR ANA ANA ANA PS S PAR T/R 85046 S PAR 85047 S PAR 87511 S PAR ANA = AUTOMATIC NETWORK ANALYZER S PAR = S PARAMETER TEST SET T/R = TRANSMISSION REFLECTION TEST SET PS = POWER SPLITTER TS1818-STR IS A SET OF 3-24 INCH AND 1-34 INCH TYPE N CABLES USED TO INTERCONNECT TRANSMISSION REFLECTION TEST SETS AND POWER SPLITTERS TS7878-STS IS A SET OF 2 MATCHED 24 INCH 7MM CABLES USED AS TEST PORT EXTENSION CABLES ON TRANSMISSION REFLECTION AND S PARAMETER TEST SETS. TSA1818-24V IS A LOW VSWR (<-30 dB return loss) 24 INCH TYPE N CABLE FOR USE WITH 8752 SYSTEMS. CONSULT 8752 MANUAL FOR REPLACEMENT PROCEDURE TS7878-18 IS PHASE MATCHED TO MASTER +/-2 DEGREES @ 2 GHZ. NOTE: HP 11857 A AND 11857D ARE 50 OHM 7MM ASSEMBLIES 11857B IS A 75 OHM TYPE N ASSEMBLY NOTE: PRODUCT SPECIFICATIONS ARE VERIFIED AT 73 DEG. F, SEA LEVEL AND 20 TO 80% RELATIVE HUMIDITY. PRODUCT SPECIFICATIONS APPLY AT 5 TO 99% (NON CONDENSING) RELATIVE HUMIDITY, CONSULT FACTORY FOR PRODUCT CHARACTERISTICS AT OTHER CONDITIONS. SEMI-FLEX IS A REGISTERED TRADEMARK OF TENSOLITE CO. PRODUCT INFORMATION AVAILABLE ON OUR WEB PAGE @ http://www.tensolite.com COPYRIGHT 1999 / 2004 TENSOLITE DATA SUBJECT TO CHANGE file P:\Andover\TechInfo\Data Sheets\Technical\Cable Assemblies\TS\TS REV.: 05/27/04