2.0x1.25mm SMD CHIP LED LAMP Part Number: KP-2012SEC Features Description z2.0mmx1.25mm zLOW SMT LED,1.1mm THICKNESS. POWER CONSUMPTION. zWIDE zIDEAL The Super Bright Orange device is made with InGaAlP (on GaAs substrate) light emitting diode chip. VIEWING ANGLE. FOR BACKLIGHT AND INDICATOR. zVARIOUS COLORS AND LENS TYPES AVAILABLE. zPACKAGE : 2000PCS / REEL. zMOISTURE zRoHS SUPER BRIGHT ORANGE SENSITIVITY LEVEL : LEVEL 3. COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.1(0.004") unless otherwise noted. 3. Specifications are subject to change without notice. 4. The device has a single mounting surface. The device must be mounted according to the specifications. SPEC NO: DSAB3530 REV NO: V.10 DATE: JUN/11/2007 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: W.J.HUA PAGE: 1 OF 4 Selection Guide Dice Part No. KP-2012SEC Iv (mcd) [2] @ 20mA Lens Type SUPER BRIGHT ORANGE (InGaAlP) WATER CLEAR Viewing Angle [1] Min. Typ. 21/2 70 200 120 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. 2. Luminous intensity / luminous flux: +/-15%. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. peak Peak Wavelength Super Bright Orange D [1] Dominant Wavelength 1/2 Max. Units Test Conditions 610 nm IF=20mA Super Bright Orange 601 nm IF=20mA Spectral Line Half-width Super Bright Orange 29 nm IF=20mA C Capacitance Super Bright Orange 30 pF VF=0V;f=1MHz VF [2] Forward Voltage Super Bright Orange 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Orange 10 uA VR = 5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. Absolute Maximum Ratings at TA=25C Parameter Super Bright Orange Units Power dissipation 75 mW Forward Current 30 mA Peak Forward Current [1] 195 mA 5 V Reverse Voltage Operating / Storage Temperature -40C To +85C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAB3530 REV NO: V.10 DATE: JUN/11/2007 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: W.J.HUA PAGE: 2 OF 4 Super Bright Orange KP-2012SEC SPEC NO: DSAB3530 REV NO: V.10 DATE: JUN/11/2007 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: W.J.HUA PAGE: 3 OF 4 KP-2012SEC Recommended Soldering Pattern (Units : mm; Tolerance: 0.1) Tape Specifications (Units : mm) SPEC NO: DSAB3530 REV NO: V.10 DATE: JUN/11/2007 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: W.J.HUA PAGE: 4 OF 4