KVR16LR11D8/8
8GB 2Rx8 1G x 72-Bit PC3L-12800
CL11 Registered w/Parity 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 1G x 72-bit (8GB)
DDR3L-1600 CL11 SDRAM (Synchronous DRAM), low voltage,
registered w/parity, 2Rx8 ECC, memory module, based on
eighteen 512M x 8-bit FBGA components. The SPD is pro-
grammed to JEDEC standard latency DDR3-1600 timing of
11-11-11 at 1.35V and 1.5V. This 240-pin DIMM uses gold
contact fingers. The electrical and mechanical specifications
are as follows:
FEATURES
•JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~
1.575V) Power Supply
•VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
•800MHz fCK for 1600Mb/sec/pin
•8 independent internal bank
•Programmable CAS Latency: 11, 10, 9, 8, 7, 6
•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•8-bit pre-fetch
•Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
•Bi-directional Differential Data Strobe
•Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
•On Die Termination using ODT pin
•On-DIMM thermal sensor (Grade B)
•Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
•Asynchronous Reset
•PCB : Height 1.180” (30.00mm), double sided component
Document No. VALUERAM1324-001.B00 04/16/14 Page 1
Memory Module Specifi cations
SPECIFICATIONS
CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power (@1.35v) 2.987 W* (per module)
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM and
Register/PLL used.
Continued >>
MODULE DIMENSIONS:
(units = millimeters)
Document No. VALUERAM1324-001.B00 Page 2
