TOSHIBA TPS823 TOSHIBA PHOTO IC SILICON EPITAXIAL PLANAR TPS823 PHOTO IC FOR PLASTIC FIBER/POLYMER CLAD FIBER Unit in mm TPS823 contains a light receiving IC integrating photo diode, [J (R05) amplifier circuit, open collector output circuit, in 1 chip. +02 +0.2 (0.3) | 45-01 (ROS) yao Output is directly connectable to IC as it changes digitally. TL When light is received, output becomes low level. 8 a | 3 i MAXIMUM RATINGS (Ta = 25C) 4 : ~ CHARACTERISTIC SYMBOL | RATING | UNIT i 061 so18 Supply Voltage Voc 5.5 Vv 5 ff) .f3-0.41+0.15 Output Voltage Vo 5.5 Vv : 12 18 Output Current 19 50 mA C1919) 1.05 02 Output Collector Power Dissipation Po 85 mW Operating Temperature Range Topr 25~85 C Storage Temperature Range Tstg 40~100 C (_) |REFERENCE VALUE Lead Temperature : Time Tsol 260C::3s JEDEC EIAJ TOSHIBA 0-5H2 Weight : 0.12g (TYP.) PIN CONNECTION I CC 1 Io > a 3 GND 961001EAA2 @ TOSHIBA is continually working to improve the quality and the reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to observe standards of safety, and to avoid situations in which a malfunction or failure of a TOSHIBA product could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent products specifications. Also, please keep in mind the precautions and conditions set forth in the TOSHIBA Semiconductor Reliability Handbook. @ The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. @ The information contained herein is subject to change without notice. 1997-09-08 1/4 TOSHIBA TPS823 OPTO-ELECTRICAL CHARACTERISTICS (Ta = 25C) CHARACTERISTIC SYMBOL TEST CONDITION MIN. | TYP. |MAX.| UNIT Operating Supply Voltage Vcc Ta=25C 45 5.0 5.5| V I9L=138mA, Vcc=5.5V, Output Current Low Level VOL Pr=120nW a 04) 0.6) V High Level IoH Voc=Vo=5.5V |0.001] 250] uA Supply Current Low Level Icct, Vcc=5.5V, Pe=1200W _ 12 18 mA High Level Iccy Vcec=5.5V _ 7 15 LH Threshold Radiant Pp Vcc=5.5V, Ta=25C, = 26 60) W Incidence (Note) fAL | Ap=660nm, Vo=1.5V |~15.9]/-12.3] dBm Propagation [(L>H| tpLH _ 70| Switching |Delay Time fH-L | tpHL Ta=25C, Voc=5V, = so] | Time Rise Time tr RL =3500, Pe=051200W 20); Fall Time te 45; Note : Equivalent to the optical output at the end of a plastic fiber in the core diameter 980 am. SWITCHING TIME TEST CIRCUIT 50% Q_) VIN| oH LH y ~ 99% | OH ny BBY K F [20% vor, tf ty PRECAUTION Please be careful of the followings. 1. Soldering temperature : 260C MAX. Soldering time : 3s MAX. (Soldering portion of lead : above 2mm from the body of the device). 2. As the output photo IC contains a very high sensitivity amplifier, a bypass capacitor 0.1uF having good high frequency characteristic shall be mounted between Pins 1 and 3 at a position within lem from the pins for preventing oscillation. It not, proper speed or ON/OFF operation may not be obtained. 3. Pin surge voltage (Note) : MAX 150V (Note) Surge voltage chargeable between optional 2 pins at storage charge below 200pF. 4. Tensile strength of lead : MAX 100g 1997-09-08 2/4 TOSHIBA TPS823 OUTPUT VOLTAGE Vg (V) 0 4 Vo - IF (TYP.) Ta =25C Voc=5V LIGHT EMITTER DEVICE =TLRC281 FIBER LENGTH L=1m ( CORE DIAMETER 980 4em ) MITSUBISHI RAYON SH4001 8 12 16 FORWARD CURRENT Ip (mA) HIGH LEVEL OUTPUT CURRENT. IgH (mA) lon Ta (TYP.) LIGHT EMITTER DEVICE =TLRC281 FIBER LENGTH L=im ( CORE DIAMETER 980m MITSUBISHI RAYON $H4001 20 40 60 80 AMBIENT TEMPERATURE Ta (C) LOW LEVEL OUTPUT VOLTAGE Voz, (V) IpyL (mA) THRESHOLD CURRENT IpyL (mA) THRESHOLD CURRENT 0.6 0.5 0.4 0.3 0.2 0.1 VOL Ta (TYP.) _ LIGHT EMITTER DEVICE Voo=5V =TLRC281 Ip=30mA FIBER LENGTH L=1m CORE DIAMETER 980; _ | | | _| ( MITSUBISHI RAYON ) RL =3500 SH4001 ene ee el, _ tae! 0 10 20 30 40 50 60 70 AMBIENT TEMPERATURE Ta (C) 80 IfHL Ta (TYP.) Voc=5v Lay Lom] aA a aT ny LIGHT EMITTER DEVICE = TLRC281 FIBER LENGTH L=1m MITSUBISHI RAYON ( CORE DIAMETER 98042 ) SH4001 0 10 20 30 40 50 60 70 AMBIENT TEMPERATURE Ta (C) 80 IHL L (TYP.) Vec=5V Ta=25C a ern LIGHT EMITTER DEVICE =TLRC281 FIBER LENGTH L=im MITSUBISHI RAYON ( CORE DIAMETER 980ym SH4001 0.5 1.0 1.5 FIBER LENGTH L (m) 2.0 1997-09-08 3/4 TOSHIBA TPS823 HL PROPAGATION DELAY TIME tpLH,tpHI, s) HL PROPAGATION DELAY TIME toLH, tpHL (ns) SUPPLY CURRENT Icq (mA) tpHL, tpLH IF (TYP.) Voc=5V, Ta=25C 120 Wh mT Ry 4k ais Ry Sa 80 1kKQ PSS I See | 4kO, ~~] Ss ibo ss wa 3500, FREES LIGHT EMITTER DEVICE 1K/ 3500 =TLRC281 | 40! IBER LENGTH L=1m ( CORE DIAMETER 980m _ LH MITSUBISHI RAYON $H4001 ---- tpHL 0 0 10 20 30 40 FORWARD CURRENT Ip (mA) tpLH, tpHL Ta (TYP.) Ry=4kQ | | 120 8500, 1kOQ. ARQ, ethan geet =f S4 80 : E 4 a | | [| seen 40 12 Iw=30mA LIGHT EMITTER DEVICE Foeem. =TLRC281 Voc=5V FIBER LENGTH L=1m tpLH CORE DIAMETER 980zm MITSUBISHI RAYON ) ---- HL $H4001 0 20 40 60 80 AMBIENT TEMPERATURE Ta (C) IccL. IccH Ta (TYP.) al pam i} LIGHT EMITTER DEVICE =TLRC281 FIBER LENGTH L=1m wee. Voc=5.6V CORE DIAMETER 980m _ MITSUBISHI RAYON ) Voc=5.0V |\ cri4001 0 20 40 60 80 AMBIENT TEMPERATURE Ta (C) HsL PROPAGATION DELAY TIME tpLH , tpHL (ns) RISE AND FALL TIME t,, tg (ns) (mA) LHL THRESHOLD CURRENT tpHL, tpLH IF (TYP.) Ry, =3500, 120 Voc=5V \ put Ta=25C aN 80 > t, ~~ ra 4 oa LIGHT EMITTER DEVICE 40 =TLRC281 FIBER LENGTH L=1m CORE DIAMETER 98042 ( MITSUBISHI RAYON ) $H4001 0 0 10 20 30 40 FORWARD CURRENT Ip (mA) tr, tf Ta (TYP.) RL =4kQ. T 1kQ, 100 : 350kQ. 1000 J 350kQ. J1kQ. _| =] _ = - -o|= = =| = == Da = SS AKO, - LIGHT EMITTER DEVICE Ip=30mA =TLRC281 te | FIBER LENGTH L=1m ( CORE DIAMETER 980,an MITSUBISHI RAYON SH4001 0 20 40 60 80 AMBIENT TEMPERATURE Ta (C) IfHL tr (TYP.) LIGHT EMITTER DEVICE 2 =TLRC281 FIBER LENGTH L=im Ta =25C CORE DIAMETER 980m Voo=5V ( MITSUBISHI RAYON ) $H4001 0 20 40 60 80 100 LOOP RADIUS r (mm) 1997-09-08 4/4