Advanced Power Solutions 10/17/01 AC TO DC EXTERNAL DESKTOP ADAPTOR SINGLE OUTPUT 15 TO 25 WATTS SWITCHING POWER SUPPLIES AD-725 SERIES FEATURES: ! ! ! ! ! ! UNIVERSAL AC INPUT LOW COST AND LIGHT WEIGHT IEC320-3PIN DT7 or DT7L AC RECEPTACLE APPROVED TO WORLDWIDE STANDARDS EMI MEETS EN55022 / FCC CLASS B CE MARKING COMPLIANCE SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Voltage: 90-264Vac typical Output Voltage: See Ratings Chart Input Connector: IEC320-3P DT7 or IEC320-3 DT7L Output Current: See Ratings Chart AC inlet receptacle Output Wattage: Typ. 25W Input Frequency: 47 to 63Hz, (consult factory for 440Hz) Line Regulation: 0.2% max.. full range Inrush Current: 35A max. Load Regulation: 3.0% max. Input Current: 0.3A max. Noise & Ripple: Typ. 1.0% peak to peak Dielectric Withstand: Meets IEC950 OVP: Automatic recovery EMI/RFI: Meets FCC Part 15, Class B Adjustability: Factory set Hold-up Time: 16mS minimum @ 115 Vac Overload Protection: Automatic recovery Line Surge: IEC801-5 Level 4 Output Connector & Cord: Several options available GENERAL SPECIFICATION Efficiency: Typ. 75% Operating Temperature: 0 to +40C Switching Frequency: 100kHz nominal at full load Storage Temperature: -20C to +85C Circuit Topology: Self oscillating flyback circuit Temperature Coefficient: 0.04% per C Transient Response: Output voltage returns in Cooling: Free air convection less than 3mS following a 50% load change Safety Standard: UL1950/CSA60950 IEC950 Construction: Splash proof, UL94 V-0 Impact resistant thermo-plastic case Notes: (1) All measurements are at nominal input, full load, and +25C unless otherwise specified. (2) Load regulation is measured at 115Vac or 230Vac in percentage to indicate the change in output voltage as the load is varied from half load to full load (%). (3) The exact obtainable load regulation depends upon the output cord selected & load current. Upper data are for 6 ft. (2 m) cord AWG#18 wires. For the details of safety approval, please consult the factory. OUTPUT VOLTAGE/CURRENT RATINGS CHART Single Output: OUTPUT OUTPUT MODEL VOLTAGE CURRENT MAX. OUTPUT POWER MAX. AD-725U-1033 AD-725U-1050 AD-725U-1060 AD-725U-1075 AD-725U-1090 AD-725U-1120A AD-725U-1150 AD-725U-1160 AD-725U-1180 AD-725U-1200 AD-725U-1225 AD-725U-1240 3.3V 5.0V 6.0V 7.5V 9.0 12.0V 15.0V 16.0V 18.0V 20.0V 22.5V 24.0V 4.5A 4.0A 3.5A 3.0A 2.6A 2.1A 1.7A 1.6A 1.4A 1.3A 1.1A 1.0A 15W 20W 21W 22W 23W 25W 25W 25W 25W 25W 25W 25W MODEL MAIN OUTPUT VOLT / AMP * AUX. OUTPUT VOLT / AMP OUTPUT POWER MAX. AD-725U-2205 5.0V / 1.5A +12.0V / 0.75A 16.5W Dual Output: Symbols: `*' OVP built in; `' Stacked on main output Remark: At least 20% of typical main output current is required to maintain stated regulation for the auxiliary output units. MECHANICAL DIMENSIONS: MM [INCHES] WEIGHT: 185g (6.53 Oz)