PART NO. ECN # REV
-A
REVISIONS
DESCRIPTION DRAWN DATE DATE DATECHECKD APPRVD
Poori 10/9/07 10/9/07 25/9/07Suresh G. C
RELEASED
13-29-7
This data sheet and its contents (the "Information") belong to the Premier Farnell Group
(the "Group") or are licensed to it. No licence is granted for the use of it other than for
information purposes in connection with the products to which it relates. No licence
of any intellectual property rights is granted. The Information is subject to change with-
out notice and replaces all data sheets previously supplied. The Information supplied is
believed to be accurate but the Group assumes no responsibility for its accuracy or
completeness, any error in or omission from it or for any use made of it. Users of this
data sheet should check for themselves the Information and the suitability of the prod-
ucts for their purpose and not make any assumptions based on information included or
omitted. Liability for loss or damage resulting from any reliance on the Information or
use of it (including liability resulting from negligence or where the Group was aware of
the possibility of such loss or damage arising) is excluded. This will not operate to limit
or restrict the Group's liability for death or personal injury resulting from its negligence.
SPC MULTICOMP is the registered trademark of the Group. © Premier Farnell plc 2007.
TOLERANCES: DRAWN BY:
Poornima
Suresh
G.Cook
CHECKED BY:
APPROVED BY:
DATE: DRAWING TITLE: 13-29-7
1169703_DWG
M10000554
10/09/07
DATE: SIZE
SCALE: NTS U.O.M.: mm (Inches) SHEET: 1 OF 1
DWG NO. ELECTRONIC FILE REV
A
10/09/07 A
DATE:
25/09/07
UNLESS OTHERWISE
SPECIFIED,
DIMENSIONS ARE
FOR REFERENCE
PURPOSES ONLY.
Dimensions : Millimetres (Inches)
Specifications:
Bodies : Brass per JIS-C3604.
Centre Contact : Brass per JIS-C3604.
Connector interface per MIL-STD-348A.
Part to be clean and free of burrs.
Mounting Hole
Specification Table
Number Description Material Finish Part Number
1 Nut Brass Nickel 100 µ” Minimum
13-29-7
2 Washer Iron
3 Insulation POM None
4 Body Brass Nickel 100 µ” Minimum
5 Insulation ABS None
6Centre Contact Brass Gold
7 Washer Nickel 100 µ” Minimum
Scale 2:1
http://www.farnell.com
http://www.newark.com
http://www.cpc.co.uk
