BAFFEAT TECHNICAL DATA Page 1/2 RIGHT ANGLE 2 HOLES FLANGE FLOATING JACK) R128. 359 , 827 SOLDER TYPE - GABLE 141 SERIES BMA COM 0.978 748 PERCAGE PANNEAL 5] (is.251 = MOUNTING HOLE A DIA wm Bia Sig ie ols 7 - - - -4 ot Lf | oy 2 holes i ol 2~56-UNC-23 To MM INCH | maxi | mini | maxi] mini 2 DIA > | silk OA 0.144 | 0-065 | | A{9.5 18.55 0.3740. 37 865 oy C [14.3 144.4 {0.5689 0.55 NOMINAL IMPEDANCE 50 0 : CABLES : KS 2 i RG 402 FREQUENCY RANGE O0-12,4 GHz TEMPERATURE RATING -65/+125 c : V.S.W.R 4.45 + 025 x FiGHz)Maxi: RF INSERTION LOSS 0.07 JFichz) 0B Maxi! VOLTAGE RATING 360 veff Maxi! DIELECTRIC WITHSTANDING VOLTAGE 4000 vVeff Minii INSULATION RESISTANCE 5000 Monin } OTHERS CHARACTERISTICS 3,2: HERMETIC SEAL NA Atm.om'/S! oypte RETENTION 272 N Mini LEAKAGE (pressurized only} NA CENTER CONTACT RETENTION MECHANICAL DURABILITY 500 cycles Axial force ~ mating end 48 N Mini Axial force - opposite end 48 NN Mini WEIGHT 8.3 or i Torque NA om.N Mint SPECIFICATION : RECOMMENDED TORQUES i Mating NA cm.N Panel nut NA cn.N Clamp nut NA om.N CONNECTOR PARTS; MATERIALS ; FINISH (37 afenges are given ) BODY i BRASS :BBR 2 OUTER CONTACT iBRASS BBR. 2, CENTER CONTACT : BRONZE | SOLD 1.3 OVER COPPER 2 INSULATOR IPTFE ; GASKET i OTHERS PIECES BRASS BBR 2 . {| nua] 3) ISSUE CREATION DATE |FILE PART-NUMBER BU RADIALL O746A 1 03/10/4996 EPCo6-06 = PT The information given here is subject to change without notice. Design changes may be in order to improve the product . Connect to the future BAFFERT TECHNICAL DATA Page 2 / 2 al Aes Pq] RADIALL | R128.359.827 below surface of body assembly. Issue 0746 A |SERIES BMA COM _ | | -L @ - ++ ue 1-1 Strip the cable . ral Stripping | a b c d @ inch 0. 169/6.055/0 0 0 mom 4.3 [1.4 @) Assembly jig Tighten the cable 2-1 Introduce the cable into the connector body until it stops. * Place the sub assembly Solder inte the assembly jig A 282 740 (or equivalent) 3 2-2 Solder the body onto the cable. a 7 2-3 Let the assembly cool down before removing it from the jig . SOLGEA PRESS ON 3-1 Solder inner conductor. 3-2 Put the cap in its place. uP 2 f Poorer -, 3-3 Press cap flush or slightly sey 1 WY My The information givan here is subject to ohange vithout notice.Design changes may bs in order to improve the produot.