Index-8 SYM53C876/876E Data Manual
Index
Assert SCSI C_D/ Signal, 4-30, A-4
Assert SCSI Data Bus, 4-22, A-3
Asse rt SCSI I_O/ S ig na l, 4-30, A-4
Assert SCSI MSG/ Signal, 4-30, A-4
Assert SCSI REQ/ Signal), 4-30, A-4
Assert SCSI RST/ Signal, 4-22, A-3
Assert SCS I SEL / Signal, 4-30, A-4
Burst Disable, 4-42, A-6
Burst Length, 4-44, 4-48, A-6, A-7
Burst Op Code Fetch Enable, 4-48, A-7
Bus Fault, 4-31, 4-49, A-5, A-7
Byte Empty in DMA FIFO, 4-39, A-6
Byte Full in DMA FIFO, 4-39, A-6
Byte Offset Counter, 4-42, 4-44, A-6
Cache Line Siz e Enable, 4-51, A-7
Chained Mode, 4-24, A-3
Chip Revision Level, 4-40, A-6
Chip Type, 4-59, A-8
Clear DMA FIFO, 4-40, A-6
Clear SC SI FIFO, 4-66, A-10
Clock Address Incrementor, 4-43, A-6
Clock Byte Counter, 4-43, A-6
Clock Conversion Factor, 4-26, A-3
Configured as I/O, 4-39, A-6
Configured as Memory, 4-39, A-6
Connected, 4-22, 4-37, A-3, A-5
Data Acknowledge Status, 4-40, A-6
Data Request Status, 4-40, A-6
Data Transfer Direction, 4-39, A-6
Destination I/O-Memory Enable, 4-48, A-7
Disable Halt on Parity Error or ATN, 4-22,
A-3
Disable Single Initiator Response, 4-66, A-10
DMA Direction, 4-44, A-6
DMA FIFO, 4-44, A-6
DMA FIFO Empty, 4-31, A-5
DMA Interrupt Pe nding, 4-38, A-5
Enable Pa rity Checking, 4-21, A-3
Enable Read Line , 4-48, A-7
Enable Read Multiple, 4-48, A-7
Enable Response to Reselection, 4-26, A-4
Enable Response to Selection, 4-26, A-4
Enable Wi de SCSI, 4-26, A-3
Encoded Chip SCSI ID, bits 3-0, 4-26, A-4
Encoded Destination SCS I ID, 4-28, 4-30, A-
4
Extend SREQ/SACK Filtering, 4-65, A-9
Extra clock cycle of data setup, 4-22, A-3
Fetch Enable, 4-60, A-8
Fetch Pin Mode, 4-41, A-6
FIFO Byte Control, 4-43, A-6
FIFO Flags, 4-34, 4-35, A-5
Flush DMA FIFO, 4-40, A-6
Function Complete, 4-53, 4-55, A-8
General Purpose Timer Expired, 4-55, 4-57,
A-8
General Purpos e Timer Period, 4-61, A-9
General Purpose Timer Scale Factor, 4-61,
A-9
GPIO Enable, 4-60, A-8
GPIO4-0, 4-29, A-4
Halt SCSI Clock, 4-66, A-10
Handshake-t o-Handshake T imer Bus Activity
Enable, 4-61, A-9
Handshake-t o-Handshake Timer Expired,
4-55, 4-57, A-8
Handshake-t o-Handshake Timer Period,
4-60, A-9
High Impedance Mode, 4-42, A-6
Ill egal In s tru c tion Detected , 4-32, A-5
Illegal instruction detected, 4-50, A-7
Immediate Arbitration, 4-23, A-3
Interrupt on the Fly, 4-37, A-5
IRQ Disable, 4-51, A-7
Last Disconnect, 4-35, A-5
L a tc h ed SCSI Pari t y, 4-34, A-5
Latched SCSI Pa rity for SD15-8, 4-35, A-5
Lost Arbitration, 4-33, A-5
Manual Start Mode, 4-49, A-7
Master Control for Set or Reset Pulses, 4-43,
A-6
Master Data Parity Error, 4-31, 4-49, A-5,
A-7
Master Enable, 4-60, A-8
Mast e r Pa rity Error Enable , 4-43, A-6
Max SCSI Synchronous Offset, 4-28, A-4