Operating Voltage Control Voltage
AVAILABLE OPTIONS
1/4” Quick Connect 280 VAC
1/4” Quick Connect 660 VAC
Locking Connector 280 VAC
Rated Load Current
Series
84140 0 1 U0
0: 25 Amp/Zero Voltage Turn-On
1: 25 Amp/Instantaneous Turn-On
2: 40 Amp/Zero Voltage Turn-On
3: 40 Amp/Instantaneous Turn-On
0: 24-280 VAC/Zero Voltage Turn-On
1: 24-280 VAC/Instantaneous Turn-On
0: 48-660 VAC/Zero Voltage Turn-On
1: 48-660 VAC/Instantaneous Turn-On
0: 4-15 VDC
1: 17-32 VDC
0: 4-15 VDC
1: 17-32 VDC
0: 4-15 VDC
1: 17-32 VDC
8: 25 Amp
9: 40 Amp
5: 25 Amp
6: 40 Amp
0: 24-280 VAC
Dual GN Series
• Current rating 25 and 40 Amps
• Output voltage 24-280 VAC and 48-660 VAC
• Direct bond copper substrate
• Back to back dual SCR output
• 4000 VAC optical isolation
• Zero Voltage and Instantaneous Turn-On
• UL/cUL Recognized, CE Compliant
OUTPUT SPECIFICATIONS (1)
Description 280 VAC
Operating Voltage [Vrms] 24-280
OUTPUT SPECIFICATIONS (1)
Description
Transient Voltage(t=1 min.) [Vpk] 550
Maximum Off-State Leakage Current @ Rated Voltage (@ max. line voltage) [mArms] 0.1
660 VAC
48-660
1000
0.25
Maximum Load Current [Arms]
Minimum Load Current [mArms]
1 Second surge current (50/60 Hz @ Ta=25°C) [Apk]
Maximum 1 Cycle Surge Current (50/60Hz) [Apk]
Maximum On-State Voltage Drop @ Rated Current [Vpk]
Thermal Resistance Junction to Case (Rjc) [°C/W]
Maximum 1/2 Cycle I² t for Fusing (50/60Hz) [A² sec]
Maximum Off-State dv/dt @ Maximum Rated Voltage [V/μsec]
25 A
25
100
85
275/300
1.4
0.6
380/370
500
40 A
40
100
150
710/750
1.3
0.4
2520/2320
500
Datasheet
Panel Mount
Do not forget to visit us at: www.crydom.com
Copyright © 2016 Crydom Inc. Specifications subject to change without notice.
PRODUCT SELECTION
1/4” Quick Connect 280 VAC Locking Connector 280 VAC1/4” Quick Connect 660 VAC
Control Voltage 25 A 40 A 40 A
4-15 VDC 84140500 8414060084140200
17-32 VDC 84140510 8414061084134210
25 A
84140800
84140810
40 A
84140900
84140910
25 A
84140000
84140410
Datasheet
Panel Mount
Do not forget to visit us at: www.crydom.com
Copyright © 2016 Crydom Inc. Specifications subject to change without notice.
INPUT SPECIFICATIONS (1)
Description 84140x0x
Control Voltage Range [Vdc] 4-15
Minimum Turn-On Voltage [Vdc] 4
Must Turn-Off Voltage [Vdc] 1
Minimum Input Current (for on-state) [mA] 7.5
Maximum Input Current [mA] 34
Nominal Input Impedance [Ohms] 500
1/2 Cycle
1/2 Cycle
Maximum Turn-On Time [msec] (2)
Maximum Turn-Off Time [msec]
84140x1x
17-32
17
1
13
24
1500
GENERAL SPECIFICATIONS (1)
ParametersDescription
-40 to 80 °C
-40 to 100 °C
Input to Output Isolation
Input to Output Capacitance
Operation Frequency
Input/Output to Ground Isolation
4000 Vrms
Ambient Operating Temperature Range
2500 Vrms
Ambient Storage Temperature Range
8pF
47 to 63 Hz
Housing Material UL94 V-0 (self extinguishing)
Weight (typical) 3.2 oz (91.5g)
GENERAL NOTES
For additional information or specific questions, contact Crydom Technical Support.
(1) All parameters at 25°C unless otherwise specified.
(2) Turn-on time for Instantaneous turn-on versions is 0.02 msec.
Input A
+
Input B
1A ( )
2A ( ) 2B ( )
Load
V
AC
Load
V
AC
1B ( )
+-
-
WIRING DIAGRAM
SOLID STATE RELA Y
MECHANICAL SPECIFICATIONS (1)
Tolerances: ±0.02 in / 0.5 mm
All dimensions are in: inches [millimeters]
Input A
+
Input B+-
-
SOLID STATE RELA Y
0.60
[15.2]
0.56
[14.3]
0.18
[4.7]
2.30
[58.4]
0.74
[18.8]
0.45
[11.5]
1.87
[47.5]
1.31
[33.2]
0.86
[21.8]
1.21
[30.6]
Mating Connector for 841408xxx and 841409xxx
Molex # 50-57-9404 without pins
Crimp Pins Molex # 16-02-0103
Datasheet
Panel Mount
Do not forget to visit us at: www.crydom.com
Copyright © 2016 Crydom Inc. Specifications subject to change without notice.
1.00
[25.4]
1.17
[29.7]
1.78
[45.3]
Pin .025 SQ
.100 CENTERS
(4 places)
Mounting
Hole/Slot
0.19 [4.9]
DIA.
EQUIVALENT CIRCUIT BLOCK DIAGRAMS
+DC
-DC
AC
Trigger
Circuit
Current
Limiter
AC
+
-
1A
2A
INPUT
OUTPUT
+DC
-DC
AC
Trigger
Circuit
Current
Limiter
AC
+
-
1B
2B
INPUT
OUTPUT
THERMAL DERATE INFORMATION
AGENCY APPROVALS
EN60950-1: Meets the requirements of sections1.5: 1,7: 2.9: 2.10.5.3: 4.2: 4.5: 4.7:
Certified according to EN 62314:2006
IEC 61000-4-2 Electrostatic Discharge Level 3
IEC 61000-4-4 Electrically Fast Transients Level 3
IEC 61000-4-5 Electrical Surges Level 3
LR 38595
E79183
Rev. 092616
Datasheet
Panel Mount
Do not forget to visit us at: www.crydom.com
Copyright © 2016 Crydom Inc. Specifications subject to change without notice.
25 A
0
10
20
30
40
50
20 30 40 50 60 70 80
0.7°C/W 1°C/W 1.5°C/W 2°C/W
Combined Channel
Output Current (Amp)
Ambient Temperature (ºC)
40 A
0
10
20
30
70
80
40
50
60
20 30 40 50 60 70 80
0.5°C/W 1°C/W 1.5°C/W 2°C/W
Combined Channel
Output Current (Amp)
Ambient Temperature (ºC)
DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / 危险
HAZARD OF
ELECTRIC
SHOCK,
EXPLOSION,
OR ARC FLASH.
•Disconnect all
power before
installing or
working with
this equipment.
•Verify all
connections
and replace all
covers before
turning on
power.
Failure to follow
these
instructions will
result in death
or serious injury.
RIESGO DE
DESCARGA
ELECTRICA O
EXPLOSION.
•Desconectar
todos los
suministros de
energia a este
equipo antes
de trabajar
con este equipo.
•Verificar todas
las conexiones
y colocar todas
las tapas antes
de energizer
el equipo.
El
incumplimiento
de estas
instrucciones
puede provocar
la muerte o
lesiones serias.
RISQUE DE
DESCHARGE
ELECTRIQUE
OU EXPLOSION
•Eteindre
toutes les
sources
d'énergie de
cet appareil
avant de
travailler
dessus de cet
appareil
•Vérifier tous
connections, et
remettre tous
couverts en
olace avant de
mettre sous
De non-suivi de
ces instructions
provoquera la
mort ou des
lésions sérieuses
sérieuses.
GEFAHR EINES
ELEKTRISCHE
N SCHLAGES
ODER EINER
EXPLOSION.
•Stellen Sie
jeglichen
Strom ab, der
dieses Gerät
versorgt, bevor
Sie an dem
Gerät Arbeiten
durchführen
•Vor dem
Drehen auf
Energie alle
Anschlüsse
überprüfen
und alle
Abdeckungen
ersetzen.
Unterlassung
dieser
Anweisungen
können zum
Tode oder zu
schweren
Verletzungen
führen.
RISCHIO DI
SCOSSA
ELETTRICA O
DELL’ESPLOSI
ONE.
•Spenga tutta
l'alimentazion
e che fornisce
questa
apparecchiatu
ra prima del
lavorare a questa
apparecchiatu ra
•Verificare tutti
i collegamenti
e sostituire
tutte le coperture
prima della
rotazione
sull'alimentazi one
L'omissione di
seguire queste
istruz ioni
provocherà la
morte o di
lesioni serie
存在电击、
爆炸或电弧
闪烁危险
•
在操作此设
备之前请先
关闭电源。
若不遵守这些说明，
可能会导致严重的
人身伤害甚至死亡。
WARNING / AVERTISSEMENT / WARNUNG /ADVERTENCIA / AVVERTENZA / 警告
RISK OF MATERIAL DAMAGE AND HOT
ENCLOSURE
• The product's side panels may be hot, allow
the product to cool before touching.
• Follow proper mounting instructions including
torque values.
• Do not allow liquids or foreign objects to enter
this product.
Failure to follow these instructions can result in
serious injury, or equipment damage.
RISQUE DE DOMMAGE MATERIEL ET DE
SURCHAUFFE DU BOITIER
• Les panneaux latéraux du produit peuvent être
chauds. Laisser le produit refroidir avant de le
toucher.
• Respecter les consignes de montage, et
notamment les couples de serrage.
• Ne pas laisser pénétrer de liquide ni de corps
étrangers à l'intérieur du produit.
Le non-respect de cette directive peut entraîner,
des lésions corporelles graves ou des
dommages matériels.
Die Nichtbeachtung dieser Anweisung kann
Körperverletzung oder Materialschäden
zur Folge haben.
GEFAHR VON MATERIALSCHÄDEN UND
GEHÄUSEERHITZUNG
• Die Seitenwände können heiß sein. Lassen Sie
das Produkt abkühlen, bevor Sie es berühren.
• Beachten Sie die Montageanweisungen,
• Führen Sie keine Flüssigkeiten oder
Fremdkörper in das Produkt ein.
Si no se respetan estas precauciones pueden
producirse graves lesiones, daños materiales.
RIESGO DE DAÑOS MATERIALES Y DE
SOBRECALENTAMIENTO DE LA UNIDAD
• Los paneles laterales del producto pueden
estar calientes. Esperar que el producto se
enfríe antes de tocarlo.
• Respetar las instrucciones de montaje, y en
particular los pares de apretado.
• No dejar que penetren líquidos o cuerpos
extraños en el producto.
La mancata osservanza di questa precauzione può
causare gravi rischi per l'incolumità personale o
danni alle apparecchiature.
RISCHIO DI DANNI MATERIALI E D'INVOLUCRO
CALDO
• I pannelli laterali dell'apparecchio possono
scottare; lasciar quindi raffreddare il prodotto
prima di toccarlo.
• Seguire le istruzioni di montaggio corrette.
• Non far entrare liquidi o oggetti estranei in questo
apparecchio.
如不能正确执行这些操作说明，
极有可能造成严重人体伤害或者设备的损坏。
材料损坏和高温外壳的危险性
• 产品的一侧面板可能很热，在其冷却前请
不要触碰。
• 遵照正确的安装说明，包括扭矩值。
• 请勿让液体及其他异物进入本产品。
Datasheet
Panel Mount
Do not forget to visit us at: www.crydom.com
Copyright © 2016 Crydom Inc. Specifications subject to change without notice.
ANNEX - ENVIROMENTAL INFORMATION
The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People’s Republic of China
Electronic Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution Caused by Electronic Information Products.
Part
Name
Toxic or hazardous Substance and Elements
Lead Mercury Cadmium Hexavalent Polybrominated Polybrominated
(Pb) (Hg) (Cd) Chromium
(Cr (VI))
biphenyls
(PBB)
diphenyl ethers
(PBDE)
Semiconductor die
Solder
附件 - 环保信息
此附件所标示的包括电子信息产品污染图标的环保信息符合中华人民共和国电子行业标准 SJ/T11364 - 2006,
电子信息产品污染控制标识要求。
有毒有害物质或元素件部
名称 铅 汞 镉 六价铬 多溴联苯 多溴二苯醚
(Pb) (Hg) (Cd) (Cr (VI)) (PBB) (PBDE)
半导体芯片
焊接点
50
Datasheet
Panel Mount
Do not forget to visit us at: www.crydom.com
Copyright © 2016 Crydom Inc. Specifications subject to change without notice.
