PRODUCT DATASHEET 1-800-383-7323 1-800-383-7323 / USA USA/CAN 1-800-383-7323 / CANADA www.energizer.com ENERGIZER 386/301 SILVER OXIDE Specifications Chemical System: Designation: Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): Industry Standard Dimensions mm (inches) Silver Oxide (Zn/Ag2O) ANSI/NEDA-1133SO/1132SO, IEC-SR43 1.55 Volts 127 mAh* (to 1.2 volts) 6.5K ohm continuous drain at 21C 1.7 grams (0.06 oz.) 0.44 cubic centimeters (0.27 cubic inch) 5 to 15 ohms * Varies according to the applied load, temperature, and cutoff voltage. Cross Section 6.70 (0.265) Ref. Typical 4.20 (0.165) 11.60 (0.457) 11.25 (0.443) E 3.80 (0.150) R1.5 (0.059) Ref. Typical 3.63 (0.143) Ref. 0.20 (0.008) Maximum Ref. Permissible deflection from a flat Gasket Can Separator SO L 0.13 (0.005) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Anode Cap Gel Anode ET 3.38 (0.133) Ref. Cathode DESIGNED FOR USE ON CONTINUOUS LOW DRAIN HIGH PULSE ON DEMAND Temperature Characteristics Typical Performance at 21C (70F) Typical Performance at Low Discharge Rates 1.7 1.6 1.5 1.4 1.3 1.2 1.1 1.0 Service Effects 125 100 75 50 25 0 -20 0 150 Schedule Continuous 300 Service, Hours 450 600 Typical Drains at 1.52V (milliamperes) (ohm) Cutoff 1.2V (hours) 0.234 6.5K 542 Load 0 20 Temperature (C) 40 Storage Effects 100 Service (%) Voltage, CCV Schedule: Continuous Typical Drain @1.52V: 0.234 milliamperes Load: 6.5K ohm Service (%) OB Typical Discharge Characteristics 0 C 90 20 C 80 70 40 C 60 0 2 4 6 8 Storage Time (yrs) 10 12 Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. (c)Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 4350B Page 1 of 1